wheel Citroen DS5 HYBRID 2016 1.G Repair Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2016, Model line: DS5 HYBRID, Model: Citroen DS5 HYBRID 2016 1.GPages: 376, PDF Size: 12.57 MB
Page 348 of 376
"ECO OFF" function
This function prevents the HDi Diesel engine being
switched off and ensures that a comfortable temperature
can be maintained in the passenger compartment.
This therefore allows the air conditioning or heating to be
kept running.
Depending on version, the control is either in
the switch panel alongside the steering wheel,
or in the " Driving
" menu of the touch screen.
On pressing the ECO OFF
switch, the
HDi Diesel engine restarts immediately and
then operates continuously.
The indicator lamp in the control comes on.
Pressing this control again deactivates the
function.
The indicator lamp in the control goes off.
The Hybrid4 system returns to normal
operation.
*
Except in ZEV mode, which gives preference
to electric running over maintaining a
comfortable temperature.
The function is deactivated on
switching off the ignition.
During phases of electric running and
when the internal combustion engine is
stopped, the Hybrid4 system manages
restarting automatically to maintain
the temperature in the passenger
compartment * .
However, variations in temperature
may still be felt in very high ambient
temperatures.
In this case, activate the ECO OFF
function.
With the switch on the dashboard
)
Press this switch.
Deactivation is confirmed by the illumination of
the indicator lamp in the control switch and the
display of a message.
Pressing the switch again reactivates the
system.
The indicator lamp in the switch goes off,
accompanied by the display of a message.
With the touch screen button
Pressing the button again reactivates the
system.
The indicator lamp for the button goes off,
accompanied by the display of a message.
)
Select the "Driving"
menu.
Deactivation is confirmed by the illumination of
the indicator lamp for the button and the display
of a message.
)
In the page, press this button.
Page 349 of 376
23Hybrid4 system
Driving recommendations
Obser ve the driving regulations and remain
vigilant whatever the traffic conditions.
Pay close attention to the traffic and keep your
hands on the wheel so that you are ready to
react at any time to any eventuality.
On a long journey, a break every two hours is
strongly recommended.
In difficult weather, drive smoothly, anticipate
the need to brake and increase the distance
from other vehicles.
Driving on flooded roads
We strongly advise against driving on flooded
roads, as this could cause serious damage
to the internal combustion engine or electric
motor, the electronic gearbox, or the electrical
systems of your vehicle. If you are obliged to drive through water:
- check that the depth of water does not
exceed 15 cm, taking account of waves
that might be generated by other users,
- place the mode selector in the 4WD
position,
- drive as slowly as possible without
stalling. In all cases, do not exceed 6 mph
(10 km/h),
- do not stop and do not switch off the
engine.
On leaving the flooded road, as soon as
circumstances allow, make several light brake
applications to dry the brake discs and pads.
If in doubt on the state of your vehicle, contact
a CITROËN dealer or a qualified workshop.
Important!
Never drive with the parking brake
applied - Risk of overheating and
damage to the braking system!
Do not park or run the engine when
stationary in areas where inflammable
substances and materials (dry grass,
dead leaves...) might come into
contact with the hot exhaust system
or certain components of the Hybrid4
system which can reach very high
temperatures - Risk of fire!
Never leave a vehicle unsuper vised
with the engine running. If you have
to leave your vehicle with the engine
running, apply the parking brake
and put the electronic gearbox into
position N
.
Page 358 of 376
When immobilising the vehicle, with the
Hybrid4 system active, you must place
the gear selector in neutral N
.
Before carrying out any work in the
engine compartment, check that the
gear selector is in position N
, that the
parking brake is applied and that the
READY
lamp is off before switching off
the Hybrid4 system.
Six-speed electronic gearbox which offers a
choice between two operating modes:
- automated
mode for automatic control of
the gears by the gearbox,
- manual
mode for sequential gear changing
by the driver.
In automated mode, it is possible to change
gear manually by using the steering mounted
control paddles as desired, when overtaking,
for example.
Electronic gearbox (ETG6)
R.
