instrument panel Citroen DS5 2014 1.G User Guide

35Monitoring










Deactivation indicator lamps

If one of the following indicator lamps comes on, this confirms that the corresponding system has been switched off intentionally.
This is may be accompanied by an audible signal and a message in the instrument panel screen.



Warning / indicator lamp



State



Cause



Action / Observations









Passenger's
airbag system


fixed in the instrument
panel and/or seat belt
and front passenger's
airbag warning lamps
display. The control switch, located in the
glove box, is set to the OFF
position.
The passenger's front airbag is
deactivated. Set the control to the "ON"
position to activate the
passenger's front airbag.
In this case, do not fit a child seat in the rear-facing
position.

Warning lamps

When the engine is running or the vehicle is being driven, illumination of one of the following warning lamps indicates a fault which requires action on
the part of the driver.
Any fault resulting in the illumination of a warning lamp must be investigated further by reading the associated message in the instrument panel screen.
If you encounter any problems, contact a CITROËN dealer or a qualified workshop.



Warning / indicator lamp



State



Cause



Action / Observations






STOP


fixed, associated
with another warning
lamp, accompanied
by an audible signal
and a message in the
screen. Illumination of this warning lamp is
related to a serious fault with the
braking system, power steering, the
engine oil pressure or engine coolant
temperature or a major electrical
fault. Stop as soon as it is safe to do so as the engine may
cut out.
Park, switch off the ignition and call a CITROËN
dealer or a qualified workshop.

Coolant
temperature gauge
With the engine running:


- in zone A
, the temperature is correct,

- in zone B
, the temperature is too high; the
central STOP
warning lamp comes on,
accompanied by an audible signal and a
message in the instrument panel screen.

You MUST stop as soon as it is safe to do so.

Wait a few minutes before switching off the
engine.
Contact a CITROËN dealer or a qualified
workshop.
After driving for a few minutes, the temperature
and pressure in the cooling system increase.
To top up the level:



wait for the engine to cool,


unscrew the cap by two turns to allow the
pressure to drop,


when the pressure has dropped, remove
the cap,


top up the level to the "MA X" mark.


Be aware of the risk of burns when
topping up the cooling system. Do not
fill above the maximum level (indicated
on the reser voir).

43Monitoring






Service indicator


More than 1 800 miles (3 000 km)
remain before the next service is due
When the ignition is switched on, no ser vice
information appears in the screen. System which informs the driver when the
next ser vice is due, in accordance with the
manufacturer's ser vicing schedule.
The point at which the ser vice is due is
calculated from the last indicator zero reset. It
is determined by two parameters:


- the distance travelled,

- the time elapsed since the last ser vice.


Between 600 miles (1 000 km)
and 1 800 miles (3 000 km) remain
before the next service is due
For 5 seconds after the ignition is switched on, the
spanner symbolising the ser vice operations comes
on. The distance recorder display line indicates the
distance remaining before the next ser vice is due.

Example:
1 700 miles (2 800 km) remain
before the next ser vice is due.
For 5 seconds after the ignition is switched on,
the screen indicates:
5 seconds after the ignition is switched on,
the spanner goes off
; the distance recorder
resumes its normal operation. The screen then
indicates the total and trip distances.


Less than 600 miles (1 000 km)
remain before the next service is due

Example:
560 miles (900 km) remain before
the next ser vice is due.
For 5 seconds after the ignition is switched on,
the screen indicates:
5 seconds after the ignition is switched on,
the distance recorder resumes its normal
operation. The spanner remains on
to
indicate that a ser vice must be carried out
soon.

Illumination of the key is accompanied
by a message in the instrument panel
screen.

45Monitoring















Engine oil level indicator *


Oil level incorrect

This is indicated by the display of the message
"Oil level incorrect" in the instrument panel
screen, accompanied by the ser vice warning
lamp and an audible signal.
If the low oil level is confirmed by a check using
the dipstick, the level must be topped up to
avoid damage to the engine.
Refer to the "Checking levels" section.


Oil level indicator fault

This is signalled by the display of the message "Oil
level measurement invalid" in the instrument panel.
Contact a CITROËN dealer or a qualified
workshop.

In the event of a fault with the electric indicator,
the oil level is no longer monitored.
If the system is faulty, you must check the
engine oil level using the manual dipstick
located under the bonnet.
Refer to the "Checking levels" section.
On versions fitted with an electric oil level
indicator, the state of the engine oil level is
displayed in the instrument panel for a few
seconds, after the ser vicing information.
The level read will only be correct if
the vehicle is on level ground and the
engine has been off for more than
30 minutes.

