Nfv Citroen XSARA PICASSO 2004 1.G Owner's Guide

Downloaded from www.Manualslib.com manuals search engine 404
AXLES
SUSPENSION
STEERING
A > B =Negative figure: – = TOEOUT
A < B = Positive figure:+ =TOEIN
WARNING
AXLE GEOMETRY
Checks at reference height (the reference height of the vehicle is set as per the table below).
CRD Vehicle (CRD = Difficult road conditions)
Front axle Rear axle
Vehicle Tracking Castor Pivot angle Camber Tracking Camber
Adjustable Yes No
All types 1 ± 1 mm3,7 ± 1,3 mm
0°18’ at 0°0’2°56’ ± 18’ 10°25’ ± 30’ 0°07’ ± 30’
0°33’ ± 0°12’ 1°14’ ± 18’
XSARA PICASSO
B3CP02UC
Engines: NFV RFN RHY

Downloaded from www.Manualslib.com manuals search engine 409
AXLES
SUSPENSION
STEERING
Steering Rack pinion Number of teeth Number of steering Turning circle Turning circle
rack travel in rack wheel turns between walls between kerbs
Left hand drive
71,7 x 2
LH helix28 Teeth 3,22 12 m 11,48 m
Right hand driveRH helix
Engines Steering valve
NFV 6FZ RFN RHY
number of teeth :7
Length of the steering link rods (preadjustment):
Between balljoint centres =
392 mm.
Between the centre of the pivot balljoint and the contact face of the steering rack balljoint =
412 mm.
STEERING COLUMN SPECIFICATIONSXSARA PICASSO

Downloaded from www.Manualslib.com manuals search engine 452
BRAKESBRAKE SPECIFICATIONS
(*) ESP + Electronic Stability Program
XSARA PICASSO
Mercosur Europe
Without ESP (*)
2.0i 16V 2.0 HDi 1.6i 1.8i 16V 2.0i 16V 2.0 HDi
Engine type RFN RHY NFV 6FZ RFN RHY
Master cylinder
23,8
Master vac
Ø Master cylinder travel
254/34
FT mm
CaliperLUCASBOSCHpiston makesC54/54ZOH54/54
Disc Ventilated266
Disc thickness/min. thickness20,4/18,4 22/20
Makes/Brake pad gradeJURID/3724FERODO/769 (37)
Rear brake plates
Supplier/TypeLUCAS/ENERGIT/C52980
Ø Cylinder or caliper22,2
mm Drum/Ø maxi228,6/230
RR MakeABEX
Brake lining grade4930/2
Compensator/Supplier/TypeTEVESITTA (loadsensitive rear braking compensator)
Cutoff pressure in Bars20/61,6

Downloaded from www.Manualslib.com manuals search engine 485
SPECIAL FEATURES: AIR CONDITIONING SYSTEM (R 134.a)
Compressor (MANULLI seal)
«EUR OCLIM»
Tools.
Tool for removingrefitting air conditioning seals: FACOM ().1702
IMPERATIVE: Removingrefitting the MANULLI seal
(see corresponding operation).
MANULLI seal.
C2 C3 : All engineversions
XSARA
(Compressor and condenser end): 08/2000 #
XSARA PICASSO
(Compressor end):11/2002 #
Engineversions:
NFV : 10/12/2001
#
6FZ : 01/04/2002 #
RHY: 04/11/2002 #
Aircon compressor.
XSARA PICASSOengine versions:6FZ and RHY
Discontinuation
of compressor SD 6 V 12
Replaced
by compressor SD 7 V 16: 04/11/2002#
C2 C3 XSARA PICASSO
The drive plate (1)is held on the aircon compressor shaft by ribs.
New wiring
(2).
New seals
(3) (MANULLI).
Identification label
(4) for aircon compressor.
AIRCONC5HP18UD

Downloaded from www.Manualslib.com manuals search engine 505
AIRCON
AIR CONDITIONING SYSTEM R 134.a
Checks on the air conditioning circuit
C5HP18GD
Key.
T/P
= Average temperature(°C ) at the air vents/
high pressure(Bars).
P = Low pressure(Bars).
TE = Exterior temperature(C°).
HP = Pressure at compressor outlet(Bars).
BP = Pressure at compressor inlet(Bars).
TA = Average temperature(°C) of air blown from
the central vents.
C3 C3 PLURIEL NFV

Downloaded from www.Manualslib.com manuals search engine 515
AIRCON
(1)High pressure valve
(2)Low pressure valve
(3)High pressure clickfit union (tool 8005-T.C)
(4)Low pressure clickfit union (tool 8005-T.A)
(5)Pressostat.: 1,8 ± 0,6 m.daN
(6)
Filtering/drying cartridge plug
Tightening torques (m.daN).
(a) : 0,8.± 0,1
(b) : 0,5.± 0,1(c):1,4 ± 0,2
(d):2,5 ±0,25
XSARA PICASSO NFV AIR CONDITIONING SYSTEM R 134.a
C5HP13PP

Downloaded from www.Manualslib.com manuals search engine 517
AIRCON
XSARA PICASSO NFV 6FZ AIR CONDITIONING SYSTEM R 134.a
Checks on the air conditioning circuit
C5HP150D
Key.
T/P
= Scale of:
Temperature (°C ), average of air from the central vents.
Pressure High (Bars).
Pressure Low (Bars).
Te= Exterior temperature (°C).
HP= Pressure at compressor outlet (Bars).
Ta = Temperature (°C)of air blown from the vents.
BP= Pressure at compressor inlet (Bars).