Reverse
)
With your foot on the brake, lift the selector
and move it for wards.
N.
Neutral.
)
With your foot on the brake, select this
position to start.
A.
Automated mode.
)
Move the selector backwards to select
this mode.
M.
Manual mode with sequential gear changing.
)
Lift the selector, then move it backwards
to select this mode, then use the steering
mounted control paddles to change gear.
Gear selector
+.
Change up paddle to the right of the
steering wheel.
)
Press the back of the "+"
steering mounted
paddle to change up a gear.
-.
Change down paddle to the left of the
steering wheel.
)
Press the back of the "-"
steering mounted
paddle to change down a gear.
Steering mounted control paddles
Engagement of reverse gear is
accompanied by an audible signal.
The steering mounted paddles cannot
be used to select neutral or to engage
or disengage reverse gear.
Page 361 of 376
35Driving
Stopping the vehicle
Operating fault
Before leaving the vehicle, check that
the parking brake lamps are on (not
flashing) in the instrument panel and in
the control lever.
To immobilise the vehicle without
applying the parking brake, before
switching off the ignition, place the gear
selector in position A
or R
.
If the battery is flat, it is essential
to place a chock against one of the
wheels to immobilise the vehicle.
Before switching off the Hybrid4 system, place
the gear selector in position N.
When switching off the Hybrid4 system, the
electric parking brake is applied automatically.
If the automatic function is deactivated, apply
the parking brake manually to immobilise the
vehicle.
Never leave children unsuper vised in
the vehicle with the Hybrid4 system
active.
For your safety, this function will only
be activated if you press the brake
pedal when engaging for ward drive or
reverse.
This function is deactivated if the
driver's door is opened. To reactivate
it, close the door and then press the
brake or accelerator pedal.
Creep function
This function facilitates manoeuvring of the
vehicle at low speed (when parking, in traffic
jams, …).
With the Hybrid4 hybrid system active, the
vehicle stationary and the parking brake
released:
)
press the brake pedal,
)
place the gear selector in position A
, R
or
M
,
)
gradually release the brake pedal.
The vehicle moves off immediately and
gradually reaches a speed of approximately
6 mph (10 km/h), with pressing the accelerator
pedal.
With the ignition on, the
flashing of this warning lamp,
accompanied by an audible
signal and a message
in the instrument panel screen, indicates a
malfunction of the gearbox.
Have it checked by a CITROËN dealer or a
qualified workshop.
Page 363 of 376
37Practical information
Temporary puncture repair kit
This kit comprises a compressor and a sealant cartridge.
It allows you to carry out a temporary repair
to a tyre.
This makes it possible to continue to the nearest garage.
It can be used for for repairing most
punctures on the tread or shoulder of
the tyre.
The compressor can be used to check
and adjust a tyre pressure.
For more information on the use of this
temporary puncture repair kit, refer
to the corresponding section in the
handbook for the vehicle.
All of these tools are specific to your
vehicle.
Do not use them for other purposes.
Access to the kit
List of tools
1.
12 V compressor.
Contains a sealant cartridge for the
temporary repair of a tyre and can also be
used for adjusting tyre pressures.
2.
Chock.
For blocking the wheels of the vehicle.
3.
Wheel bolt cover remover.
For removing the wheel bolt head
protectors on alloy wheels.
4.
Wheel trim remover.
For removing the wheel bolt finishers on
alloy wheels.
5.
Removable towing eye.
This kit is installed in the storage box, under the
boot floor.
Page 364 of 376
Recovery of the vehicle on a fl at-bed
Never recover the vehicle by towing it with two or four wheels on the ground, as there is a risk of
damage to the transmission.
However, if necessary because access to the vehicle is difficult, the vehicle can be moved a few
dozen metres, at a speed of less than 6 mph (10 km/h).
Use the towing eye only
to pull the vehicle out
or to lash it for recovery on a flat-bed lorry or
trailer.
Before doing any work, with the ignition on, press the brake pedal and place the gear selector at
position N
, then switch off the Hybrid4 system ( READY
lamp off).
