oil viscosity DODGE CHALLENGER 2017 3.G Owners Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 2017, Model line: CHALLENGER, Model: DODGE CHALLENGER 2017 3.GPages: 506, PDF Size: 4.44 MB
Page 71 of 506

ENGINE BREAK-IN RECOMMENDATIONS
For vehicles equipped with the 3.6L or 5.7L use the
following engine break-in recommendations:
A long break-in period is not required for the drivetrain
(engine, transmission, clutch, and rear axle) in your new
vehicle.
Drive moderately during the first 300 miles (500 km). After
the initial 60 miles (100 km), speeds up to 50 or 55 mph (80
or 90 km/h) are desirable.
While cruising, brief full-throttle acceleration within the
limits of local traffic laws contributes to a good break-in.
However, wide-open throttle acceleration in low gear can
be detrimental and should be avoided.
The engine oil, transmission fluid, and axle lubricant
installed at the factory is high-quality and energy-
conserving. Oil, fluid, and lubricant changes should be
consistent with anticipated climate and conditions under
which vehicle operations will occur. For the recommended
viscosity and quality grades, refer to “Maintenance Proce-
dures” in “Maintaining Your Vehicle”.
CAUTION!
Never use Non-Detergent Oil or Straight Mineral Oil
in the engine or damage may result.
NOTE: A new engine may consume some oil during its
first few thousand miles (kilometers) of operation. This
should be considered a normal part of the break-in and not
interpreted as an indication of difficulty. Please check your
oil level with the engine oil indicator often during the
break in period. Add oil as required.
For vehicles equipped with the 6.4L use the following
engine break-in recommendations:
Despite modern technology and World Class manufactur-
ing methods, the moving parts of the vehicle must still
wear in with each other. This wearing in occurs mainly
during the first 500 miles (805 km) and continues through
the first oil change interval.2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 69
Page 421 of 506

Engine Oil Selection — 3.6L and 5.7L Engine
For best performance and maximum protection under all
types of operating conditions, the manufacturer only rec-
ommends engine oils that are API Certified and meet the
requirements of FCA Material Standard MS-6395.
Engine Oil Selection — 6.4L Engine
For best performance and maximum protection under all
types of operating conditions, the manufacturer only rec-
ommends full synthetic engine oils that meet the American
Petroleum Institute (API) categories of SN.
The manufacturer recommends the use of a full synthetic
SAE 0W-40 engine oil or equivalent meeting the require-
ments of FCA Material Standard MS-12633.
CAUTION!
Do not use chemical flushes in your engine oil as the
chemicals can damage your engine. Such damage is not
covered by the New Vehicle Limited Warranty.
American Petroleum Institute (API) Engine Oil
Identification Symbol
This symbol means that the oil has been
certified by the American Petroleum In-
stitute (API). The manufacturer only rec-
ommends API Certified engine oils.
This symbol certifies 0W-20, 5W-20, 0W-
30, 5W-30 and 10W-30 engine oils.
CAUTION!
Do not use chemical flushes in your engine oil as the
chemicals can damage your engine. Such damage is not
covered by the New Vehicle Limited Warranty.
Engine Oil Viscosity (SAE Grade) — 3.6L Engine
Mopar SAE 5W-20 engine oil approved to FCA Material
Standard MS-6395 such as Pennzoil, Shell Helix or equiva-
lent is recommended for all operating temperatures. This
engine oil improves low temperature starting and vehicle
fuel economy.
7
MAINTAINING YOUR VEHICLE 419
Page 422 of 506

