clock DODGE CHALLENGER 2012 3.G User Guide

2. If equipped with aluminum wheels where the center
cap covers the lug nuts, use the lug wrench to pry the
center cap off carefully before raising the vehicle.
3. Before raising the vehicle, use the lug wrench to
loosen, but not remove, the lug nuts on the wheel with
the flat tire. Turn the lug nuts counterclockwise one turn
while the wheel is still on the ground.
4.
Place the jack underneath the lift area that is closest to
the flat tire. Turn the jack screw clockwise to firmly engage
the jack saddle with the lift area of the sill flange.
Front Jacking Location
370 WHAT TO DO IN EMERGENCIES

9. Lower the vehicle to the ground by turning the jack
handle counterclockwise.
10. Finish tightening the lug nuts. Push down on the
wrench while at the end of the handle for increased
leverage. Tighten the lug nuts in a star pattern until each
nut has been tightened twice. The correct tightness of
each lug nut is 110 ft/lb. (150 N·m). If in doubt about the
correct tightness, have them checked with a torque
wrench by your authorized dealer or at a service station.
11. Stow the jack, tools and flat tire. Make sure the base
of the jack faces the front of the vehicle before tightening
down the fastener.WARNING!
•A loose tire or jack thrown forward in a collision
or hard stop could endanger the occupants of the
vehicle. Always stow the jack parts and the spare
tire in the places provided.
•Have the deflated (flat) tire repaired or replaced
immediately.
Road Tire Installation
1. Mount the road tire on the axle.
2. Install the remaining lug nuts with the cone shaped
end of the nut toward the wheel. Lightly tighten the lug
nuts.6
WHAT TO DO IN EMERGENCIES 373

WARNING!
To avoid the risk of forcing the vehicle off the jack,
do not tighten the wheel nuts fully until the vehicle
has been lowered. Failure to follow this warning may
result in personal injury.
3. Lower the vehicle to the ground by turning the jack
handle counterclockwise.
4. Finish tightening the lug nuts. Push down on the
wrench while at the end of the handle for increased
leverage. Tighten the lug nuts in a star pattern until each
nut has been tightened twice. The correct tightness of
each lug nut is 110 ft/lbs (150 N·m). If in doubt about the
correct tightness, have them checked with a torque
wrench by your authorized dealer or service station. 5. After 25 miles (40 km) check the lug nut torque with a
torque wrench to ensure that all lug nuts are properly
seated against the wheel.
JUMP-STARTING PROCEDURES
If your vehicle has a discharged battery it can be jump-
started using a set of jumper cables and a battery in
another vehicle or by using a portable battery booster
pack. Jump-starting can be dangerous if done improperly
so please follow the procedures in this section carefully.
NOTE:
When using a portable battery booster pack
follow the manufacturer ’s operating instructions and
precautions.
374 WHAT TO DO IN EMERGENCIES

Front/Rear Side Marker Lamp
1. Remove the front/rear side marker. Use a fiber stick or
similar tool to gently pry the lamp on the outboard side
to disengage the clip.
NOTE:
•If a screwdriver is used, make sure a soft material is
placed between the vehicle body and tool so not to
scratch the paint.
2. Rotate the bulb’s socket counterclockwise, and remove
the bulb and socket assembly from the housing.
3. Pull the bulb out of the socket and insert the replace-
ment bulb.
4. Install the bulb and socket assembly into the housing,
and rotate the socket clockwise to lock it in place.
5. Reinstall the front/rear side marker.
Tail/Turn And Stop Lamp
1. Open the trunk.
2. Using a screwdriver, remove the tail lamp retainer.
3. Remove the fasteners from the back of the tail lamp
assembly.
434 MAINTAINING YOUR VEHICLE

4. Pull back the trunk liner.
5. Remove the remaining fasteners from the back of the
tail lamp assembly.
6. Pull the tail lamp assembly clear from the vehicle to
access the bulbs.7. Push the electrical connector locking tab to the side.
8. Disconnect the electrical connector.
9. Turn the appropriate bulb and socket assembly coun-
terclockwise to remove it from the tail lamp assembly.
10. Disconnect the bulb from the socket assembly and
install the replacement bulb.
7
MAINTAINING YOUR VEHICLE 435

11. Reinstall the bulb and socket assembly into the tail
lamp assembly, and then turn it clockwise.
12. Reinstall the tail lamp assembly, fasteners, electrical
connector, and trunk liner.
13. Reinstall tail lamp retainer.14. Close the trunk.
Center Tail/Backup Lamp
See your authorized dealer for bulb replacement.
Center High-Mounted Stop Lamp (CHMSL)
The CHMSL uses LED lamps that are not serviceable
separately. The CHMSL must be replaced as an assembly,
see your authorized dealer.
436 MAINTAINING YOUR VEHICLE

Brightness, Interior Lights.................. 144
Bulb Replacement ..................... 432,433
Bulbs, Light .......................... 82,432
Calibration, Compass ..................... 196
Capacities, Fluid ........................ 438
Caps, Filler Fuel .............................. 332
Oil (Engine) ........................ 396
Radiator (Coolant Pressure) ............. 411
Car Washes ............................ 419
Carbon Monoxide Warning ...............79,331
Cargo (Vehicle Loading) ................... 334
Cellular Phone ........................ 92,237
Center High Mounted Stop Light ............ 436
Certification Label ....................... 334
Chains, Tire ............................ 314
Changing A Flat Tire ..................... 365
Chart, Tire Sizing ........................ 297 Check Engine Light
(Malfunction Indicator Light)
............... 391
Checking Your Vehicle For Safety ............. 78
Checks, Safety ........................... 78
Child Restraint .................... 68,70,73,75
Child Restraint Tether Anchors .............72,73
Clean Air Gasoline ....................... 328
Cleaning Wheels ............................ 421
Windshield Wiper Blades ............... 404
Clock ............................. 204,213
Cold Weather Operation ................... 258
Compact Disc (CD) Maintenance ............. 237
Compact Spare Tire ...................... 309
Compass .............................. 195
Compass Calibration ..................... 196
Compass Variance ....................... 196
Computer, Trip/Travel .................... 191
472 INDEX

Reminder.......................... 180
Untwisting Procedure .................. 50
Seats ................................. 126
Adjustment ......................... 126
Head Restraints ...................... 132
Heated ............................ 129
Height Adjustment ................... 126
Power ............................ 126
Rear Folding ........................ 135
Seatback Release ..................... 135
Tilting ............................ 126
Security Alarm (Theft Alarm) ................ 18
Selection of Coolant (Antifreeze) ..........409,439
Selection of Oil ......................... 395
Sentry Key (Immobilizer) ................... 16
Sentry Key Programming ................... 18
Sentry Key Replacement ................... 17
Service Assistance ....................... 461 Service Contract
......................... 463
Service Engine Soon Light
(Malfunction Indicator) .................... 185
Service Manuals ........................ 465
Setting the Clock ..................... 204,213
Settings, Personal ........................ 198
Shift Indicator Light ...................... 263
Shift Lever Override ...................... 379
Shifting ............................... 265
Automatic Transmission ................ 265
Short Message Service (SMS) ................ 113
Shoulder Belts ........................... 45
Side Airbag ............................. 63
Side Window Demisters (Defrosters) .......... 244
Signals, Turn ...................... 82,142,178
Slippery Surfaces, Driving On ............... 277
Snow Chains (Tire Chains) ................. 314
Snow Tires ............................ 316
10
INDEX 485