garage door opener DODGE CHARGER SRT 2018 Owners Manual

HOOD ................................86
▫ To Open The Hood ......................86
▫ To Close The Hood ......................87
 TRUNK ...............................87
▫ Opening .............................87
▫ Closing ..............................88
▫ Trunk Safety ...........................89
▫ Cargo Area Features .....................89
 GARAGE DOOR OPENER — IF EQUIPPED .....90
▫ Before You Begin Programming HomeLink .....91▫
Canadian/Gate Operator Programming ........94
▫ Using HomeLink ........................95
▫ Security ..............................95
▫ Troubleshooting Tips .....................96
▫ General Information ......................96
 INTERNAL EQUIPMENT ...................97
▫ Storage ...............................97
▫ Cupholders ...........................99
▫ Electrical Power Outlets ..................101
▫ Sunglasses Bin Door ....................104
16 GETTING TO KNOW YOUR VEHICLE

WARNING!
•Be certain that the seatback is securely locked into
position. If the seatback is not securely locked into
position, the seat will not provide the proper stabil-
ity for child seats and/or passengers. An improperly
latched seat could cause serious injury.
• The cargo area in the rear of the vehicle (with the rear
seatbacks in the locked-up or folded down position)
should not be used as a play area by children when
the vehicle is in motion. They could be seriously
injured in a collision. Children should be seated and
using the proper restraint system.
• To help protect against personal injury, passengers
should not be seated in the rear cargo area. The rear
cargo space is intended for load carrying purposes
only, not for passengers, who should sit in seats and
use seat belts.
The weight and position of cargo and passengers can
change the vehicle center of gravity and vehicle han-
dling. To avoid loss of control resulting in personal
injury, follow these guidelines for loading your vehicle:
•Always place cargo evenly on the cargo floor. Put
heavier objects as low and as far forward as possible.
(Continued)
WARNING! (Continued)
•Place as much cargo as possible in front of the rear
axle. Too much weight or improperly placed weight
over or behind the rear axle can cause the rear of the
vehicle to sway.
• Do not pile luggage or cargo higher than the top of
the seatback. This could impair visibility or become
a dangerous projectile in a sudden stop or collision.
GARAGE DOOR OPENER — IF EQUIPPED
HomeLink replaces up to three hand-held transmitters that
operate devices such as garage door openers, motorized
gates, lighting or home security systems. The HomeLink
unit is powered by your vehicle’s battery.
The HomeLink buttons, located on either the overhead
console, headliner or sunvisor, designate the three different
HomeLink channels. The HomeLink indicator is located
above the center button.
90 GETTING TO KNOW YOUR VEHICLE

NOTE:HomeLink is disabled when the Vehicle Security
Alarm is active.
Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming. For more efficient programming and accurate transmission
of the radio-frequency signal it is recommended that a new
battery be placed in the hand-held transmitter of the device
that is being programmed to the HomeLink system.
To erase the channels, place the ignition in the ON/RUN
position, and push and hold the two outside HomeLink
buttons (I and III) for up to 20 seconds or until the orange
indicator flashes.
NOTE:
•
Erasing all channels should only be performed when
programming HomeLink for the first time. Do not erase
channels when programming additional buttons.
• If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.Programming A Rolling Code
For programming garage door openers that were manufac-
tured after 1995. These garage door openers can be identi-
fied by the “LEARN” or “TRAIN” button located where
the hanging antenna is attached to the garage door opener.
Overhead Console HomeLink Buttons
3
GETTING TO KNOW YOUR VEHICLE 91

NOTE:It is NOT the button that is normally used to open
and close the door. The name and color of the button may
vary by manufacturer.
1. Place the ignition in the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink button you wish to program
while keeping the HomeLink indicator light in view. 3. Push and hold the HomeLink button you want to
program while you push and hold the hand-held trans-
mitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink indicator will flash slowly and
then rapidly after HomeLink has received the frequency
signal from the hand-held transmitter. Release both
buttons after the indicator light changes from slow to
rapid.
5. At the garage door opener motor (in the garage), locate the “LEARN” or “TRAINING” button. This can usually
be found where the hanging antenna wire is attached to
the garage door opener/device motor. Firmly push and
release the “LEARN” or “TRAINING” button. On some
garage door openers/devices there may be a light that
blinks when the garage door opener/device is in the
LEARN/TRAIN mode.
NOTE: You have 30 seconds in which to initiate the next
step after the LEARN button has been pushed.
6. Return to the vehicle and push the programmed HomeLink button twice (holding the button for two
seconds each time). If the garage door opener/device
activates, programming is complete.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button 92 GETTING TO KNOW YOUR VEHICLE

