fold seats CITROEN NEMO DAG 2013 Handbook (in English)
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2013, Model line: NEMO DAG, Model: CITROEN NEMO DAG 2013Pages: 180, PDF Size: 9.06 MB
Page 40 of 180
38
Access
Good practice
When opening, take care not to obstruct the
guide space on the floor to allow the door to
slide correctly.
Do not block traffic.
Load space
Sliding side door (Combi)
Pull the handle A
towards the rear, slide the
door fully to engage the latch which holds
the door in the open position (Combi).
Side-hinged rear doors
To open, slide the control B
to the right. If your vehicle is parked on a slope,
guide the side door as it slides. The
door could open or close more quickly due
to the incline of the ground, risking injury.
As a safety precaution and to guarantee
correct operation, do not drive with the
sliding side door open. Press once to unlock the sliding
side doors and the rear doors
(Light van) from the driving
position.
Tailgate (Combi)
In the event of a battery or central
locking fault, the tailgate can be released
mechanically from inside the boot.
Open the sliding side door and fold the rear
seats fully.
From inside the boot, press the lever to
release the tailgate.
Page 99 of 180
97
4
EASE OF USE and COMFORT
Seats
RETRACTABLE PASSENGER SEAT
Table position
Press the head restraint to place it in
the lowest position.
Push one of the controls rearwards, located
on each side of the seat back.
Lower the seat back onto the seat cushion
to the table position.
Retracted position
After placing the seat back in the table
position, pull the seat's rear strap while
guiding the folded seat back forwards and
towards the floor.
Returning the seat to the sitting
position
Pull the seat's rear strap to unlock the seat.
Lift the seat from the front and the rear then
guide it forwards to bring it to the table position.
Push one of the controls rearwards, located on
each side of the seat back while pressing on
the seat back, then place the seat back in
the upright position.
Press on the seat back fi rmly to trigger the
locking of the seat on the fl oor.
Adjust the head restraint using the button on
the side. Only move the seat when the rear
seats are not occupied.
Page 100 of 180
98
Seats
ONE-PIECE REAR BENCH SEAT
Table position
Press the head restraint and its lug
simultaneously to place the head restraint in
the low position.
Unlock the seat back by pushing the two side
controls. The red indicator becomes visible.
Fold the seat back onto the seat cushion.
Fully folded position
After placing the seat back in the table
position, pull the central strap to unlock the
rear feet of the seat.
Lift the seat fully to secure it in the fully
folded position.
Removing the bench seat
After placing the bench seat in the fully
folded position, lower the transverse bar to
unlock the front feet of the seat.
Lift the bench seat to detach it from its front
anchorages.
When driving, to secure the bench,
detach the red retaining strap, located
on the back of the bench seat cushion, and
fix one end to a front head restraint spindle
and the other to the side of the seat cushion.
Page 101 of 180
99
4
EASE OF USE and COMFORT
Seats
Returning the bench seat to its
position
Put the bench seat in place in its front
anchorages in the fully folded position.
Fold the bench seat to the table position,
the front and rear feet of the seat lock
automatically.
Returning the bench seat to the sitting
position
Lift the bench seat back.
Take care not to trap the seat belts.
Lock the seat back by pushing it fully
towards the rear. The red indicator is no
longer visible.
Rear head restraints
The rear head restraints can be removed
and have two positions:
high, position for use,
low, storage position.
To raise or lower a head restraint, pull it
forwards sliding it at the same time.
To remove it, place it in the high position,
push the lug and pull it forwards and
upwards.
To refit it, engage the head restraint rods
in the holes taking care to remain in the
centreline of the seat back.
Never drive with the head restraints
removed, they must be in place and
correctly adjusted.
Page 102 of 180
100
Seats
SPLIT REAR BENCH SEAT
The left-hand side (2/3) or right-hand side
(1/3) of this bench seat can be folded to
adapt the load space in the boot.
Table position
Press the head restraint and its lug
simultaneously to place the head restraint in
the low position.
Unlock the seat back by pulling the
corresponding side control towards you. The
red indicator becomes visible.
Fold the corresponding seat back onto the
seat cushion.
Fully folded position
After placing the seat back in the table
position, pull the corresponding strap to
unlock the rear feet of the seat.
Lift the seat fully to secure it in the fully
folded position.
Removing the bench seat
After placing the bench seat in the fully
folded position, lower the corresponding
transverse bar to unlock the front feet of the
seat.
Lift the bench seat to detach it from its front
anchorages.
When driving, to secure the bench,
detach the red retaining strap, located
on the back of the bench seat cushion, and fi x
one end to a front head restraint spindle and
the other end to the side of the seat cushion.
Page 103 of 180
101
4
EASE OF USE and COMFORT
Seats
Returning the bench seat to its position
Put the bench seat in place in its front
anchorages in the fully folded position.
Fold the bench seat to the table position,
the front and rear feet of the seat lock
automatically.
Returning the bench seat to the sitting
position
Lift the bench seat back.
Take care not to trap the seat belts.
Lock the seat back by pushing it fully
towards the rear. The red indicator is no
longer visible.
Repeat all of these operations for the other
part of the rear bench seat.