Always call on professionals for recovery of the vehicle on a flat-bed lorry or trailer.
Snow chains
Recommendations
The use of snow chains is only authorised on
the front wheels.
The mode selector must be in the
4WD
position.
For information on the sizes
compatible with the tyres on your
vehicle and advice on use, refer to the
corresponding section in the handbook
for the vehicle.
Page 370 of 376
Air conditioning / Heating
Question
Answer
It seems to me that the vehicle runs less on electric
when the heating or air conditioning is operating, is that
right? The demand for heating or air conditioning may require the starting of the HDi Diesel
engine until the desired level of comfort is attained.
Normal operation of the Hybrid4 system is simply put back. The period can be longer
under very low or very high ambient temperatures.
It seems to me that when it is very hot and the air
conditioning is working, the vehicle runs on electric for
shorter periods. Is that right? When it is hot, the periods when the HDi Diesel engine is put on standby and the vehicle
runs on electric are necessarily restricted in order to limit the difference between the
temperature in the vehicle and the level of comfort selected.
In very hot weather, it is possible to press the " ECO OFF
" button (which brings the vehicle
out of ZEV
mode and prevents electric running or the stopping of the engine) to give
preference to temperature control (keeps the air conditioning running).
Miscellaneous
Question
Answer
Is towing possible with my Hybrid4 vehicle? For information on the towing ability of your Hybrid4 vehicle, refer to " Weights and towed
loads" in the "Technical data" section.
This allows a jet ski or two-wheeler on a trailer to be towed, for example.
This limit is related to maintaining adequate cooling capacity for the HDi Diesel engine as
well as the components of the Hybrid4 system that are also cooled by the engine's cooling
system.
Why does engine braking seem so strong? If the high voltage battery is not fully charged, the engine braking results mainly from the
energy recovery by the electric motor. The power of this engine braking is higher than that
of an internal combustion engine.
Page 371 of 376
45Alphabetical index
Advice on driving ............................................ 23
Air conditioning ......................................... 22, 25
Bag hook ......................................................... 31
Back up starting .............................................. 18
Battery, 12 V ...................................................... 5
Battery, high voltage ........................ 5, 27-29, 39
Boot floor, removable ...................................... 31
Cable, high voltage ......................................... 28
Car wash ......................................................... 36
Cooling, high voltage battery .......................... 29
Defrosting ........................................................ 25
Demisting ........................................................ 25
Display screen, instrument panel ......... 8, 10, 13
Driving economically....................................... 24
Eco-driving ..................................................... 24
ECO OFF (switch) ........................................... 22
Electric running (ZEV) ............ 11, 20, 22, 24, 25
Electronic key .......................................15, 17, 18
Emergency switching off ................................. 18
Energy flows ............................................. 10, 11
Energy recovery .................................... 9, 11, 24Keyless Entry and Starting ..................15, 17, 18
Key not recognised ......................................... 18
Kit, temporary puncture repair ........................ 37
Filter, particle ........................................ 5, 26, 42
Fittings, boot ................................................... 31
Flat bed (recovery) .......................................... 38
Four-wheel drive (4WD) ................ 19, 21, 23, 38
Fuel consumption .................................. 9, 12, 24
Gearbox, electronic ...................5, 15, 23 -25, 32
Gear selector, electronic gearbox .................. 32 Engine compartment ...................................... 30
Engine, Diesel .....................5, 19, 22, 25, 36, 40
Environment .................................................... 24
Opening the bonnet ........................................ 30
Ignition on........................................................ 17
Indicator, power................................................. 9
Instrument panel ............................................... 8 Head-up display .............................................. 16
Heating ...................................................... 22, 25
High voltage .............................................. 27, 28
Histogram, fuel consumption .......................... 12Mode selector ......................................... 2, 7, 19
Motor, electric ....................................... 5, 19, 39
Parcel shelf, rear ............................................. 31
Parking brake, electric ........................ 15, 23, 36
Power indicator ............................................. 8, 9
Puncture .......................................................... 37A
B
C
D
EH
IK
F
GM
O
P