turn signal DACIA SUPERNOVA 2004 Repair Manual
[x] Cancel search | Manufacturer: DACIA, Model Year: 2004, Model line: SUPERNOVA, Model: DACIA SUPERNOVA 2004Pages: 933, PDF Size: 9.11 MB
Page 459 of 933

REAR AND INTERIOR LIGHTING
81
81 - 2
BULBS
Hugh/low beam lights Two phases bulb R2-12V-40/45 W
He adl a mp swith flange holder P45t41
Parking lights Bulb 12V-4W with holder BA 9s
Front turning lamp Bulb 12V-21W (colored) with holder BAU 15s
Fog lamps Halogen bulb H3, 12V-55W with holder Pk22s
Rear Parking, stop lights Bulb 12V-21/5W with holder BAY 15d
lamps Turning and reverse driving Bulb 12V-21W with holder BA15s
Rear fog lamps Bulb 12V-21W with holder BA 15s
Lamps: side signaling, trunk lighting Bulb 12V-5W with holder W2,1x9,5
License plate, ceiling, document compartment Bulb SOFIT 10 x 35 type AS02; 12 V-5W
lamps with holder Sv 8,5
Lamp STOP-S3 on the ceiling Bulb 12V-21W type C21W with holder Sv 8,5
Instrument panel Bulb 12V-1,2W holderW 2 x 4,6d BULBS
vnx.su
Page 471 of 933

82A
HORN - ENGINE IMMOBILISER
82A - 4
NOTE :
The vehicles equipped with this anti starting system, have a type of decoder, and those
provided also with RF remote control for locking/ unlocking doors have another type
of decoder.
The identification of the two types of E.C.U. de coder i s realised by the inscriptions on
the labels as fol lows: -code P8200032783H and the inscription TRANS-PLAF for the vehicles without
RF remote control ;
-code P82000 32776H and the inscription TRF-TRANS-CAR for the vehicles
with RF remote control.
ANTI STARTING INDICATOR
It is located on the instrument panel (picture 8, position A) and has the following functions: - signals the activation of the anti starting system
- signals the case of non identifying the key head
- signals the entrance in the operation mode “resynchronisation” of the remote controls,
RF with E.C.U. decoder, for the vehicles which use the RF remote control.
pict.7
pict.8
A
GENERALITIES
The dome ceiling lighting is activated subject to the position of the switch
(picture 7, position 1):
- position A the ceiling lights permanently
- position B the ceiling turned off
- position C dome ceiling lighting; this will light for 5 seconds after a front door closing or
after the command of unlocking the doors with the RF remote control. This delay turns out in the
moment of setting the contact.
vnx.su
Page 504 of 933

82A
HORN - ENGINE IMMOBILISER
82A - 37
A
LP8. TURNING LIGHTS DO NOT SWITCH ON AT THE BLOCKING /
UNLOCKING OF THE DOORS
RECOMMENDATION Check the absence of the failures with the CLIP tester.
If there are failures, fix them first.
Check if the synchronisatio n of the RF remote control and the E.C.U. decoder has been performed .
Are the turning lights functioning normally at the activation of the signalling switch ?
Check the continuity and the isolation related to
the ground and the +12 V of the electric layout:
E.C.U. decoder FLASH relay
Pin B3 pole 2
Is it correct?
Repair the signalli ng system.
Check t he fuse F03 and F04.
Fix the electric layout.
Check the fuse F15 ( up to 01.06.2001) or
F 07 (after 01.06.2001).
Is it good?Replace the fuse.
Disconnect the FLASH relay. Supply with
+ 12, the pole 4 of the relay. Are the l eft
turning lights turning on? Supply with +12 V
the pole 5 of the signal relay.
Are the right turning lights turning on?
Repair the electric layout from
poles 4 and 5 of the FLASH relay.
Replace the FLASH relay.
AFTER REPAIRING Perform a conformity checking.
Check the operation of the anti starting system.
No
No
No
Yes
Yes
Yes
Yes No
DIAGNOSTIC
vnx.su
Page 512 of 933

