Horn DAEWOO MATIZ 2003 Service User Guide

DAEWOO M-150 BL2
SECTION 9C
HORNS
CAUTION: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in B unless otherwise
noted.
TABLE OF CONTENTS
Description and Operation 9C-2. . . . . . . . . . . . . . . . . .
Horn 9C-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Repair Instructions 9C-3. . . . . . . . . . . . . . . . . . . . . . . . .
On-Vehicle Service 9C-3. . . . . . . . . . . . . . . . . . . . . . . . . . Horn 9C-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Schematic and Routing Diagrams 9C-4. . . . . . . . . . .
Horn Wiring System 9C-4. . . . . . . . . . . . . . . . . . . . . . .

9C – 2 HORN
DAEWOO M-150 BL2
DESCRIPTION AND OPERATION
HORN
The horn is located under the hood. It is attached near
the radiator at the front of the vehicle. The horn is actu-ated by pressing the steering wheel pad, which grounds
the horn’s electrical circuit.

HORN 9C–3
DAEWOO M-150 BL2
REPAIR INSTRUCTIONS
ON–VEHICLE SERVICE
D19C501A
HORN
Removal Procedure
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle.
3. Remove the front wheels.
4. Remove the front wheel house splash shield.

Remove the clip and bolts.
a. Bolts and clips.

Remove the wheel house splash shield.
b. Splash shield.

D19D517A
5 Remove the horn.

Remove the bolt (1).

Disconnect the electrical connector (2).
D19D518A
Installation Procedure
1. Install the horn with the bolt.
2. Connect the electrical connector.
3. Install the front wheel house splash shield with the
clips and the bolts.
4. Install the front wheels.
5. Lower the vehicle.
6. Connect the negative battery cable.

9C –4 HORN
DAEWOO M-150 BL2
SCHEMATIC AND ROUTING DIAGRAMS
HORN WIRING SYSTEM
D19D207B