open bonnet Citroen DS5 HYBRID4 2012 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2012, Model line: DS5 HYBRID4, Model: Citroen DS5 HYBRID4 2012 1.GPages: 358, PDF Size: 10.91 MB
Page 7 of 358
CHECKS PR ACTICAL
INFORMATIONTECHNICAL DATA AUDIO and
TELEMATICS
196Te m p o r a ry puncture
repair kit
202Changing a wheel
209Changing a bulb
217Changing a fuse
220 12 V battery
223Energy economy mode
224Changing a wiper blade
224Recovering the vehicle
226 Vehic le recovery
226 Towing a trailer
228Fitting roof bars
229Accessories
235 Opening the bonnet
236 Diesel engine
237 Running out of fuel (Diesel)
238Checking levels
241 Checks
246 Electric motor
247Diesel engine
248 Diesel weights
249 Dimensions
250 Identifi cation markings
254 Emergency or assistance
257eMyWay
311 Audio system
008008009009010010011011
Page 52 of 358
Underbonnet precautions / warnings
The alternator-star ter motor of your hybrid
vehicle is also supplied at high voltage. If the
vehicle ignition has not been switched off, there
is a risk of the engine restar ting at any time.
Alwa
ys ensure that theignition is switched off ( Readylamp off) before
opening the bonnet.
Also ensure that the ignition is switchedoff when refuelling to avoid the enginerestarting.
Page 87 of 358
OFF
85
Access
System which protects and provides a deterrent
against theft and break-ins. It provides the
following types of monitoring:
Alarm
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open adoor, the boot or the bonnet...
- Interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.
- Tilt
The system checks for any change in the attitude of the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or knocked.
Self-protection function
The system checks for the puttingout of ser vice of its components. The alarm is triggered if the battery, thebutton or the wires of the siren are putout of ser vice or damaged.
For all work on the alarm system, contact a CITROËN dealer or aqualified workshop.
Locking the vehicle with full
alarm system
Activation
)Switch off the ignition and get out of the vehicle.
)
Press the locking button on the
r
emote control or lock the vehicleusing the Keyless Entry and Starting system. The monitoring system is active: the indicator
lam
p in the button flashes once per second.
After the locking button on the remote control
is pressed or the vehicle locked using the
Keyless Entry and Star ting system, the exterior
perimeter monitoring is activated after a delay of 5 seconds, the interior volumetric monitoring after 45 seconds and the anti-tilt after one
minute and 30 seconds.
If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior
perimeter monitoring will be activated after a
delay of 45 seconds.
) Press the unlocking button on
the remote control or unlock the
vehicle using the Keyless Entryand Star ting system.
Deactivation of the volumetric monitoring
The volumetric protection system is deactivated: the indicator lamp in the button goes off.
Page 222 of 358
12 V battery
The presence of this label indicatesthe use of a 12 V lead-acid battery withspecial technology and specification, for which the involvement of a CITROËN dealer or qualified workshop is requiredwhen replacing or disconnecting thebattery.
Failure to observe this recommendation may cause premature wear of thebattery. The battery is located under the bonnet.
To
gain access to it: )
open the bonnet using the interior releaselever, then the exterior safety catch, )
remove the plastic cover on the (+) terminal,
)
if necessary, unclip the fusebox to remove
the battery.
Access to the battery
)Raise the locking tab Dfully to release the cable terminal clamp E
.
Reconnecting the (+) cable
)Position the open clamp Eof the cable on
the positive post (+) of the battery. )Press ver tically on the clamp E
to position
it correctly on the battery. )Lock the clamp by spreading the positioning lug and then lowering the tab D.
Do not apply excessive force on thetab as locking will not be possible if the clamp is not positioned correctly; star tthe procedure again.
Before doing any work on your vehicle,
switch off the ignition ( Ready
lamp off)to avoid any risk of injury resulting fromautomatic operation of the engine. Y
our vehicle is fitted with a conventional 12 V
battery, located under the bonnet, in addition
to the hi
gh voltage battery used by the hybrid system.
In cer tain conditions, if the 12 V battery is
too discharged to activate the hybrid system, recharging from another conventional 12 V battery is possible.
Do not carry out this recharge if the Readylamp is on. Procedure
for star ting the engine using another battery or charging a discharged battery.
Disconnecting the (+) cable