inflation pressure Citroen DS5 2016 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2016, Model line: DS5, Model: Citroen DS5 2016 1.GPages: 500, PDF Size: 55.11 MB
Page 10 of 500
DS5_en_Chap00b_vue-ensemble_ed02-2015
ExteriorElectronic key / Keyless Entry and Starting 52 - 60, 100 -102
-
op
ening / closing
-
an
ti-theft protection
-
bat
tery
-
st
arting
Welcome lighting
14
9
Directional lighting
15
1
Cornering lighting
15
2
Headlamp beam height adjustment
15
0
Changing bulbs
21
1-215
-
fr
ont lamps
-
fog
lamps
-
di
rection indicator repeaters Wipers
153
-15 6
Changing a wiper blade
15
6, 228
Doors
52
- 61
-
Ke
yless Entry and Starting
-
op
ening / closing
-
ce
ntral locking
-
emer
gency control
Alarm
63
-65 Cockpit glass roof
68
- 69
Roof bars
23
2
Accessories
234
-235
ESC (ABS, EBA, ASR, DSC)
18
2-185
Tyre under-inflation detection
11
6 -117
Tyre pressures
11
6, 201, 274
Snow chains
21
0
Changing a wheel
20
2-209
-
to
ols
-
re
moving / refitting
Temporary puncture repair kit
19
6 -201 Boot
53
, 62
-
op
ening / closing
-
emer
gency release
AdBlue additive, topping-up
25
3 -257, 258 -261
Changing bulbs
21
6-218
-
re
ar lamps
-
3r
d brake lamp
-
nu
mber plate lamps
-
fog
lamps
Door mirrors
80
D
oor mirror spotlamps
14
9
Fuel tank
23
9 -241
Misfuel prevention (Diesel)
24
2 Parking sensors
13
6 -137
Reversing camera
13
8
To w i n g
2 2
9 - 2 3 0
Towbar
99
, 231
Page 30 of 500
Under-inflationfixed. The pressure in one or more wheels
is too low. Check the pressure of the tyres as soon as possible.
This check should preferably be carried out when the
tyres are cold.
+ flashing then fixed,
accompanied by the
Service warning lamp.The tyre pressure monitoring system
has a fault or no sensor is detected
on one of the wheels. Under-inflation detection is not assured.
Have the system checked by a CITROËN dealer or a
qualified workshop.
Warning / indicator lamp
State
cause A
ction / Observations
Engine
autodiagnosis
system flashing.
The engine management system has
a fault. Risk of destruction of the catalytic converter.
Have it checked by a CITROËN dealer or a qualified
workshop.
fixed. The emission control system has
a fault.
The warning lamp should go off when the engine is started.If it does not go off, contact a CITROËN dealer or
qualified workshop without delay.
Low fuel level fixed with the two
l
ast
bars flashing,
accompanied by a
message and an
audible signal. When it first comes on there remains
approximately 6 litres of fuel
in the
tank. You must refuel as soon as possible to avoid running
out of fuel.
This warning lamp will come on every time the ignition
is switched on, accompanied by a message and an
audible signal, until a sufficient addition of fuel is
made.
This audible signal and message are repeated with
increasing frequency as the fuel level drops and
approaches "0".
Fuel tank capacity: approximately 60 litres.
Never continue to drive until you run out of fuel as
this could damage the emission control and injection
systems.
Page 118 of 500
DS5_en_Chap04_conduite_ed02-2015
Tyre under-inflation detection
System which automatically checks the
pressures of the tyres while driving.
The system continuously monitors the
pressures of the four tyres, as soon as the
vehicle is moving.
A pressure sensor is located in the valve of
each tyre (except the spare wheel).
The system triggers an alert if a drop in
pressure is detected in one or more tyres.This system does not avoid the need
to check the tyre pressures regularly
(including the spare wheel) and before
a long journey.
Driving with under-inflated tyres
adversely affects road holding,
extends braking distances and causes
premature tyre wear, particularly under
arduous conditions (vehicle loaded,
high speed, long journey).
Driving with under-inflated tyres
increases fuel consumption.
The tyre pressures for your vehicle can
be found on the tyre pressure label.
The tyre pressures must be checked
when the tyres cold (vehicle stopped
for 1 hour or after driving for less then
6 miles (10 km) at moderate speed).
Other wise, add 0.3 bar to the values
indicated on the label.
For more information on identification
markings, including the tyre pressure
label, refer to the corresponding
section.
The tyre under-inflation detection
system is an aid to driving which does
not replace the need for vigilance on
the part of the driver.
Page 119 of 500
11 7
DS5_en_Chap04_conduite_ed02-2015
Under-inflation alert
The aler t is given by the fixed illumination
of this warning lamp, accompanied by
an audible signal, and depending on
equipment, the display of a message.
In the event of a problem on one of the tyres,
the symbol or the message appears, according
to equipment, to identify it.
F
Re
duce speed, avoid sudden steering
movements or harsh brake applications.
F
St
op as soon as it is safe to do so. The alert is maintained until the tyre or
tyres concerned is reinflated, repaired
or replaced.
The spare wheel (space-saver type or a
steel rim) does not have a sensor.
The loss of pressure detected does not
always lead to visible deformation of
the tyre.
Do not rely on just a visual check.
