homelink DODGE CHARGER 2010 7.G Owners Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 2010, Model line: CHARGER, Model: DODGE CHARGER 2010 7.GPages: 484, PDF Size: 11.72 MB
Page 86 of 484
▫Interior Lights ...................... 139
Windshield Wipers And Washers .......... 140
▫ Intermittent Wiper System .............. 140
▫ Windshield Washers .................. 141
▫ Mist Feature ........................ 141
▫ Headlights On With Wipers (Available With
Automatic Headlights Only) ............ 142
Tilt/Telescoping Steering Column .......... 142
Adjustable Pedals — If Equipped .......... 143
Electronic Speed Control ................ 144
▫ To Activate ......................... 145
▫ To Set At A Desired Speed .............. 146
▫ To Deactivate ....................... 146
▫ To Resume Speed .................... 146 ▫
To Vary The Speed Setting .............. 146
▫ To Accelerate For Passing .............. 147
Overhead Console ..................... 148
▫ Courtesy/Reading Lights .............. 148
▫ Sunglasses Storage ................... 149
Garage Door Opener — If Equipped ........ 149
▫ Programming HomeLink .............. 150
▫ Gate Operator/Canadian Programming .... 153
▫ Using HomeLink ................... 153
▫ Reprogramming A Single
HomeLink Button................... 154
▫ Security ........................... 154
▫ Troubleshooting Tips .................. 154
▫ General Information .................. 155
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 85
Page 149 of 484
WARNING!
Electronic Speed Control can be dangerous where the
system cannot maintain a constant speed. Your ve-
hicle could go too fast for the conditions and you
could lose control. An accident could be the result.
Do not use Electronic Speed Control in heavy traffic
or on roads that are winding, icy, snow-covered or
slippery.
OVERHEAD CONSOLE
The overhead console contains courtesy/reading lights
and storage for sunglasses. Universal Garage Door
Opener (HomeLink) buttons and power sunroof switch
may also be included, if equipped.
Courtesy/Reading Lights
At the forward end of the console are two courtesy/
reading lights.
Press the lens to turn on the light. Press it a second time
to turn off the light.
Overhead Console
148 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 150 of 484
These lights also turn on when a door is opened, when
the UNLOCK button on the Remote Keyless Entry (RKE)
transmitter is pressed, or when the dimmer control is
turned fully upward, past the second detent.
Sunglasses Storage
At the rear of the console, a compartment is provided for
the storage of a pair of sunglasses.
The storage compartment access is apush/pushdesign.
Push on the raised bar on the compartment door to open.
Push on the raised bar to close.
GARAGE DOOR OPENER — IF EQUIPPED
HomeLink replaces up to three remote controls (hand-
held transmitters) that operate devices such as garage
door openers, motorized gates, lighting or home security
systems. The HomeLink unit operates off your vehicle’s
battery. The HomeLink
buttons are located in the overhead
console, and contain one, two or three dots/lines desig-
nating the different HomeLink channels.
NOTE: HomeLink is disabled when the Vehicle Secu-
rity Alarm is active.
HomeLink Buttons
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 149
Page 151 of 484
WARNING!
•Your motorized door or gate will open and close
while you are training the Universal Transceiver.
Do not train the transceiver if people, pets, or
other objects are in the path of the door or gate.
Only use this transceiver with a garage door
opener that has a “stop and reverse” feature as
required by federal safety standards. This includes
most garage door opener models manufactured
after 1982. Do not use a garage door opener with-
out these safety features. Call toll-free 1–800–355–
3515 or, on the Internet at www.HomeLink.com for
safety information or assistance.
•Vehicle exhaust contains carbon monoxide, a dan-
gerous gas. Do not run your vehicle in the garage
while training the transceiver. Exhaust gas can
cause serious injury or death.
Programming HomeLink
Before You Begin
If you have not trained any of the HomeLinkbuttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for up
to 20 seconds. The EVIC will display “CLEARING
CHANNELS.” Release the buttons when the EVIC mes-
sage states “CHANNELS CLEARED.”
It is recommended that a new battery be placed in the
handheld transmitter of the device that is being copied to
HomeLink for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
while training.
1. Place the ignition in the RUN position.
150 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 152 of 484
2. Place the handheld transmitter 1 to 3 in (3 to 8 cm)
from the HomeLinkbuttons while keeping the EVIC
display in view.
For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink.
3. Simultaneously, press and hold both the chosen
HomeLink button and the handheld transmitter button
until the EVIC display changes from “CHANNEL #
TRAINING” to “CHANNEL # TRAINED.”
Then release both the HomeLink and handheld trans-
mitter buttons.
If the EVIC display states “DID NOT TRAIN” repeat
Step 3. If the signal is too weak, replace the battery in the
handheld transmitter.
It may take up to 30 seconds or longer in rare cases. The
garage door may open and close while you train. NOTE:
Some gate operators and garage door openers
may require you to replace Step 3 with procedures noted
in the “Gate Operator/Canadian Programming” section.
4. Press and hold the just-trained HomeLink button. If
the channel has been trained, the EVIC display will now
state “CHANNEL # TRANSMIT.”