The engine oil filler cap also shows the recommended
engine oil viscosity for your engine. For information on
engine oil filler cap location, refer to the “Engine Compart-
ment” illustration in this section.
NOTE:Mopar SAE 5W-30 engine oil approved to FCA
Material Standard MS-6395 such as Pennzoil, Shell Helix or
equivalent may be used when SAE 5W-20 engine oil
meeting MS-6395 is not available.
Lubricants which do not have both the engine oil certifi-
cation mark and the correct SAE viscosity grade number
should not be used.
Engine Oil Viscosity (SAE Grade) — 5.7L Engine
Mopar SAE 5W-20 engine oil approved to FCA Material
Standard MS-6395 such as Pennzoil, Shell Helix or equiva-
lent is recommended for all operating temperatures. This
engine oil improves low temperature starting and vehicle
fuel economy.
The engine oil filler cap also shows the recommended
engine oil viscosity for your engine. For information on
engine oil filler cap location, refer to the “Engine Compart-
ment” illustration in this section. NOTE:
Vehicles equipped with a 5.7L engine must use SAE
5W-20 oil. Failure to do so may result in improper opera-
tion of the Fuel Saver Technology. Refer to “Fuel Saver
Technology – If Equipped” in “Starting And Operating” for
further information.
Lubricants which do not have both the engine oil certifi-
cation mark and the correct SAE viscosity grade number
should not be used.
Engine Oil Viscosity — 6.4L Engine
Use Pennzoil Ultra 0W-40 engine or equivalent Mopar oil
meeting the FCA Material Standard MS-12633 for use in all
operating temperatures.
The engine oil filler cap also shows the recommended
engine oil viscosity for your engine. For information on
engine oil filler cap location, refer to “Engine Compart-
ment” in “Maintaining Your Vehicle” for further informa-
tion.
Materials Added To Engine Oil
The manufacturer strongly recommends against the addi-
tion of any additives (other than leak detection dyes) to the
engine oil. Engine oil is an engineered product and its
performance may be impaired by supplemental additives.
420 MAINTAINING YOUR VEHICLE
Page 424 of 506

3. Using a water and mild detergent clean the followinglocations.
— The water drain slot located at the front forward edge of
the shaker assembly.
— The seals attached to the scoop and air box.
— Lower water drains located in the lower shaker assem-
bly and air box as well as the hood interface areas for the
seals. Apply Mopar Leather, Rubber & Vinyl Protectant
after cleaning to seals.
4. Re-install shaker assembly.
Synthetic Engine Oils
You may use synthetic engine oils provided the recom-
mended oil quality requirements are met, and the recom-
mended maintenance intervals for oil and filter changes are
followed.
Synthetic engine oils which do not have both the engine oil
certification mark and the correct SAE viscosity grade
number should not be used.
Disposing Of Used Engine Oil And Oil Filters
Care should be taken in disposing of used engine oil and
oil filters from your vehicle. Used oil and oil filters,
indiscriminately discarded, can present a problem to the
environment. Contact your authorized dealer, service sta-
tion or governmental agency for advice on how and where
used oil and oil filters can be safely discarded in your area.
Engine Oil Filter
The engine oil filter should be replaced with a new filter at
every engine oil change.
Engine Oil Filter Selection
This manufacturer’s engines have a full-flow type oil filter.
Use a filter of this type for replacement. The quality of
replacement filters varies considerably. Only high quality
filters should be used to assure most efficient service.
Mopar engine oil filters are high quality oil filters and are
recommended.
Engine Air Cleaner Filter
Refer to the “Maintenance Schedule” for the proper main-
tenance intervals.
422 MAINTAINING YOUR VEHICLE
Page 492 of 506

Engine.............................. .412, 413
Air Cleaner ............................ .422
Block Heater ........................... .303
Break-In Recommendations ..................69
Checking Oil Level ....................417, 418
Compartment .....................411, 412, 413
Compartment Identification .................411
Coolant (Antifreeze) .............430, 462, 464, 465
Cooling .............................. .430
Exhaust Gas Caution ...................71, 368
Fails To Start ........................... .302
Flooded, Starting ........................ .302
Fuel Requirements ....................... .363
Jump Starting ....................399, 400, 401
Oil ..................417, 460, 461, 462, 464, 465
Oil Change Interval ...................... .418
Oil Filler Cap .......................... .420
Oil Filter .............................. .422
Oil Selection .....................419, 460, 461
Oil Synthetic ........................... .422
Overheating ........................... .382
Starting .............................. .299
Engine Oil Viscosity .....................419, 420
Engine Oil Viscosity Chart ....................419
Enhanced Accident Response Feature ..........52, 408Entry System, Illuminated
.....................16
Ethanol ................................. .365
Exhaust Gas Caution .....................71, 368
Exhaust System ........................ .71, 428
Exterior Folding Mirrors ......................85
Exterior Lighting .......................... .104
Exterior Lights .............................74
Filler Location Fuel ........................ .368
Filters Air Cleaner ............................ .422
Air Conditioning .....................278, 426
Engine Oil ...................422,
462, 464, 465
Engine Oil Disposal ...................... .422
Flashers ................................ .382
Hazard Warning ........................ .382
Turn Signal ...................... .74, 108, 194
Flash-To-Pass ............................ .109
Flooded Engine Starting ..................... .302
Fluid, Brake .................462, 463, 464, 465, 466
Fluid Capacities ....................... .460, 461
Fluid Leaks ...............................74
Fluid Level Checks Automatic Transmission ....................437
Brake ................................ .435
490 INDEX
Page 497 of 506

