fog light bulb Citroen GRAND C4 PICASSO 2017 2.G Owner's Manual

211
C4-Picasso-II_en_Chap05_eclairage-visibilite_ed02-2016
Lighting control stalk
Main lighting
The various front and rear lamps of the vehicle
are designed to adapt the driver's visibility
progressively according to the climatic
conditions:
-
s
idelamps, to be seen,
-

d
aytime running lamps to be more visible
during the day,
-

d
ipped beam headlamps to see without
dazzling other drivers,
-

m
ain beam headlamps to see clearly when
the road is clear.
Additional lighting
Other lamps are provided to meet the
requirements of particular driving conditions:
-
r

ear foglamps,
-

f
ront foglamps with cornering lighting,
-

d
irectional headlamps for improved
visibility when cornering,
-

g
uide-me-home and welcome lighting to
facilitate access to the vehicle,
-

p
arking lamps as vehicle position markers.
Programming
The setting of some functions can be adjusted:
- a utomatic illumination of headlamps,
-

a
utomatic headlamp dipping,
-

g
uide-me-home lighting,
-

w
elcome lighting,
-

c
ornering lighting,
-
d

irectional lighting.
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.
Travelling abroad
Halogen headlamps
For motoring in countries that drive
on the other side of the road, it is
necessary to adapt the adjustment of
the dipped beams so as to not dazzle
the drivers of approaching vehicles.
Contact a CITROËN dealer or qualified
workshop.
Xenon headlamps
The design of the dipped beam
headlamps allows you to drive in a
country that drives on the other side
of the road, without the need for any
modification.
In the event of the failure of one or more
bulbs, a message advises you to check
the lamp(s) in question.
Selection and control of the various front and rear lamps providing the vehicle's lighting.
5
Lighting and visibility

304
C4-Picasso-II_en_Chap08_en-cas-panne_ed02-2016
Changing a bulb
For H7 type bulbs with lugs... take care
to observe their correct installation
so as to ensure the best lighting
performance.
Risk of electrocution
Xenon bulbs (D5S-25W) must be
replaced by a CITROËN dealer or a
qualified workshop.
Front lamps
1. Directional dipped beam headlamps (D5S-25W).
2.
M

ain beam headlamps (H7-55W).
3.
D

aytime running lamps / sidelamps
(

6 light emitting diodes - LEDs).
4.
D

irection indicators
(

6 light emittng diodes - LEDs).
5.
F

ront foglamps (H11-55W). 1. D
ipped beam headlamps (H7-55W).
2. M ain beam headlamps (H7-55W).
3.
D

aytime running lamps/sidelamps
(

4 light emitting diodes - LEDs).
4.
D

irection indicators (PW Y24W).
5.
F

oglamps (H11-55W).In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.
Light- emitting diodes - LEDs
For replacement, contact a CITROËN dealer or
qualified workshop.
Model with xenon headlamps Model with halogen headlamps
In the event of a breakdown

307
C4-Picasso-II_en_Chap08_en-cas-panne_ed02-2016
The direction indicator bulb is located below
the front lamp.
F
T
urn the bulb holder a quarter turn anti-
clockwise.
F

R
emove the bulb holder.
F

C
hange the failed bulb.
For reassembly, carry out these operations in
reverse order.
Direction indicators Front foglamps
F Unclip the finisher by pulling at the top.
F
R emove the two screws to remove the unit.
F

T
urn the bulb holder a quarter turn.
F

R
emove the bulb holder.
F

C
hange the failed bulb.
For reassembly, carry out these operations in
reverse order, pressing on the finisher to refit it.
Faster flashing of a direction indicator
warning lamp (left or right) indicates a
failed bulb on that side.
Direction indicators
(light- emitting diodes - LED)
For the replacement of this type of lamp,
contact a CITROËN dealer or a qualified
workshop.
8
In the event of a breakdown

308
C4-Picasso-II_en_Chap08_en-cas-panne_ed02-2016
You should contact a CITROËN dealer or a
qualified workshop for the replacement of the
light-emitting diode - LED.
Door mirror spotlamps
Integrated direction indicator
side repeaters
You should contact a CITROËN dealer or a
qualified workshop for the replacement of these
bulbs.1.
D

irection indicators (PY21W amber).
2.
S
idelamps / foglamps (P21/5W).
Rear lamps
Light-emitting diodes -
LEDs
For replacement, contact a CITROËN
dealer or qualified workshop.
3.
B

rake lamps / sidelamps (light-emitting
diodes - LEDs).
4. R
eversing lamps (W16W).
5.
D

irection indicators (PY21W).
Model with LED lamps3. Sidelamps (5W5).
4. B rake lamps (P21/ W).
5.
D

irection indicators (W Y16W).
6.
R

eversing lamps (W16W).
Model with conventional bulb lamps
In the event of a breakdown

310
C4-Picasso-II_en_Chap08_en-cas-panne_ed02-2016
1. Direction indicators (PY21W amber).
2. Sidelamps / foglamps (P21/5W).
Rear lamps
3. Sidelamps (light-emitting diodes - LEDs).
4. B rake lamps (light-emitting diodes - LEDs).
5.
D

irection indicators (PY21W).
6.
R

eversing lamps (light-emitting diodes -
L ED s).
Model with LED lamps
3. Sidelamps (W5W).
4. B rake lamps / sidelamps (P21W).
5.
D

irection indicators (W Y16W).
6.
R

eversing lamps (W16W).
Model with conventional bulb lamps
Light-emitting diodes -
LEDs
For replacement, contact a CITROËN
dealer or qualified workshop.
In the event of a breakdown

312
C4-Picasso-II_en_Chap08_en-cas-panne_ed02-2016
Direction indicator, sidelamp and
foglamp
Access is by passing a hand under the bumper.
F T urn the bulb holder a quarter of a turn and
pull it out.
F

C
hange the bulb.
For reassembly carry out these operations in
reverse order.
You can also contact a CITROËN dealer or a
qualified workshop for the replacement of these
bulbs. For the replacement of this type of lamp,
contact a CITROËN dealer or a qualified
workshop.
Third brake lamp (light- emitting
diodes-LED)
Number plate lamps
(W5W)
To refit, press on the lens to clip it in place. F
I
nsert a thin screwdriver into one of the cut-
outs in the lens.
F
P
ush it outwards to unclip it.
F
R
emove the lens.
F
C
hange the faulty bulb.
In the event of a breakdown