If the EVIC display still states “CHANNEL # TRAIN-
ING” repeat Step 3.
NOTE: After training a HomeLink channel, if the
garage door does not operate with HomeLink and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading “Programming A Rolling Code System.”
5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 151
Page 153 of 484
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).6. Firmly press and release the LEARN or TRAINING
button. The name and color of the button may vary by
manufacturer.
NOTE:
You have 30 seconds in which to initiate the next
step after the LEARN button has been pressed.
7. Return to the vehicle and press the programmed
HomeLink button twice (holding the button for two
seconds each time). If the device is plugged in and
activates, programming is complete.
If the device does not activate, press the button a third
time (for two seconds) to complete the training.
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
1 — Garage Door Opener
2 — Training Button
152 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 154 of 484
Gate Operator/Canadian Programming
Canadian radio-frequency laws require transmitter sig-
nals to “time-out” (or quit) after several seconds of
transmission – which may not be long enough for
HomeLinkto pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to “time-out” in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3 with the following:
3. Continue to press and hold the HomeLink button,
while you press and release (“cycle”), your handheld
transmitter every two seconds until HomeLink hassuccessfully accepted the frequency signal. The EVIC
display will change from “CHANNEL # TRAINING” to
“CHANNEL # TRAINED.”
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under “Programming
HomeLink” earlier in this section.
Using HomeLink
To operate, press and release the programmed
HomeLink
button. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.,). The handheld transmitter of the device may also be
used at any time.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 153
Page 155 of 484
Reprogramming A Single HomeLinkButton
To reprogram a channel that has been previously trained,
follow these steps:
1. Place the ignition in the RUN position.
2. Press and hold the desired HomeLink button for
20 seconds until the EVIC display states “CHANNEL #
TRAINING.” Do not release the button.
3. Without releasing the button, proceed with Program-
ming HomeLink Step 2 and follow all remaining steps.
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the EVIC message states “CHANNELS
CLEARED.” Note that all channels will be erased. Indi-
vidual channels cannot be erased. The HomeLink
Universal Transceiver is disabled when
the Vehicle Security Alarm is active.
Troubleshooting Tips
If you are having trouble programming HomeLink , here
are some of the most common solutions:
•Replace the battery in the original transmitter.
•Press the LEARN button on the garage door opener to
complete the training for rolling code.
•Did you unplug the device for training, and remember
to plug it back in?
If you are having any problems or require assistance,
please call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
154 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 470 of 484
Methanol............................ 327
Octane Rating ...................... 326,428
Requirements ......................... 326
Saver Mode .......................... 190
Specifications ......................... 428
Tank Capacity ........................ 426
Fuel System Caution ..................... 331
Fueling ............................... 330
Fuses ................................ 409
Garage Door Opener (HomeLink) ........... 149
Gas Cap (Fuel Filler Cap) ...............330,376
Gasoline, Clean Air ...................... 327
Gasoline (Fuel) Conserving .......................... 190
Gasoline, Reformulated ................... 327
Gauges Coolant Temperature ................... 174
Fuel ............................... 173 Odometer
........................... 178
Speedometer ......................... 173
Tachometer .......................... 173
Gear Ranges ........................ 271,276
General Information ...............17,26,119,325
General Maintenance ..................... 379
Glass Cleaning .......................... 408
Gross Axle Weight Rating ...............334,336
Gross Vehicle Weight Rating .............334,335
GVWR ............................... 334
Hands-Free Phone (Uconnect™) .............. 91
Hazard Driving Through Flowing, Rising, or Shallow
Standing Water ........................ 283
Hazard Warning Flasher ................... 350
Head Restraints ......................... 128
Headlight Washers ....................... 390
Headlights ............................ 421
10
INDEX 469
Page 471 of 484
Automatic........................... 134
Bulb Replacement ...................... 418
Cleaning ............................ 407
Delay .............................. 135
High Beam/Low Beam Select Switch ........ 137
Lights On Reminder .................... 136
On With Wipers .................... 135,142
Passing ............................. 138
Switch .............................. 134
Time Delay .......................... 135
Washers ............................. 390
Heated Mirrors .......................... 90
Heated Seats ........................... 130
Heater ............................... 247
Heater, Engine Block ..................... 265
High Beam/Low Beam Select (Dimmer) Switch . . 137
Hitches Trailer Towing ........................ 338
Holder, Coin ........................... 162 Holder, Cup
........................... 161
HomeLink (Garage Door Opener) Transmitter . . . 149
Hood Release .......................... 132
Ignition ............................... 14
Key ............................... 12,14
Ignition Key Removal ..................... 14
Illuminated Entry ........................ 19
Immobilizer (Sentry Key) ................... 15
Infant Restraint ........................ 67,68
Information Center, Vehicle ................. 186
Inside Rearview Mirror .................... 87
Instrument Cluster .................... 171,173
Instrument Panel and Controls .............. 170
Instrument Panel Lens Cleaning ............. 408
Interior Appearance Care .................. 407
Interior Fuses .......................... 409
Interior Lights .......................... 139
Intermittent Wipers (Delay Wipers) ........... 140
470 INDEX