Vanity.................................86
Modifications/Alterations, Vehicle ................6
Monitor, Tire Pressure System ..................357
Mopar Parts .......................... .416, 483
MTBE/ETBE ............................. .365
Multi-Function Control Lever ..................108
New Vehicle Break-In Period ...................69
Occupant Restraints .........................32
Octane Rating, Gasoline (Fuel) .......363, 462, 464, 465
Oil Change Indicator, Reset ...................201
Oil, Engine .....................417, 462, 464, 465
Capacity .......................... .460, 461
Change Interval ........................ .418
Checking .......................... .417, 418
Dipstick ........................... .417, 418
Disposal .............................. .422
Filter ...................... .422, 462, 464, 465
Filter Disposal .......................... .422
Identification Logo ...................... .419
Materials Added To ...................... .420
Pressure Warning Light ....................179
Recommendation ..................419, 460, 461
Synthetic ............................. .422Viscosity
.....................419, 420, 460, 461
Oil Filter, Change ......................... .422
Oil Filter, Selection ......................... .422
Oil Pressure Light ......................... .179
Onboard Diagnostic System ...................414
Operating Precautions ...................... .414
Operator Manual (Owner’s Manual) ...............4
Outside Rearview Mirrors .....................84
Overhead Console ......................... .149
Overheating, Engine ....................... .382
Owner’s Manual (Operator Manual) ...........4,483
Paint Care ............................... .439
Panic Alarm ...............................18
Parking Brake ............................ .322
ParkSense
System, Rear ..................... .140
Passenger Seat Easy Entry ..............................98
Passing Light ............................ .109
Performance ............................. .203
Personalized Menu Bar ..................... .280
Pets .....................................68
Placard, Tire And Loading Information ........340, 341
Power Brakes ............................... .324
10
INDEX 495
Page 503 of 506

Uconnect 8.4/8.4 NAV Voice RecognitionRegister .............................. .288
SiriusXM Guardian ...................... .288
Uconnect Settings ...........................17
Customer Programmable Features .........222, 240
Passive Entry Programming ..............222, 240
Uconnect Settings .....................222, 240
Uconnect Voice Command ....................280
Uniform Tire Quality Grades ..................356
Unleaded Gasoline ........................ .363
Untwisting Procedure, Seat Belt .................39
Vanity Mirrors .............................86
Vehicle Certification Label ....................370
Vehicle Identification Number (VIN) ...............6
Vehicle Loading .....................341, 370, 371
Vehicle Modifications/Alterations .................6
Vehicle Security Alarm (Security Alarm) ...........14
Vehicle Storage ........................ .277, 455
Viscosity, Engine Oil .....................419, 420
Voice Recognition System (VR) .................280Warnings And Cautions
.......................4
Warranty Information ...................... .483
Washer Adding Fluid .......................... .428
Washers, Windshield ..................111,112,428
Washing Vehicle .......................... .439
Water Driving Through ........................ .319
Wheel And Wheel Trim ..................... .440
Wheel And Wheel Trim Care ..................440
Wind Buffeting ........................... .159
Window Fogging .......................... .277
Windows .................................29
Power .................................29
Windshield Defroster .........................72
Windshield Washers .....................111,112
Fluid ................................ .428
Windshield Wiper Blades .....................427
Windshield Wipers ..........................111
Wiper Blade Replacement .....................427
Wipers, Intermittent .........................
112
Wipers, Rain Sensitive ......................113
10
INDEX 501