remove seats DODGE CHALLENGER 2010 3.G User Guide

• Route the tether strap to provide the most direct path for the strap between the
anchor and the child seat.
• Attach the tether strap hook of the child restraint to the anchor and remove slack in the tether strap according to the child restraint manufacturer’s instructions.
FRONT SEATS
WARNING!
Adjusting a seat while the vehicle is movi ng is dangerous. The sudden movement of
the seat could cause you to lose control. The seat belt might not be properly adjusted,
and you could be injured. Only adjust a seat while the vehicle is parked.
Manual Seat Adjustment
Manual Front Seatback Recline
• Lean forward in the seat and lift the seatback release lever, then lean back to
the desired position and release the lever.
• Lift the lever to return the seatback to an upright position.
Lumbar Support
• Rotate the lumbar adjust lever forward to increase and rearward to decrease the
desired amount of lumbar support.
WARNING!
Do not ride with the seatback reclined so that the seat belt is no longer resting against
your chest. In a collision, you could slide under the seat belt and be seriously or even
fatally injured. Use the recliner only when the vehicle is parked.
13
GETTING STARTED

Passenger Forward/Rearward
• Lift up on the adjusting bar located at thefront of the seat near the floor and release
at the desired position.
Passenger Easy Entry Seats
• For easy access to the rear seat, pull upwardon the easy entry lever, located on the
passenger seatback; the seatback will
dump forward and the seat will slide
forward. You can also temporarily remove
the seat belt from the guide loop on the
seat and allow the seat belt to retract out of
the way.
Power Seats
• The power seat switches are located on theoutboard side of the front seat cushions.
• The seat swit ch, controls forward/backward
and up/down.
• The recline switch controls the angle of the seatback. Press the switch forward or
rearward and the seatback will move in
either direction.
CAUTION!
DO NOT place any article under a power seat or impede its ability to move as it may
cause damage to the seat controls. Seat travel may become limited if movement is
stopped by an obstruction in the seat's path.
GETTING STARTED
14