82B
HORN - ENGINE IMMOBILISER
82B - 45
Vo l u m etric protection checking.
Perform the following checking steps after locking using the RF remote control, the doors, the
engine hood and the hatchback. The operations must be performed in no more than 40 seconds
since the anti i ntrusion system has been activated with the RF remote control; if operating after
these 40 seconds, the siren will start and the turning lights will blink.
Close the door. The sound signal (buzzer)
will stop.
Th e pr oper operation of the anti intrusion system on different situations must be according to
those shown in Table 01. For detecting the causes of possible incidents of the anti intrusion system, perform the checking
steps presented in Table 02.
Lo wer the rear windows with about 10
cm. Close the doors, the engine hood
and the ha tchback.
Check out if there is any movement in
the cockpit.
Ac tivate the system pressing the button
of the RF remote control.
In troduce a hand through the window,
inside the cockpit and move it.
Th e LED indicator will blink quickly,
showing there has been a volumetric
detection and that volumetric sensors are
f unctioning correctly.
Deac tivate the system using the RF
remote contro l, then clos e al l the
vehicle windows.
Reactivate the system and then hit by
ha nd the windows surfa c e of the
vehicle. The LED indicator should
continue to normally blink and the siren
starting shall not occur.
Functional checking of the peripheral
protection.
Close the doors, the engine hood and the
hatchback.
Ac tivate the system pressing the button
of th e RF remote.
The doors will lock and the LED indicator
will blink.
Open a do or with the vehicle key.
The LED indicator will continuously be on,
a nd a sound signal (buzzer) will be heard.
Deac tivate and reactivate the sys tem
w ith the RF remote control.
Deac tivate t he system by pressing the
button of the RF remote control.
The do ors will unlock and t he LED
indicator will go off.
Rep eat a.m. operations for both front
door s, engine hood and hatchback.
FUNCTIONAL CHECKING OF THE SYSTEM
vnx.su
Page 534 of 933

84
CONTROLS - SIGNALLING
84-3
SI
GNALIZING AND LIGHTING CONTROL SWITCH
DISMOUNTING-REMOUNTING
The lighting control switch e quipping the SupeRNova vehicles includes also the turning-
signalizing switch .
NOTE
The lighting control switch is not to be repaired.
DISMOUNTING
Disconnect the battery.
Dismount the lower steering wheel casing.
Cut the plastic collar which is attaching the wiring on the steering column.
Disconnect the switch connector from the front wiring.
Dismount the switch attachment screw from the steering column.
Dismount the switch.
REMOUNTING
Tighten the switch attachment screws.
Connect the switch connector to the front wiring.
Position the plugs and fix with a new plastic collar.
Connect the battery.
Check the switch operation.
Mount the steering wheel lower casing.
UNDER WHEEL CONTROL MODULE
vnx.su
Page 538 of 933

84
CONTROLS - SIGNALLING
84-7
HAZARD SWITCH
Pos Destination1 Supply + after contact
2 Supply + permanently
3 Left turning
4R ight turning
5+ Parking lights
6 Mass
7 Hazard indicator
8T ur ning switch
9 Supply + turning relay
vnx.su
Page 564 of 933

89A
ELECTRICAL DIAGRAMS
89A - 12
(until 01.06.2001)
21
101
102
103
104
105
107
113
120
121
122
123
124
125
128
137
138
139
140
141
145
146
147
149
155
156
160
163
165
168
171
172
173
175
176
177
180
181
184
185
188
189
190Right signalling anti-return diode
Electric lighter
Ashtr a y
Alternator
Anti-theft system
Acoustic alarm
Battery
Windscreen wiper timer
Injection computer (UCE)
Fog lights switch
Fog headlights switch
Door closing switch
Climate blower switch
Hazard switch
Rear window defrosting switch
Turning signalling relay
Right rear door actuator
Left rear door actuator
Left front door actuator
Right front door actuator
Windscreen wiper-washer switch
Detona tion sensor
Atmospheric pressure sensor
RPM s
ensor
Reverse driving contact
Handbrake contact
St op contact
Starte r
Trunk lighting lamp
Documents compartment lighting lamp
AC compressor clutch
Right rear lamp
Left rear lamp
Left fog lamp
Right fog headlight
Left fog headlight
Left front door contact
Right front door contact
Right front parking lamp
Left front parking lamp
Cooling motor fan
Right rear loud speaker
Left rear loud speakerRight front brake pad
Left front brake pad
Windscreen washing pump
Va l ve potentiometer
Diagnostic socket
Right headlamp
Left headlamp
Fog lamps relay
Fog headlights control relay
Cooling motor fan control relay
Fuel pump control relay
Actuators relay
Injection water temperature sensor
Instrument panel
V ehicle speed transducer
Right front turning lamp
Left front turning lamp
Cockpit fuse and relays box
Radio
Cooling motor fan and AC
Right side signalling lamp
Left side signalling lamp
Injection air temperature sensor
Rear window defrosting timer
Climate control lighting
AC starting button
Motor fan resistance ( f or AC)
Left front ceiling lamp
Right front ceiling lamp
Canister purging valve
UCE anti-intrusion
Engine hood contact
Siren
Vo l u metric sensor
AC relay ( on board)
UCE decoder
Hatchback contact
AC compressor clutch control relay
Engine compartment fuse and relays box
Climate control blower
STOP-S3 l amp
St ep-by-step engine
Anti-starting bushing
216
217
221
222
225
226
227
230
231
234
236
238
244
247
250
255
256
260
261
262
267
268
272
294
298
319
321
328
329
371
427
438
442
454
474
503
560
584
597
600
639
649
654
CODE COMPONENT DENOMINATIONCODE COMPONENT DENOMINATION
ELECTRIC COMPONENTS INDEX
vnx.su
Page 570 of 933

