battery DODGE CHALLENGER SRT 2011 3.G Service Manual

Quality Grading..................... 433
Radial ............................ 303
Replacement ........................ 306
Rotation ........................... 309
Safety .......................... 290,300
Sizes ............................. 292
Snow Tires ......................... 309
Spinning ........................... 304
Tread Wear Indicators ................. 304
To Open Hood .......................... 137
Towing ............................... 327
24-Hour Towing Assistance ............. 107
Disabled Vehicle ..................... 348
Recreational ........................ 327
Towing Assistance ....................... 107
Traction Control ......................... 283
Trailer Towing .......................... 327
Transmission ........................... 380
Automatic .................... 261,264,380Fluid
............................. 403
Manual ........................... 257
Shifting ......................... 259,261
Transmitter Battery Service
(Remote Keyless Entry) .................... 26
Transmitter Programming
(Remote Keyless Entry) .................... 21
Transmitter, Garage Door Opener (HomeLink®) . . 152
Transmitter, Remote Keyless Entry (RKE) ........ 21
Transporting Pets ........................ 79
Tread Wear Indicators .................... 304
Trip Odometer .......................... 174
Trunk Lid (Deck Lid) .................... 40,42
Trunk Release Remote Control ............... 40
Trunk Release, Emergency .................. 42
Turn Signals ......................... 142,176
UCI Connector ......................... 226
Uconnect™ (Hands-Free Phone) .............. 93
10
INDEX 453

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained personnel.
The following must be observed during installation.
The positive power connection should be made directly to
the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the roof
or the rear area of the vehicle. Care should be used in
mounting antennas with magnet bases. Magnets may affect
the accuracy or operation of the compass on vehicles so
equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.