fuel DODGE CALIBER 2008 1.G Owner's Guide

Change Engine Oil
Refer to the “Maintenance Schedule” in Section 8 for
recommended engine oil change intervals.
Engine Oil Selection (Gasoline Engines)
For best performance and maximum protection for all
engines under all types of operating conditions, the
manufacturer recommends engine oils that are API Cer-
tified and meet the requirements of DaimlerChrysler
Material Standard MS-6395.
American Petroleum Institute (API) Engine Oil
Identification Symbol
This symbol means that the oil has
been certified by the American
Petroleum Institute (API). The
manufacturer only recommends
API Certified engine oils.
Engine Oil Viscosity (SAE Grade)
SAE 5W-20 engine oil is recommended for all operating
temperatures. This engine oil improves low temperature
starting and vehicle fuel economy. Your engine oil filler
cap also states the recommended engine oil viscosity
grade for your engine.
324 MAINTAINING YOUR VEHICLE

Drive Belt — Check Condition
Check the drive belt condition. Refer to the “Maintenance
Schedule” in Section 8 of this manual.
Inspect the drive belt for evidence of cuts, cracks, or
glazing and replace the belt for any sign of damage
which could result in belt failure.
The belt is self-tensioning and will not need adjustment.
Spark Plugs
Spark plugs must fire properly to assure engine perfor-
mance and emission control. New spark plugs should be
installed at the specified mileage. The entire set should be
replaced if there is any malfunction due to a faulty spark
plug. Refer to “Fluids, Lubricants, and Genuine Parts” in
Section 8 for spark plug information.
Catalytic Converter
The catalytic converter requires the use of unleaded fuel
only. Leaded gasoline will destroy the effectiveness of the
catalyst as an emission control device.
Under normal operating conditions, the catalytic con-
verter will not require maintenance. However, it is im-
portant to keep the engine properly tuned to assure
proper catalyst operation and prevent possible catalyst
damage.
326 MAINTAINING YOUR VEHICLE

To minimize the possibility of catalyst damage:
•Do not shut off the engine or interrupt the ignition
when the transaxle is in gear and the vehicle is in
motion.
•Do not try to start the engine by pushing or towing the
vehicle.
•Do not idle the engine with any spark plug wires
disconnected for a prolonged period.
Crankcase Emission Control System
Proper operation of this system depends on freedom
from sticking or plugging due to deposits. As vehicle
mileage builds up, the PCV valve and passages may
accumulate deposits. If a valve is not working properly,
replace it with a new valve.Do not attempt to clean the
old PCV valve.Check the ventilation hose for indication of damage or
plugging deposits. Replace if necessary.
Fuel Filter
A plugged fuel filter can cause hard starting or limit the
speed at which a vehicle can be driven. Should an
excessive amount of dirt accumulate in the fuel tank,
frequent fuel filter replacement may be necessary. The
fuel filters are located inside the fuel tank. See your
authorized dealer for service.
Air Cleaner Element (Filter)
Refer to “Maintenance Schedule” under Section 8.
328 MAINTAINING YOUR VEHICLE

•Do not change the thermostat for summer or winter
operation. If replacement is ever necessary, install
ONLY the correct type thermostat. Other designs may
result in unsatisfactory coolant performance, poor gas
mileage, and increased emissions.
Hoses And Vacuum/Vapor Harnesses
Inspect surfaces of hoses and nylon tubing for evidence
of heat and mechanical damage. Hard or soft spots,
brittle rubber, cracking, tears, cuts, abrasions, and exces-
sive swelling indicate deterioration of the rubber.
Pay particular attention to the hoses nearest to high heat
sources such as the exhaust manifold. Inspect hose rout-
ing to be sure hoses do not touch any heat source or
moving component that may cause heat damage or
mechanical wear.
Ensure nylon tubing in these areas has not melted or
collapsed.Inspect all hose connections such as clamps and cou-
plings, to make sure they are secure and no leaks are
present.
Components should be replaced immediately if there is
any evidence of degradation that could cause failure.Fuel System Connections
Electronic Fuel Injection high pressure fuel systems are
designed with tubes and special connects, connections
and clamps which have unique material characteristics to
provide adequate sealing and resist attack by deterio-
rated gasoline.
You are urged to use only the manufacturer’s-specified
tubes, connections and clamps, or their equivalent in
material and specification, in any fuel system servicing.
340 MAINTAINING YOUR VEHICLE

FLUIDS AND CAPACITIES
U.S. Metric
Fuel (Approximate)13.5 Gal 51.0 L
Engine Oil-With Filter
All Gasoline Engines (use API Certified SAE 5W-20 Engine Oil) 4.5 qts 4.26 L
Cooling System *
MoparAntifreeze/Coolant 5 Year/100,000 Miles Formula), or equivalent. 7.2 qts 6.8 L
* Includes heater and coolant recovery bottle filled to MAX level.
360 MAINTAINING YOUR VEHICLE