Operating fault
The flashing and then fixed
illumination of the under-inflation
warning lamp accompanied by the
illumination of the service warning
lamp indicates a fault with the system.
This alert is also displayed when one or
more wheels is not fitted with a sensor
(for example, a space-saver or steel
spare wheel).
Go to a CITROËN dealer or a qualified
workshop
t
o have the system checked or,
following the repair of a puncture, to have the
original wheel, equipped with a sensor, refitted. In this case, monitoring of the tyre pressures is
not assured.
F
If y
ou have a compressor (the one in the
temporary puncture repair kit for example),
check the four tyre pressures when cold.
If i
t is not possible to check the tyre
pressures at the time, drive carefully at
reduced speed.
or
F In t
he event of a puncture, use the
temporary puncture repair kit or the spare
wheel (according to equipment). Any tyre repair or replacement on a wheel
fitted with this system must be carried out by a
CITROËN dealer or a qualified workshop.
If after changing a tyre, a wheel is not detected
by your vehicle (fitting snow tyres for example),
you must have the system reinitialised by a
CITROËN dealer or a qualified workshop.
driving
Page 199 of 500
197
DS5_en_Chap08_info-pratiques_ed02-2015
A. "Sealant" or "Air" position selector.
B. O n "I" / off "O" switch.
c. De
flation button.
d. Pr
essure gauge (in bar and psi).
E.
Co
mpartment housing:
-
a ca
ble with adaptor for 12 V socket,
-
va
rious inflation adaptors for
accessories, such as balls,
bicycle
t
yres...
description of the kit
F. Sealant cartridge.
G. Wh ite pipe with cap for repair.
H.
Bl
ack pipe for inflation.
I.
Sp
eed limit sticker.
The speed limit sticker I must be affixed
to the vehicle's steering wheel to remind
you that a wheel is in temporary use.
Do not exceed a speed of 50 mph
(80
k
m/h) when driving with a tyre
repaired using this type of kit.
The tyre inflation pressures are given on this
label.
Practical information
Page 201 of 500
199
DS5_en_Chap08_info-pratiques_ed02-2015
Do not start the compressor before
connecting the white pipe to the tyre
valve: the sealant product would be
expelled through the pipe.
F Sw
itch on the compressor by moving
the switch B to position "I" until the tyre
pressure reaches 2.0 bars.
Th
e sealant is injected into the tyre under
pressure; do not disconnect the pipe from
the valve during this operation (risk of
splashing). F Re
move the kit and screw the cap back on
the white pipe.
Ta
ke care to avoid staining your vehicle
with traces of fluid. Keep the kit to hand.
F
Dr
ive immediately for approximately three
miles (five kilometres), at reduced speed
(between 15 and 35 mph (20 and 60 km/h)),
to plug the puncture.
F
St
op to check the repair and the tyre
pressure using the kit.
Tyre under-inflation detection
If the vehicle is fitted with tyre under-
inflation detection, the under-inflation
warning lamp will remain on after the
wheel has been repaired until the
system is reinitialised by a CITROËN
dealer or a qualified workshop.
If after around 5 to 7 minutes the
pressure is not attained, this indicates
that the tyre is not repairable; contact
a CITROËN dealer or a qualified
workshop for assistance.
Practical information
Page 202 of 500
DS5_en_Chap08_info-pratiques_ed02-2015
F Turn the selector A to the "air"
position.
F
Un
coil the black pipe H fully.
F
Co
nnect the black pipe to the
valve of the wheel. F
Co
nnect the compressor's electric plug to
the vehicle's 12 V socket.
F St art the vehicle again and leave the
engine running. F
Ad
just the pressure using the compressor
(to inflate: switch B in position "I" ;
to d eflate: switch B i n position "O" and
press button
c), i
n accordance with the
vehicle's tyre pressure label (located on the
left hand door aperture).
A lo
ss of pressure indicates that the
puncture has not been fully plugged;
contact a CITROËN dealer or qualified
workshop for assistance.
F
Re
move and stow the kit.
F
Dr
ive at reduced speed (50 mph [80 km/h]
max) limiting the distance travelled to
approximately 120 miles (200 km).
As soon as possible, go to a CITROËN
dealer or a qualified workshop.
You must inform the technician that you
have used this kit. After inspection, the
technician will advise you on whether
the tyre can be repaired or if it must be
replaced.
2. Inflation
Page 276 of 500
DS5_en_Chap10_caracteristiques_ed02-2015
Identification markingsVarious visible markings for the identification of your vehicle.
A.
veh
icle Identification Number (
vIN
)
under the bonnet.
Th
is number is engraved on the bodywork
near the damper support. The tyre pressures must be checked
when the tyres are cold, at least once
a month.
If the tyre pressures are too low, this
increases fuel consumption.
B.
veh
icle identification Number (
vIN
) on
the windscreen lower cross member.
Th
is number is indicated on a self-adhesive
label which is visible through the windscreen.
c. Ma
nufacturer's label.
Th
e VIN is indicated on a self-destroying
label affixed to the door aperture, on the
passenger's side.
d. Tyr
e/paint label.
Th
is label is affixed to the centre pillar, on
the driver's side. It bears the following information:
-
th
e tyre inflation pressures, laden and
unladen,
-
th
e tyre sizes,
-
th
e inflation pressure of the spare wheel,
-
th
e paint colour code.
The rear quarter light cannot be etched
as it is made of polycarbonate material.