Citroen XSARA PICASSO DAG 2005.5 1.G Owner's Guide
Manufacturer: CITROEN, Model Year: 2005.5, Model line: XSARA PICASSO DAG, Model: Citroen XSARA PICASSO DAG 2005.5 1.GPages: 151, PDF Size: 3.32 MB
Page 21 of 151
B
1
A
2
3
4
28
I
I N B R I E F
IS P E E D L I M I T E R / « L I M I T »
This driving assistance function allows you to choo se a maximum speed that you wish not to exceed. This has to be a speed greater than 30 km/h (approx. 20 mph).
Control A for the speed limiter is located below the lightin g/signalling Acontrol stalk.
Note: The information relating to the speed limiter is shown in zone B on the screen.
To select the function
Turn control 1 to the position « LIMIT ».
On selection of the function via control 1, the last speed memorised is displayed.
To adjust the maximum speed
Provided the engine is running, you adjust the memo rised speed by pressing :- button 4 to increase the memorised speed,- button 2 to decrease the memorised speed.Note: successive presses will modify the speed in steps of 1 km/h and a continuous press in steps of 5 km/h.
Activation of the maximum speedAs you see the desired maximum speed displayed, pre ss control 3 to activate 3the limitation.
The information « OFF » then disappears from zone B.
The trip mileage recorder is shown.
While the function is active, action on the accelerator pedal will not
permit the programmed speed to be exceeded, unless you press the
pedal hard down to go beyond the tight spot (see «Temporary override of the maximum speed»).
Note : the vehicle speed may vary slightly from that memor ised.
Page 22 of 151
29
I N B R I E F
IS P E E D L I M I T E R / « L I M I T »
To deactivate the maximum speed
Press button 3 at the end of the control 3A.
This action brings up the information « OFF » on the screen. This action does not cancel the memorised speed which remains displayed in zone B.
Temporary override of the maximum speed
It is possible at any time to drive at above the memorised maximum speed by pressing the pedal hard do wn to go beyond the tight spot.
All the time the speed is being exceeded, the displayed speed flashes.
You have only to release the accelerator pedal to r eturn below the limit speed, making the function ac tive again.
Note : if during speed limitation the system is unable to keep to the memorised speed (e.g. on a steep descen t or under heavy acceleration), then the speed fl ashes. Adapt your speed as necessary.
The function will reactivate when your speed is again below the desired limit speed.
To cancel the function
- By moving the control from position « LIMIT » to position 0.
- By stopping the engine. The speed chosen previously is memorised.
In the event of a malfunction, a message appears, accompanied by a sound signal.
Contact a CITROËN dealer.
A fl oor mat not approved by CITROËN may risk sliding forward under the accelerator pedal and preventing you from pressing beyond the tight spot. It will then be impossible to exit the speed limitation, except by actioning the control under the steering wheel.
The driver must remain attentive and keep complete control of the vehicle.