fold seats Citroen GRAND C4 PICASSO 2017 2.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2017, Model line: GRAND C4 PICASSO, Model: Citroen GRAND C4 PICASSO 2017 2.GPages: 527, PDF Size: 12.91 MB
Page 70 of 527
68
C4-Picasso-II_en_Chap02_ouvertures_ed02-2016
Reinitialising the motorised
tailgate
This operation is necessary where there is
no movement - after detection of an obstacle,
connecting or recharging the battery, ...
F
O
pen the tailgate manually, if necessary.
F
M
anually close the tailgate fully.
If the problem persists, contact a CITROËN
dealer or a qualified workshop.
Precautions in use
In wintry conditions
In the event of an accumulation of snow
on the tailgate, clear the snow before
commanding a motorised opening of
the tailgate.
The formation of ice can block the
tailgate and prevent its opening: wait
until the ice melts with the heating of
the passenger compartment.
When washing the vehicle
When washing the vehicle in an
automatic car wash, don't forget to
lock your vehicle to avoid the risk of
unexpected opening.
Back-up release
F Fold back the rear seats to gain access to the lock from inside the boot.
F
I
nsert a small screwdriver into hole A of the
lock to unlock the tailgate.
F
M
ove the latch to the left.
Locking after closing
If the fault persists after closing again, the boot
will remain locked. To manually unlock the boot in the event of a
battery or central locking failure.
Unlocking
Access
Page 79 of 527
77
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
F Pull the control upwards or turn the knob to adjust the backrest.
When the backrest is at the desired angle,
release the control.
Table position for the
passenger's seat backrest
This position, associated with the position of
the rear seats, allows you to carry long objects
inside the vehicle.
When the backrest is at the desired angle,
release the control lever. To ensure that the
backrest does not suddenly fold for wards
and hurt you, restrain it with your back or
your hand while operating the control.
Check that there is no object that could
inter fere with the movement of the seat,
both above and below.
F
P
lace the head restraint in the low position,
raise the armrest and fold the fixed table
onto the back of the seat.
F
P
ull the control fully up and tip the backrest
forwards.
To return to the normal position, guide the
backrest backwards until it locks.
Passenger's seat backrest angle
3
Ease of use and comfort
Page 84 of 527
82
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Heated seats
F Use the adjustment thumbwheel to switch on and select the desired level of heating:
0: Off.
1 : Low.
2 : Medium.
3 : High.
With the engine running, the front seats can be
heated separately.
Before operating the leg rest, ensure
that nothing could inter fere with its
movement.
F
P
ush the control for wards or backwards to
unfold or fold away the leg rest.
The movement stops when you release the
control.
Electric passenger seat
Do not use the function if the seat is not
occupied.
Reduce the level of heating as soon as
possible.
Once the seat and passenger
compartment are at a comfortable
temperature, you can switch off the
function; reducing electric current
consumption also reduces fuel
consumption. Prolonged use at the highest setting
is not recommended for those with
sensitive skin.
There is a risk of burns for those that
do not have normal perception of heat
(illness, taking medicines, ...).
There is a risk of overheating the
system if material with insulating
properties is used, such as cushions or
seat covers.
Do not use the system:
-
i
f wearing damp clothing,
-
i
f child seats are fitted.
To avoid breaking the heating element
in the seat:
-
d
o not place heavy objects on the
seat,
-
d
o not kneel or stand on the seat,
- d o not place sharp objects on the
seat,
-
d
o not spill liquids onto the seat.
To avoid the risk of short-circuit:
-
d
o not use liquid products for
cleaning the seat,
-
n
ever use the heating function
when the seat is damp.
Ease of use and comfort
Page 86 of 527
84
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Second-row seats
Forwards-backwards adjustment
F Raise the lever A, located at the front of
the seat cushion, and adjust the seat to the
desired position.
The 3 seats in the 2
nd row are independent of each other and are all the same width. Their backrests can be folded to vary the load space in the boot.
A.
F
or wards and backwards adjustment: raise
the lever.
B.
B
ackrest angle adjustment: pull the strap
and guide the seat to the rear.
C.
F
olding the seat: pull the strap up to
release the seat.
D.
F
olding the seat from the rear: pull the
strap then push the seat for ward.
Ease of use and comfort
Page 87 of 527
85
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
F Pull the strap B and guide the seat to the r e a r.
The backrest reclines and the seat base pivots
s li g ht l y.
"Comfort" position
Returning the seat to the initial
position
F Pull the strap B and guide the seat for ward.
Super vise any movements of seats
when made by children. To remove it:
- m
ove the head restraint to the high position,
-
p
ress lug A pulling the head restraint
upwards at the same time.
The rear head restraints can be removed and
have two positions:
-
h
igh, position for use,
-
l
ow, stowed position.
To raise a head restraint, pull it upwards.
To lower it, press lug A then the head restraint.
Rear head restraints
Never drive with the head restraints
removed; they must be in place and
correctly adjusted.
To refit it:
-
e
ngage the head restraint rods in the
apertures, keeping them in line with the
seat backrest. Depending on version, the sides can be folded
to obtain a more comfortable position.
