stop start DODGE CHALLENGER 2011 3.G Workshop Manual

3. Turn the ignition switch to the ON/RUN position.
4. Press and maintain firm pressure on the brake pedal.
5. Using a screwdriver or similar tool, press and hold the
override tab through the access port on the center con-
sole.6. Move the shift lever into the NEUTRAL position.
7. The vehicle may then be started in NEUTRAL.
8. Reinstall the shift lever override access cover.
With Keyless Enter-N-Go — If Equipped
If the engine is running, press the START/STOP button to
turn it off. Release the brake pedal and press the START/
STOP button once or twice to go to the ON/RUN
position. Do not start the engine. Then, follow the in-
structions shown above to activate the override.
TOWING A DISABLED VEHICLE
Without The Key Fob
Special care must be taken when the vehicle is towed
with the ignition in the OFF position. The only approved
method of towing without the ignition key is with a
flatbed truck. Proper towing equipment is necessary to
prevent damage to the vehicle.
Shift Lever Override Access Cover
376 WHAT TO DO IN EMERGENCIES

Under normal operating conditions, the catalytic con-
verter will not require maintenance. However, it is im-
portant to keep the engine properly tuned to assure
proper catalyst operation and prevent possible catalyst
damage.
NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may suggest severe
and abnormal catalyst overheating. If this occurs, stop
the vehicle, turn off the engine and allow it to cool.
Service, including a tune-up to manufacturer’s specifica-
tions, should be obtained immediately. To minimize the possibility of catalytic converter dam-
age:
•Do not shut off the engine or interrupt the ignition,
when the transmission is in gear and the vehicle is in
motion.
•Do not try to start the engine by pushing or towing the
vehicle.
•Do not idle the engine with any spark plug wires
disconnected or removed, such as when diagnostic
testing, or for prolonged periods during very rough
idle or malfunctioning operating conditions.
7
MAINTAINING YOUR VEHICLE 401

Intermittent Wipers (Delay Wipers)........... 146
Introduction ............................. 4
Jack Location ........................... 361
Jack Operation .......................... 364
Jacking Instructions ...................... 364
Jump Starting .......................... 370
Key-In Reminder ......................... 15
Key, Programming ........................ 17
Key, Replacement ........................ 17
Key, Sentry (Immobilizer) ................... 16
Keyless Enter-N-Go ................. 34,196,254
Keyless Entry System ...................... 21
Keyless Go .......................... 12,196
Keys ................................. 12
Kicker Sound System ..................... 234
Knee Bolster .......................... 55,56Lane Change and Turn Signals
.............. 143
Lap/Shoulder Belts ....................... 45
LATCH
(Lower Anchors and Tether for CHildren) .....73,75
Latches ................................ 84
Hood ............................. 138
Lead Free Gasoline ...................... 321
Leaks, Fluid ............................ 84
Life of Tires ............................ 307
Light Bulbs .......................... 84,426
Lights .............................. 84,139
Airbag .................... 63,64,68,82,178
Alarm ............................ 185
Anti-Lock ....................... 186,283
Automatic Headlights ................. 140
Brake Assist Warning .................. 290
Brake Warning .................... 183,281
Bulb Replacement ................. 426,427
Center Mounted Stop .................. 431
10
INDEX 475