turn signal Citroen JUMPER 2013 2.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2013, Model line: JUMPER, Model: Citroen JUMPER 2013 2.GPages: 184, PDF Size: 4.62 MB
Page 26 of 184
24
Access
MAIN FUNCTIONS OF THE KEY
Type of key
Unlocking
the cabin
Locking the doors
Unlocking
the rear doors
Deadlocking
Key
Turn anti-clockwise
(driver's side).
Turn clockwise
(driver's side).
-
-
Remote control
-
-
Signalling
Direction indicators
2 flashes.
1 flash.
2 flashes.
3 flashes.
Lamp on
the control
Off.
On for about 3 seconds,
then flashing.
Flashing.
Flashing
Page 28 of 184
26
Access
While the alarm is monitoring, any intrusion
triggers the siren for approximately
30 seconds, accompanied by lighting of
the direction indicators.
The alarm then returns to monitoring mode
but the triggering event is stored and is
indicated by rapid flashing of the LED,
if the alarm is deactivated.
The alarm is also triggered following an
electrical supply cut-off, when the supply is
restored.
Automatic activation
Depending on the country in which the
vehicle is sold: this function activates
monitoring automatically approximately
2 minutes after the last door is closed. To
avoid triggering the alarm when opening a
door, the unlocking button on the remote
control must be pressed again.
Deactivation using the key
Unlock the doors using the key and enter the
vehicle. Switch on the ignition, identification
of the key code will switch off the alarm.
Deactivation using the remote control
When this button is pressed, the
alarm is deactivated when the
vehicle is unlocked.
Deactivation of the anti-tilt protection *
Press this control to deactivate
the protection (when towing the
vehicle with the alarm on, for
example).
The protection remains active until the doors
are unlocked with the central locking.
ALARM
If your vehicle is fitted with an ANTI-THEFT
ALARM.
This provides:
- exterior perimeter protection by
detectors on the openings (doors,
bonnet) and on the electrical power
supply,
- anti-tilt protection.
The system also includes a siren and an
LED which can be seen from outside,
indicating the three possible states of the
alarm:
- alarm activated (monitoring), slow
flashing of the red LED,
- alarm not activated (not monitoring),
LED off,
- alarm triggered (intrusion signal), rapid
flashing of the red LED when the vehicle
is unlocked.
Activation of the alarm
First ensure that all of the doors are closed
correctly.
The alarm is activated by
pressing this padlock, the
protection is active after a few
seconds.
*
Depending on engine.
Good practice
To deactivate the siren quickly following
unwanted triggering:
- switch on the ignition, identification of
the key code will switch off the alarm,
- press the unlocking button (cab and key)
on the remote control.
To avoid setting the alarm, when washing
the vehicle for example, lock the vehicle
using the key.
Unlocking the vehicle using the remote
control deactivates the siren automatically.