Relax head restraints
3
Ease of use and comfort
Page 88 of 527
86
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Flat floor
Folding a seat
F Pull firmly upwards on strap C, as indicated
by the arrow, to release the seat; keep
pulling until the seat is fully folded.
P
ush the seat backrest gently for wards
so that the backrest folds onto the seat
cushion. The assembly lowers onto the
f l o o r. You can fold the second-row seats from the
boot, after first folding the third-row seats.
F
P
ull on the strap D to release the seat in
question then push for wards lightly on the
backrest.
T
o avoid any damage to the mechanism,
the strap D
unclips if too much force is
applied. Simply clip it in place again for the
system to be operational again.
F
P
lace the seats in the fully back position.
Each seat can be folded onto the floor to vary
the space available in the boot.
From the outside
From the boot, when loading
for example
Ease of use and comfort
Page 89 of 527
87
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Repositioning a seat
Before operating the rear seats, check
that the outer rear seat belts are not
loose, to avoid damaging them. The
centre belt must be stowed. Fix the
tongues of the three belts to their
anchorage points.
Continuity panels
These continuity panels are not
designed to support a weight greater
than 30 kg.Releasing / locking the continuity panels
F
B
efore unfolding the continuity panels,
check that the seats in the 2
nd row are fully
back.
F
S
lide the continuity panel latch upwards to
release.
F
S
traighten the continuity panel, then slide
the latch downwards to lock it.
F
I
f necessary, straighten the continuity
panels for the seats in the 2
nd row and lock
them in place.
F
R
aise the backrest and push it rear wards
until it locks in position Each seat has a continuity panel at the bottom
of the backrest, that once unfolded:
-
p rovides a continuous load sur face in the
boot, whatever the position of the seats,
-
a
voids objects sliding under the seats in
the 2
nd row.
3
Ease of use and comfort
Page 90 of 527
88
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Access to the third-row
seats
Access to the third-row seats is via the outer
second-row seats.
F
P
ull the lever E . The seat is released and
the seat cushion comes up against the
backrest.
F
H
old the lever E in the raised position,
pushing for wards. The whole seat slides
towards the front seat.
Space becomes free behind the seat, the
third-row passengers can get to their seats.
Leaving the vehicle from
the third-row seats Repositioning a seat, from
the outside, with the door
open
In the event of a failure of this system
(lever E
), the passengers in the third
row can also leave the vehicle after first
folding the backrests of the second-row
seats using the strap D .
Do not allow children to operate the
seats without supervision.
F
L
ift the lever E
. The seat is released and
the seat cushion comes up against the
backrest.
F
P
ush the seat backrest, still holding the
lever E in the raised position. If there are passengers seated in the third row:
F
m
anually return the assembly as far
as possible rear wards; the seat does
not return to the fully back position, so
as to retain legroom for the third-row
passengers,
F
f
old the seat cushion until it locks.
Ensure that there is no object on or under the
seat that you want to move.
Before operating the seats, ensure that
the tables on the backs of the first-row
seats are folded away.
Ease of use and comfort
Page 91 of 527
89
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Third-row seats
Concertina boards
Folding the concertina boards
F Remove the luggage net.
F or more information on the luggage net
and the Interior fittings , refer to the
corresponding section.
F
R
eturn the second-row continuity panels to
their initial position and lock them in place.
F
F
old the concertina boards and position
them vertically.
F
P
ull on the strap F located behind the seat
backrest. The backrest pivots rear wards,
pulling the seat base with it. The seat locks
in the open position.
Each of the two floor panels can
support a load of 100 kg.
Pull on the control, the 3 sections of the board
will fold like a concertina.
When the third-row seats are upright, these
concertina boards can be left either:
-
f
lat behind the seats,
-
i
n the vertical position,
thereby leaving a storage area available.
Repositioning the
seats
Two rigid concertina boards, which cannot
be separated from the vehicle, cover the
2
third-row seats, when these are in the folded
position.
3
Ease of use and comfort
Page 92 of 527
90
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
F Return the second-row continuity panels to their initial position and lock them.
F
L
ower the head restraints.
F
C
orrectly position the concertina board
vertically behind the seat.
F
C
heck that the seat belts for the 3
rd row
seats are correctly fixed to the loops and
are not folded.
F
P
ull the strap G , located at the bottom of
the seat backrest. The seat unlocks. Before moving the third-row seats,
return the rigid floor plates of the
second-row seats to the upright position
and lock them in place.
Do not try to fold a third-row seat that
has not first had the backrest fully
locked in place.
Do not leave objects either on or
underneath the seat bases of the third-
row seats when you are folding them.
Do not leave your hand on the control
G
as you fold the seats, as you risk
trapping your fingers.
Do not allow children to operate the
seats without supervision.
F
N
ext push the backrest gently for wards.
The backrest pivots, folding onto the seat
base. The seat base then folds into the
stowage area provided for that purpose.
F
R
eposition the concertina boards over the
folded seats.
Folding the seats
Ease of use and comfort