Oil level correct


*
Depending on version.

47Monitoring
System allowing certain screens to be switched
off for night driving (available only with
eMyWay).
The instrument panel remains on with the
vehicle speed, electronic gearbox gear
selected, cruise control or speed limiter
information, if in use, and the low fuel alerts if
necessary.
If there is an alert or a change in a function
or to a setting, the black panel mode is
interrupted.









Black panel (black screen)
with eMyWay

For more information, refer to the
eMyWay part of the "Audio and
telematics" section.

Tr i p c o m p u t e r


System that gives you information on the journey in progress (range, fuel consumption…).




When the trip required is displayed, press
the control for more than two seconds
or use the left hand thumb wheel of the
steering mounted controls.
Trips "1"
and "2"
are independent but their use
is identical.
For example, trip "1"
can be used for daily
figures, and trip "2"
for monthly figures.











Instrument panel screen

Information display





Press the button on the end of the wiper
control stalk
to display the various tabs in
succession.



- The current information tab with:


●
the range,

●
the current fuel consumption,

●
the Stop & Start time counter.





- Tr i p "1"
with:


●
the average speed,
for the first trip.

●
the average fuel consumption.





- Tr i p "2"
with:


●
the average speed,
for the second trip.

●
the average fuel consumption.




Tr i p r e s e t




- Radio or media.

- Satellite navigation.

Do not throw the remote control
batteries away, they contain metals
which are harmful to the environment.
Take them to an approved collection
point.















Changing the battery of
the electronic key

Battery ref.: CR2032 / 3 volts.
This replacement battery is available from a
CITROËN dealer or a qualified workshop.
A message appears in the instrument panel
screen when replacement of the battery is
needed.



Unclip the cover using a small screwdriver
at the cutout.


Lift off the cover.


Remove the flat battery from its location.


Fit the new battery into its location
obser ving the original direction of fitment.


Clip the cover onto the casing.

















Remote control problem -
reinitialisation
Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.



Place the mechanical key (integral with the
remote control) in the lock to unlock your
vehicle.


Place the electronic key in the reader.


Switch on the ignition by pressing
START/STOP.
The electronic key is fully operational again.
If the problem persists, contact a CITROËN
dealer or a qualified workshop as soon as
possible.

Central locking control


Automatic central locking of the
doors
(anti-intrusion security)
The doors and boot can lock automatically
while driving (speed above 6 mph (10 km/h)).
To activate or deactivate this function (activated
by default:
If the vehicle is deadlocked or locked
from the outside, the button is not
active. In this case, use the remote
control to unlock the vehicle or pull an
interior door handle to open a door.
If one of the doors is open, central
locking from the inside does not take
place.
Driving with the doors locked may make
access to the passenger compartment
by the emergency ser vices more
difficult in an emergency.


Operate the button.
This allows the doors and the boot to be locked
or unlocked.


Operate this button until a
message appears in the
instrument panel screen.



Transporting long or voluminous
objects

If you want to drive with the boot open,
press the central locking control button
to lock the doors.








Emergency control

System allowing the doors to be locked and
unlocked manually in the event of a malfunction
of the central locking system or battery failure.

Locking the driver's door




Insert the key in the door lock, then turn it
to the rear.
You can also apply the procedure described for
the passenger doors.


Unlocking the driver's door




Insert the key in the door lock, then turn it
to the front.

Boot




After unlocking the boot or the vehicle
using the electronic key - remote control,
press the opening control then raise the
tailgate.



Opening from outside




Press this button until the boot is heard to
unlock.








Ta i l g a t e r e l e a s e


Unlocking




Fold back the rear seats to gain access to
the lock from inside the boot.


Insert a small screwdriver into hole A
of the
lock to unlock the tailgate.


Move the latch to the left.
System allowing the mechanical unlocking
of the boot in the event of a battery or central
locking system malfunction.

Locking after closing

If the fault persists after closing again, the boot
will remain locked.



Closing




Lower the tailgate using the interior grab
handle.


If the tailgate is not closed correctly, engine
running
or vehicle moving
(speed above
6 mph (10 km/h)), a message appears in the
instrument panel screen for a few seconds.


Opening from inside