set clock DACIA SANDERO 2022 Owners Manual

Downloaded from www.Manualslib.com manuals search engine JauneNoir Noir texte
1.13
ENG_UD26927_1
Volant de direction/Heure (X52 - Dacia)
ENG_NU_993-5_X52_Dacia_1
Press and hold button 3 to enter the
hour setting mode.
When only the hours flash, press
button 3 briefly, to scroll through them.
Press and hold button 3 to enter the
minute setting mode.
When only the minutes flash, press
button 3 briefly, to scroll through them.
Confirm by pressing and holding
button 3.
STEERING WHEEL/CLOCK
Adjusting the steering wheel
Depending on the vehicle, the steering
wheel position is adjustable.
Pull lever 1 and move the steering
wheel to the required position.
Then push the lever to lock the steer-
ing wheel.
Make sure that the steering wheel is
correctly locked.
For safety reasons, carry
out any adjustments when
the vehicle is stationary.
Setting the time
Resetting the clock 2
Display the “Clock” display on the instru-
ment panel by pressing the button 3.
2
3
If the power supply is cut (battery
disconnected, supply wire cut, etc.),
the clock must be reset.For your safety, we recom-
mend that you do not adjust
the clock while driving.
1

Downloaded from www.Manualslib.com manuals search engine JauneNoir Noir texte
1.52
ENG_UD34537_4
Ordinateur de bord (X52 - Dacia)
ENG_NU_993-5_X52_Dacia_1
ON-BOARD COMPUTER (1/5)
Interpreting some of the
values displayed after
resetting
The values showing average fuel con-
sumption, range and average speed
will become more stable and reliable
the further you travel after pressing the
reset button.
For the first few miles after pressing the
reset key you will notice that the range
increases as you travel. This range
takes into account the average fuel con-
sumption since the last time the reset
button was pressed. Therefore, the fuel
consumption may decrease when:
– the vehicle stops accelerating;
– the engine reaches its operating
temperature (if the engine was cold
when the reset key was pressed);
– when driving from an urban area
onto the open road.
Resetting is automatic when the maxi-
mum capacity of any of the memories
is exceeded.
On-board computer 1
Display selection key 2
The display depends on the vehicle and
the country.
Scroll through the following information
by pressing the button 2:
a) Total mileage recorder
b) Trip mileage recorder
c) Fuel consumed
d) Average fuel consumption
e) Current fuel consumption
f) Estimated range
g) Distance travelled
h) Average speed
i) Oil change interval
j) Speed limiter
k) Clock
l) Exterior temperature
m) Reset the tyre pressure.
Refer to the table on the following
pages showing display examples.
Resetting the trip mileage
To reset the trip mileage recorder, the
display must show the Trip mileometer
function.
Press and hold button 2.
1
2