FLUIDS, LUBRICANTS, AND GENUINE PARTS
Engine
Component Fluids, Lubricants And Genuine Parts
Engine Coolant MoparAntifreeze/Coolant 5 Year/100,000 Mile Formula HOAT (Hybrid Or-
ganic Additive Technology) or equivalent.
Engine Oil Use API Certified SAE 5W-20 Engine Oil. Refer to your engine oil filler cap
for correct SAE grade meeting DaimlerChrysler Material Standard MS-6395.
Engine Oil Filter Mopar04884900AB or equivalent.
Spark Plugs ZFR5F-11 (Gap 0.043”)
Fuel Selection 87 Octane (R + M)/2
MAINTAINING YOUR VEHICLE 361
7

if it has been six months since your last oil change and
even if the oil change indicator message is NOT
illuminated.
•Change your engine oil more often if you drive your
vehicle off-road for an extended period of time.
•Under no circumstances should oil change intervals
exceed 6,000 mi (10 000 km) or six months, whichever
comes first.
Your authorized dealer will reset the oil change indicator
message after completing the scheduled oil change. If this
scheduled oil change is performed by someone other
than your authorized dealer, the message can be reset by
referring to the steps described under “Oil Change
Required” in “Use Factory Settings” of the EVIC section
in this manual or under “Odometer/Trip Odometer” in
the Instrument Cluster Descriptions section of this
manual.At Each Stop for Fuel
•Check the engine oil level about five minutes after a
fully warmed engine is shut off. Checking the oil level
while the vehicle is on level ground will improve the
accuracy of the oil level reading. Add oil only when
the level is at or below the ADD or MIN mark.
•Check the windshield washer solvent and add if
required.
Once a Month
•Check the tire pressure and look for unusual wear or
damage.
•Inspect the battery and clean and tighten the terminals
as required.
•Check the fluid levels of coolant reservoir, brake
master cylinder, power steering and transmission and
add as needed.
MAINTENANCE SCHEDULES 365
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

ABS (Anti-Lock Brake System).............. 247
Adding Engine Coolant (Antifreeze).......... 337
Adding Fuel........................... 284
Adding Washer Fluid..................124,153
Additives, Fuel......................... 283
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 328
Air Conditioner Maintenance............... 331
Air Conditioning Controls................. 219
Air Conditioning, Operating Tips............ 225
Air Conditioning Refrigerant.............331,332
Air Conditioning System................219,331
Air Pressure, Tires....................... 263
Airbag................................ 48
Airbag Deployment....................... 55
Airbag Light....................... 57,70,165
Airbag Maintenance....................... 57
Airbag, Side............................ 54
Airbag, Window (Side Curtain)............... 49
Alarm System (Security Alarm)............ 19,165Alignment and Balance................... 270
All Wheel Drive (AWD)................... 244
Alterations/Modifications, Vehicle............. 7
Antenna, Satellite Radio................... 216
Antifreeze (Engine Coolant)...........336,360,361
Capacities........................... 360
Disposal............................ 338
Anti-Lock Brake System (ABS)............128,247
Anti-Theft Security Alarm (Theft Alarm)........ 19
Appearance Care........................ 346
Assistance Towing........................ 93
Automatic Door Locks................... 28,29
Automatic Transaxle........... 13,233,235,304,343
Fluid Level Check...................... 344
Interlock System....................... 237
Overheating.......................... 304
Selection Of Lubricant................... 343
Shifting ............................. 237
Special Additives...................... 344
382 INDEX

Autostick............................. 239
BallJoints ............................. 332
Battery............................... 329
Keyless Transmitter Replacement (RKE)....... 25
Belts,Drive ............................ 326
Beverage Cooler........................ 154
Body Mechanism Lubrication............... 333
B-Pillar Location........................ 258
Brake Assist System...................... 130
Brake Fluid............................ 362
Brake, Parking.......................... 244
Brake System........................246,341
Anti-Lock (ABS).................128,129,247
Hoses.............................. 341
Master Cylinder....................... 342
Parking............................. 244
Warning Light........................ 172
Brakes.............................246,341Brake/Transmission Interlock............... 237
Break-In Recommendations, New Vehicle........ 69
Bulb Replacement....................... 355
Bulbs,Light ............................ 355
Calibration, Compass..................... 184
Capacities, Antifreeze (Engine Coolant)........ 360
Capacities, Fluid........................ 360
Caps, Filler
Fuel................................ 284
Oil (Engine).......................318,324
Car Washes............................ 347
Carbon Monoxide Warning................. 284
Cargo Area Cover....................... 149
Cargo Area Features...................... 147
Cargo Compartment
Light ............................... 147
Luggage Carrier....................... 153
CargoLight ............................ 147
INDEX 383
10

Brake Assist System.................... 130
Electronic Stability Program............... 131
Traction Control System................. 131
Electronic Speed Control (Cruise Control)...... 126
Electronic Stability Program (ESP)............ 131
Electronic Vehicle Information Center (EVIC).... 175
Emergency, In Case of
Jacking............................. 304
Jump Starting......................... 310
Towing ............................. 313
Emission Control System Maintenance......320,364
Engine............................. 69,318
Break-In Recommendations................ 69
Checking Oil Level..................... 322
Cooling ............................. 335
Exhaust Gas Caution.................... 284
Fuel Requirements..................... 281
Jump Starting......................... 310
Oil ...........................322,360,361Oil Change Interval.................... 324
Oil Filler Cap......................318,324
OilFilter ............................ 361
Oil Selection.......................... 324
Oil Synthetic......................... 325
Operation............................ 69
Overheating.......................... 302
Temperature Gauge..................... 164
Enhanced Accident Response Feature.......... 56
Event Data Recorder...................... 57
Exhaust Gas Caution.............. 35,69,284,334
Exhaust System......................... 334
Fabric Care............................ 348
Filler Location Fuel...................... 164
Filters
Air Cleaner.......................... 328
Engine Fuel.......................... 328
Engine Oil........................325,361
386 INDEX