hood release DODGE CHARGER 2006 6.G Owners Manual

CAUTION!
Do not place any article under the adjustable pedals
or impede its ability to move as it may cause damage
to the pedal controls. Pedal travel may become
limited if movement is stopped by an obstruction in
the adjustable pedal’s path.
TO OPEN AND CLOSE THE HOOD
Two latches must be released to open the hood. First, pull
the hood release lever located under the left side of the
instrument panel.
Next, move to the outside of the vehicle and push the
safety catch to the left. The safety catch is located under
the center front edge of the hood.
Hood Release Lever
96 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

After Starting
The idle speed will automatically decrease as the engine
warms up.
ENGINE BLOCK HEATER—IF EQUIPPED
The engine block heater warms engine coolant and
permits quicker starts in cold weather. Connect the cord
to a standard 110-115 volt AC electrical outlet with a
grounded, three-wire extension cord.
The engine block heater cord is routed under the hood on
the driver side of the vehicle. It has a removable cap that
is located on the driver side of the Integrated Power
Module.
WARNING!
Remember to disconnect the cord before driving.
Damage to the 110-115 volt electrical cord could
cause electrocution.
TRANSMISSION SHIFTING
4 Speed Automatic Transmission
Shifting from D (Drive) to P (Park) or R (Reverse) (or
from P or R to D) should be done only after the
accelerator pedal is released and the vehicle is stopped.
Be sure to keep your foot on the brake when moving the
shift lever between these gears.
Gear Selector
198 STARTING AND OPERATING

If necessary, add fluid to restore to the proper indicated
level. With a clean cloth, wipe any spilled fluid from all
surfaces. Refer to Fluids, Lubricants, and Genuine Parts
for correct fluid type.
Front & Rear Suspension Ball Joints
The suspension ball joints should be inspected for exter-
nal leakage or damage when other maintenance is per-
formed.
Steering Linkage
The tie rod end ball joints should be inspected for
external leakage or damage when other maintenance is
performed.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, doors, trunk and hood hinges, should be
lubricated periodically to assure quiet, easy operation
and to protect against rust and wear. Prior to the appli-
cation of any lubricant, the parts concerned should be
wiped clean to remove dust and grit; after lubricating
excess oil and grease should be removed. Particular
attention should also be given to hood latching compo-
nents to insure proper function. When performing otherunderhood services, the hood latch, release mechanism
and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the fall and spring. Apply a small
amount of a high quality lubricant such as MoparLock
Cylinder Lubricant or equivalent directly into the lock
cylinder.
Windshield Wiper Blades
The rubber edges of the wiper blades and the windshield
should be cleaned periodically with a sponge or soft cloth
and a mild nonabrasive cleaner. This will remove accu-
mulations of salt or road film.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
296 MAINTAINING YOUR VEHICLE

Passing............................. 103
Switch...........................99,100
Time Delay.......................... 102
Heated Seats........................... 92
Heater, Engine Block.................... 198
High Beam/Low Beam Select (Dimmer) Switch . 103
Hitches
Trailer Towing....................... 251
Holder, Cup........................... 125
HomeLink(Garage Door Opener) Transmitter . 115
Hood Release.......................... 96
Horn................................. 12
Hoses............................303,305
Ignition
Key ................................ 11
Illuminated Entry....................... 15
Immobilizer (Sentry Key).................. 12
Infant Restraint......................... 52
Information Center, Vehicle............... 142
Instrument Cluster...................134,135
Instrument Panel and Controls............. 132
Instrument Panel Lens Cleaning............ 310Interior Appearance Care................. 309
Interior Fuses.......................... 311
Interior Lights.......................... 98
Intermittent Wipers (Delay Wipers)......... 105
Introduction............................ 4
Jack Location.......................... 265
Jack Operation......................... 266
Jacking Instructions..................... 266
Jump Starting......................... 270
Key, Programming....................... 14
Key, Replacement....................... 14
Key, Sentry (Immobilizer).................. 12
Key-In Reminder........................ 12
Keyless Entry System..................... 21
Keys................................. 11
Knee Bolster........................... 38
Lap/Shoulder Belts...................... 32
LATCH
(Lower Anchors and Tether for CHildren)..... 55
Latch Plate............................ 33
INDEX 357
10