Page 121 of 180
11 9
5
SAFETY
Seat belts
Good practice
The driver must ensure that all passengers
fasten their seat belts correctly.
Wherever you are seated in the vehicle,
always fasten your seat belt, even for short
journeys.
The seat belts are fitted with an inertia reel
which automatically adjusts the length of the
strap to your size. The seat belt is reeled in
automatically when not in use.
Ensure that the seat belt has reeled in
correctly after use.
After folding or moving a seat, ensure that
the seat belt has reeled in correctly into its
compartment and that the buckle is ready to
accommodate the tongue. The force limiter reduces the pressure of the
seat belt against the body of the occupants.
The equipment fitted to these seat belts is
operational when the ignition is switched on.
The inertia reels are fitted with a device
which automatically locks the strap in the
event of a collision or emergency braking or
if the vehicle rolls over.
The airbag warning lamp comes
on if the pretensioners are
deployed. Contact a CITROËN or
a qualified workshop.
Depending on the nature and seriousness of
any impact, the pretensioning device may be
deployed before and independently of infl ation
of the airbags. It instantly tightens the seat
belts against the body of the occupants.
The deployment of the pretensioners is
accompanied by a slight discharge of
harmless smoke and a noise, due to the
activation of the pyrotechnic cartridge
incorporated in the system. In order to be effective, a seat belt must:
- restrain one person only,
- must not be twisted, check by pulling in
front of you with an even movement,
- be tightened as close to the body as
possible.
The upper part of the seat belt should be
positioned in the hollow of the shoulder.
The lap part should be placed as low as
possible on the pelvis.
Do not invert the seat belt buckles as they
will not fulfil their role completely. If the
seats are fitted with armrests, the lap part of
the seat belt should always pass under the
armrest.
Check that the seat belt is fastened correctly
by pulling the strap firmly.
Recommendations for children:
- use a suitable child seat if the passenger
is less than 12 years old or less than one
and a half metres tall,
- never allow a child to travel on your lap,
even with the seat belt fastened.
For further information regarding child
seats, refer to the "Children on board"
section of chapter 5.
In accordance with current safety
regulations, for all work on your vehicle,
refer to a qualified workshop that has the
skills an equipment needed, all of which can
be provided by a CITROËN dealer.
Have the seat belts checked regularly (even
after a minor impact) by a CITROËN dealer
or a qualified workshop: they must not show
any signs of wear, cutting or fraying and they
must not be transformed or modified.
Clean the seat belt straps with soapy
water or a textile cleaning product,
available from CITROËN dealers.
Page 171 of 180
169
8
VISUAL SEARCH
Interior
Seat belts................................ 118-119
Airbags ...................................120-123
Deactivating the passenger's airbag ....122
Seats, adjustments .....................95-96
Tools, jack ...................................... 138
Folding seat ..................................... 97
Child seats ......................124-126, 128
12 V socket .................................... 106
Parking brake ................................ 113
Battery (+), charging,
starting .................................135-137
INTERIOR (LIGHT VAN)
Load space .............................108-109
●
stowing rings,
●
storage tray,
●
torch,
●
vertical partition.
Rear courtesy lamp ....................... 112
Accessories ............................133-134
Rear view mirror .............................. 46
Front courtesy lamp ....................... 112
Changing a courtesy
lamp bulb .................................... 145
Page 172 of 180
170
Interior
Front seat belts ....................... 118-119
Airbags ...................................120-123
Deactivating the passenger's airbag ....122
Front seats, adjustments ............95-96
12 V socket .................................... 106
Parking brake ................................ 113
Battery (+), charging,
starting .................................135-137
Rear view mirror .............................. 46
Front courtesy lamp ....................... 112
Changing a courtesy
lamp bulb .................................... 145
Bench rear seat ..........................98-99
Rear seat
belts .................................... 118-119
Child seats .............. 124-125, 127-128
ISOFIX mountings ..................129-130
Rear fi ttings ................................... 110
●
stowing rings,
●
luggage retaining net,
●
rear parcel shelf.
Rear courtesy lamp ....................... 112
Tools, jack,
temporary puncture
repair kit .......................138, 141-142
Accessories ............................133-134
INTERIOR (COMBI)
Folding seat ..................................... 97
Page 173 of 180
171
8
VISUAL SEARCH
Interior
Front seat belts ....................... 118-119
Airbags ...................................120-123
Deactivating the passenger's airbag .... 122
Front seats, adjustments ............95-96
12 V socket .................................... 106
Parking brake ................................ 113
Battery (+), charging,
starting .................................135-137
Rear view mirror .............................. 46
Front courtesy lamp ....................... 112
Changing a courtesy
lamp bulb .................................... 145
Rear bench seat .....................100-101
Rear seat
belts ..................................... 118-119
Child seats .............. 124-125, 127-128
ISOFIX mountings ..................129-130
Rear fi ttings ............................ 110-111
●
stowing rings,
●
luggage retaining net,
●
rear parcel shelf,
●
retaining straps,
●
torch.
INTERIOR (COMBI)
Folding seat ..................................... 97
Rear courtesy lamp ....................... 112
Boot lamp ...................................... 112
Tools, jack,
temporary puncture
repair kit .......................138, 141-142
Accessories ............................133-134