driver seat adjustment Citroen GRAND C4 PICASSO RHD 2017 2.G Owner's Manual

76
Front seats
Manual adjustments
F Raise the control bar and slide the seat for wards or backwards.
When the seat is in the desired position, push
it for wards and backwards without raising the
control bar to check that it has latched. F
T urn the knob to adjust the seat backrest.
As a safety measure, seat adjustments should only be done when stationary.
F P ull the control upwards to raise or push
it downwards to lower, as many times as
necessary, to obtain the desired position.
Seat consisting of a seat cushion, a seat backrest and a head restraint which can all be adjusted to adapt your position for ease of driving and comfort.
Before moving the seat backwards, ensure that there is nothing that might prevent the full travel of the seat.
There is a risk of trapping or pinching passengers if present in the rear seats or jamming the seat if large objects are placed on the floor behind
the seat.
Forwards-backwards Driver's seat backrest angleDriver's seat height
Ease of use and comfort

78
Front seats
Electric adjustments
F Push the control for wards or rear wards to slide the seat. F
T ilt the control for wards or rear wards to
adjust the angle of the seat backrest. F
O perate the rear part of the control
upwards or downwards to obtain the
desired height.
F

O
perate the front part of the control
upwards or downwards to obtain the
desired angle.
To avoid discharging the battery, carry out
these adjustments with the engine running.
Before moving the seat backwards, ensure that there is nothing that might prevent the full travel of the seat.
There is a risk of trapping or pinching passengers if present in the rear seats or jamming the seat if large objects are placed on the floor behind
the seat.
Forwards-backwards (driver's seat) Seat backrest angleSeat cushion height and angle
Ease of use and comfort

79
System which registers the electrical settings
of the driver's seat.
Two positions can be stored and recalled, using
the buttons on the side of the driver's seat.
Storing driving positions
Storing a position using
buttons M / 1 / 2
F Switch on the ignition.
F
A djust your seat.
F

P
ress button M , then press button 1 or 2
within four seconds.
An audible signal indicates that the position has
been stored.
Storing a new position cancels the previous
position.
Recalling a stored position
F With the ignition on or the engine running, press button 1 or 2 to recall the
corresponding position.
An audible signal confirms that adjustment is
complete.
You can interrupt the current movement by
pressing button M , 1 or 2 or by using one of the
seat controls.
A stored position cannot be recalled while
driving.
Recalling stored positions is deactivated
45
seconds after switching off the ignition.
3
Ease of use and comfort

102
"Rear" function
F Press this button to activate / deactivate the "Rear" function.
From the secondary page of the Air
conditioning
menu:
This function gives rear passengers access to
the adjustment controls and allows:
-

t

he distribution of air conditioned air to the
vents for the 2
nd row of seats,
-
t
he distribution of ambient air to the vents
for the 3
rd row of seats.
F
T
urn the upper knob to open or close the
rear vent.
F

T
urn the lower knob to reduce (to the left)
or increase (to the right) the air flow.
Settings for passengers
in the 2nd row of seats"Mono" function
The comfort setting for the passenger's side
can be indexed to the driver's comfort setting
(mono-zone).
In the Air conditioning menu:
F

P
ress this button to activate /
deactivate the "Mono" function.
The function is deactivated automatically when
the passenger uses their temperature setting
buttons.
Ease of use and comfort

237
The driver must ensure that passengers use
the seat belts correctly and that they are all
fastened before setting off.
Wherever you are seated in the vehicle,
always fasten your seat belt, even for short
journeys.
Do not interchange the seat belt buckles as
they will not fulfill their role fully.
The seat belts are fitted with an inertia reel
permitting automatic adjustment of the
length of the strap to your size. The seat belt
is stowed automatically when not in use.
Before and after use, ensure that the seat
belt is reeled in correctly.
The lower part of the strap must be
positioned as low as possible on the pelvis.
The upper part must be positioned in the
hollow of the shoulder.
The inertia reels are fitted with an automatic
locking device which comes into operation in
the event of a collision, emergency braking
or if the vehicle rolls over. You can release
the device by pulling the strap firmly and
then releasing it so that it reels in slightly.Recommendations for children
Use a suitable child seat if the passenger is
less than 12 years old or shorter than one
and a half metres.
Never use the same seat belt to secure more
than one person.
Never allow a child to travel on your lap.
For more information on Child seats, refer
to the corresponding section.
In order to be effective, a seat belt must:
-
b
e tightened as close to the body as
possible,
-

b

e pulled in front of you with a smooth
movement, checking that it does not
twist,
-

b

e used to restrain only one person,
-

n

ot bear any trace of cuts or fraying,
-

n

ot be converted or modified to avoid
affecting its performance.
In the event of an impact
Depending on the nature and
seriousness of the impact , the
pretensioning device may be deployed
before and independently of the airbags.
Deployment of the pretensioners is
accompanied by a slight discharge of
harmless smoke and a noise, due to the
activation of the pyrotechnic cartridge
incorporated in the system.
In all cases, the airbag warning lamp comes
on.
Following an impact, have the seat belts
system checked, and if necessary replaced,
by a CITROËN dealer or a qualified
workshop.
In accordance with current safety
regulations, for all repairs on your vehicle's
seat belts, go to a qualified workshop with
the skills and equipment needed, which a
CITROËN dealer is able to provide.
Have your seat belts checked regularly by
a CITROËN dealer or a qualified workshop,
particularly if the straps show signs of
damage.
Clean the seat belt straps with soapy
water or a textile cleaning product, sold by
CITROËN dealers.
After folding or moving a seat or rear bench
seat, ensure that the seat belt is positioned
and reeled in correctly.
Advice
6
Safety