89A
ELECTRICAL DIAGRAMS
89A - 18
( until 01.06.2001)
The cockpit fuse box is placed left side under dashboard, being attached on the interior side
of the door(1). To access the fuses, turn the knob (2), then open up the door towards exterior.
The fuses are protecting the following electric circuits:
FUSE
NUMB ER FUSE
TYPE PROTECTED C IRCUIT
Clock, radio, STOP contact, climate blower relay control
Reverse driving contact
UCE decoder, speed transducer, instrument panel supply, diagnostic
socket, AC starting button, UCE anti-intrusion
Hazard and turning signaling lights
Front/rear parking lights, lighting: switches, instrume nt panel, climate
control, documents compartment, lighter, ashtray, radio.
Lighter, clock, instrument panel ( anti-starting indic ator), front right
ceiling lamp, UCE anti-intrusion, anti-intrusion indicator, diagnostic socket.
Windscreen wiper-washing switch, windscreen wiper timer
Rear window defrosting
Climate blower
Left fo g lamp
F01
F02
F03
F04
F05
F06
F07
F08
F09
F10 15A
5A
15A
7,5A
5A
15A
15A
20A
15A
5A
1
2
COCKPIT FUSE BOX
vnx.su
Page 572 of 933

89A
ELECTRICAL DIAGRAMS
89A - 20
FUSE BOX ELECTRIC DIAGRAM
Connector C0
1. Fog lamp switch
♦
fog lamp relay control
2. Parking lights
♦
inlet fuse F 1
3. Outlet fuse F10
♦ left fog lamp
Connector C1
1. Outlet fuse F01
♦ climate blower relay control
2. Outlet F09
♦ climate bl ower
Connector C2
A1. Rear window defrosting switch
♦ rear window defrosting timer control
A 2. Mass
A 3. Outlet fuse F06
B1. Outlet fuse F09
♦ rear window defrosting
B2. Free
B3. Outlet fuse 07
♦ wi n d s c r e e n wiper-washing, siren
Connector C3
A 1. Lights switch ( + parking)
♦ inlet fuse F05
A 2. Outlet fuse F05
♦ + parking
A 3. Free
A 4. Free
B1. Mass
B2. Mass
B3. Turning lights switch ( signaling relay control )
B4. Free
COCKPIT FUSE BOX
vnx.su
Page 573 of 933

89A
ELECTRICAL DIAGRAMS
89A - 21
Connector C4
A1. Anti-theft mechanism ( position M)
♦ inlet fuse F03)
A 2. Outlet fuse F01
A3. Hazard switch
♦ inlet fuse F04, supply of the rear window defrosting timer
B1. Outlet fuse F03
B2. Anti-theft mechanism (position M)
♦ inlet fuse F02
B3. Outlet fuse F02
♦ reverse driving contact
I= DC ( after contact )
J= IC ( before contact)
R1 = fog lamp control relay
R2 = climate blower control relay
RT = rear window defrosting timer
RS = turning signaling relay. COCKPIT FUSE BOX
vnx.su