clock DODGE CHARGER 2009 6.G Owner's Manual

5. Raise the vehicle just enough to remove the flat tire
and install the spare tire.
WARNING!
Raising the vehicle higher than necessary can make
the vehicle less stable. It could slip off the jack and
hurt someone near it. Raise the vehicle only enough
to remove the tire.
6. Remove the lug nuts, wheel cover (if equipped), and
tire. Remove the cover by hand. Do not pry it off.
7. Mount the spare tire.
NOTE: For vehicles so equipped, do not attempt to
install a center cap or wheel cover on the compact spare.
However, when reinstalling the road tire, follow the
procedure under “Wheel Cover or Center Cap Installa-
tion” in place of the remaining steps in this procedure. 8. Install the lug nuts with the cone shaped end of the
nut toward the wheel. Lightly tighten the lug nuts. To
avoid the risk of forcing the vehicle off the jack, do not
tighten the lug nuts fully until the vehicle is lowered to
the ground.
9. Lower the vehicle to the ground by turning the jack
handle counterclockwise.
10. Finish tightening the lug nuts. Push down on the
wrench while tightening for increased leverage. Alternate
lug nuts until each nut has been tightened twice. The
correct tightness of each lug nut is 100 ft/lb. (135 N·m). If
in doubt about the correct tightness, have them checked
with a torque wrench by your authorized dealer or at a
service station.
11. Stow the jack, tools and flat tire. Make sure the base
of the jack faces the rear of the vehicle before tightening
down the fastener.
WHAT TO DO IN EMERGENCIES 365
6

snapping the cover over the two lug nuts. Do not use a
hammer or excessive force to install the cover.
4. Install the remaining lug nuts with the cone shaped
end of the nut toward the wheel. Lightly tighten the lug
nuts. To avoid the risk of forcing the vehicle off the jack,
do not tighten the lug nuts fully until the vehicle is
lowered to the ground.
5. Lower the vehicle to the ground by turning the jack
handle counterclockwise.
6. Finish tightening the lug nuts. Push down on the
wrench while tightening for increased leverage. Alternate
lug nuts until each nut has been tightened twice. The
correct tightness of each lug nut is 100 ft/lb. (135 N·m). If
in doubt about the correct tightness, have them checked
with a torque wrench by your authorized dealer or at a
service station.7. For vehicles equipped with center caps, install the
center cap by hand. Do not use a hammer or excessive
force to install the center cap.
8. Stow the jack, tools, and spare tire. Make sure the base
of the jack faces the rear of the vehicle before tightening
down the fastener.
WARNING!
A loose tire or jack thrown forward in a collision or
hard stop could endanger the occupants of the ve-
hicle. Always stow the jack parts and the spare tire in
the places provided.
368 WHAT TO DO IN EMERGENCIES

NOTE:For lighted switches, see your authorized dealer
for replacement instructions.
All of the interior bulbs are glass wedge base or glass
cartridge types. Aluminum base bulbs are not approved
and should not be used for replacement.
Exterior Bulb Number
Low Beam Headlight (Standard Halogen) ......9006
Low Beam Headlight – High Intensity
Discharge (HID) ......................... D1S
(Serviced at Authorized Dealer)
High Beam Headlight ..................... 9005
Front Park/Turn Light ................... 3157A
Front Fog Light — If Equipped ..........9145/H10
(Serviced at Authorized Dealer)
Front Side Marker ........................ 194
(Serviced at Authorized Dealer)
Tail/Stop Light ......................... 3057
Tail/Turn Light ......................... 3057Rear Side Marker
........................ 168
Backup Light ........................... 921
Center High-Mount Stop Light (CHMSL) ....... LED
(Serviced at Authorized Dealer)
License ................................ 168
BULB REPLACEMENT
Low Beam Headlight, High Beam Headlight,
Park/Turn Light, and Front Side Marker Light —
Models with Halogen Headlights
1. Open the hood.
NOTE: Removal of the air cleaner filter housing may be
necessary prior to replacing bulbs in the headlight assem-
bly on the driver side of the vehicle.
2. Twist the appropriate bulb and socket assembly coun-
terclockwise, and then pull it out of the headlight assem-
bly.
MAINTAINING YOUR VEHICLE 419
7

CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
3. Disconnect the bulb from the socket assembly and
install the replacement bulb.
4. Reinstall the bulb and socket assembly into the head-
light assembly, and then turn it clockwise.
1 — High Beam Headlight Bulb
2 — Low Beam Headlight Bulb
420 MAINTAINING YOUR VEHICLE

8. Turn the appropriate bulb and socket assembly coun-
terclockwise to remove it from the tail light assembly.
1 — Backup Light Bulb
2 — Side Marker Light Bulb
424 MAINTAINING YOUR VEHICLE

9. Disconnect the bulb from the socket assembly and
install the replacement bulb.
10. Reinstall the bulb and socket assembly into the tail
light assembly, and then turn it clockwise.
3 — Tail/Turn Light Bulb4 — Tail/Stop Light BulbMAINTAINING YOUR VEHICLE 4257

Climate Control......................... 253
Clock ........................ 199,213,216,226
Coin Holder ........................... 159
Compact Disc (CD) Maintenance ............. 252
Compact Spare Tire ...................... 313
Compass .............................. 190
Compass Calibration ..................... 191
Compass Variance ....................... 191
Computer, Trip/Travel .................... 187
Connector UCI ................................ 236
Universal Consumer Interface (UCI) ......... 236
Console, Floor .......................... 159
Console, Overhead ....................... 145
Contract, Service ........................ 453
Coolant Pressure Cap (Radiator Cap) .......... 400
Cooling System ......................... 397
Adding Coolant (Antifreeze) .............. 399
Coolant Capacity ...................... 427 Coolant Level
...................... 397,401
Disposal of Used Coolant ................ 400
Drain, Flush, and Refill .................. 398
Inspection ........................... 401
Points to Remember .................... 401
Pressure Cap ......................... 400
Radiator Cap ......................... 400
Selection of Coolant (Antifreeze) ......398,427,429
Corrosion Protection ..................... 406
Cruise Control (Speed Control) .............. 141
Cruise Light ........................... 172
Cupholders ......................... 158,410
Customer Assistance ..................... 451
Customer Programmable Features ............ 193
Data Recorder, Event ...................... 65
Daytime Brightness, Interior Lights ........... 136
Daytime Running Lights ................... 133
Dealer Service .......................... 385
INDEX 463
10

Pretensioners.......................... 49
Rear Seat ............................. 42
Reminder ............................ 176
Untwisting Procedure .................... 48
Seats ................................. 122
Adjustment .......................... 122
Head Restraints ....................... 126
Heated ............................. 127
Height Adjustment ..................... 124
Lumbar Support ....................... 126
Power .............................. 124
Rear Folding ......................... 128
Reclining ............................ 124
Seatback Release ....................... 128
Tilting .............................. 124
Security Alarm (Theft Alarm) ................ 18
Selection of Coolant (Antifreeze) ..........398,429
Selection of Oil ......................... 387
Self-Sealing Tires ........................ 318 Sentry Key (Immobilizer)
................... 15
Sentry Key Programming ................... 17
Sentry Key Replacement ................... 16
Service Assistance ....................... 451
Service Contract ......................... 453
Service Engine Soon Light
(Malfunction Indicator) .................... 183
Service Manuals ........................ 455
Setting the Clock ................ 199,213,216,226
Settings, Personal ........................ 193
Shifting ............................... 273
Automatic Transmission ............273,276,282
Shoulder Belt Upper Anchorage .............. 48
Shoulder Belts ........................... 42
Side Airbag ........................... 54,60
Side Curtain (Window Airbag) ............... 54
Signals, Turn ...................... 80,134,174
Sirius Backseat TV™ (uconnect studios) ........ 247
Slippery Surfaces, Driving On ............... 287
INDEX 475
10