NOTE:If the garage door opener/device does not activate,
push the button a third time (for two seconds) to complete
the training.
To program the remaining two HomeLink buttons, repeat
each step for each remaining button. DO NOT erase the
channels.
Reprogramming A Single HomeLink Button (Rolling
Code)
To reprogram a channel that has been previously trained,
follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink button until the indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button proceed with “Program- ming A Rolling Code” step 2 and follow all remaining
steps.
Programming A Non-Rolling Code
For programming Garage Door Openers manufactured
before 1995.
1. Cycle the ignition to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)
away from the HomeLink button you wish to program
while keeping the HomeLink indicator light in view.
3. Press and hold the HomeLink button you want to program while you press and hold the hand-held trans-
mitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink indicator will flash slowly and
then rapidly after HomeLink has received the frequency
signal from the hand-held transmitter. Release both
buttons after the indicator light changes from slow to
rapid.
5. Press and hold the programmed HomeLink button and observe the indicator light.
• If the indicator light stays on constantly, programming
is complete and the garage door/device should acti-
vate when the HomeLink button is pressed.
• To program the two remaining HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
3
GETTING TO KNOW YOUR VEHICLE 93

NOTE:•If the indicator light stays on constantly, programming
is complete and the garage door/device should acti-
vate when the HomeLink button is pressed.
• To program the two remaining HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
If you unplugged the garage door opener/device for
programming, plug it back in at this time.
Reprogramming A Single HomeLink Button (Canadian/
Gate Operator)
To reprogram a channel that has been previously trained,
follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Press and hold the desired HomeLink button until the indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with “Canadian/ Gate Operator Programming” step 2 and follow all
remaining steps.Using HomeLink
To operate, push and release the programmed HomeLink
button. Activation will now occur for the programmed
device (i.e. garage door opener, gate operator, security
system, entry door lock, home/office lighting, etc.). The
hand-held transmitter of the device may also be used at
any time.
Security
It is advised to erase all channels before you sell or turn in
your vehicle.
To do this, push and hold the two outside buttons for 20
seconds until the orange indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
The HomeLink Universal Transceiver is disabled when the
Vehicle Security Alarm is active.
3
GETTING TO KNOW YOUR VEHICLE 95

Troubleshooting Tips
If you are having trouble programming HomeLink, here
are some of the most common solutions:
•Replace the battery in the Garage Door Opener hand-
held transmitter.
• Push the LEARN button on the Garage Door Opener to
complete the training for a Rolling Code.
• Did you unplug the device for programming and re-
member to plug it back in?
If you have any problems, or require assistance, please call
toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
WARNING!
• Vehicle exhaust contains carbon monoxide, a danger-
ous gas. Do not run your vehicle in the garage while
programming the transceiver. Exhaust gas can cause
serious injury or death.
• Your motorized door or gate will open and close
while you are programming the universal trans-
ceiver. Do not program the transceiver if people, pets
(Continued)
WARNING! (Continued)
or other objects are in the path of the door or gate.
Only use this transceiver with a garage door opener
that has a “stop and reverse” feature as required by
Federal safety standards. This includes most garage
door opener models manufactured after 1982. Do not
use a garage door opener without these safety fea-
tures. Call toll-free 1-800-355-3515 or, on the Internet
at HomeLink.com for safety information or assis-
tance.
General Information
The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Innovation, Science and Economic Development
Canada license-exempt RSS standard(s). Operation is sub-
ject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, in-
cluding interference that may cause undesired opera-
tion.
96 GETTING TO KNOW YOUR VEHICLE

Fold-Flat Seats.............................42
Folding Rear Seats ..........................50
Forward Collision Warning ....................153
Four-Way Hazard Flasher .....................280
Freeing A Stuck Vehicle ..................... .315
Fuel ................................... .379
Additives ............................. .380
Clean Air ............................. .380
Ethanol ...............................381
Gasoline ...............................379
Materials Added ........................ .380
Methanol ............................. .381
Octane Rating ........................379, 385
Requirements ........................379, 384
Specifications .......................... .385
Tank Capacity .......................... .384
Fuses .................................. .289
Garage Door Opener (HomeLink) ................90
Gasoline, Clean Air ........................ .380
Gasoline, Reformulated ..................... .380
Gear Ranges ............................. .222
Glass Cleaning ............................373
Gross Axle Weight Rating .....................274
Gross Vehicle Weight Rating ...................274 GVWR
................................. .274
Hazard Driving Through Flowing, Rising, Or Shallow Standing
Water .................................276
Hazard Warning Flashers .....................280
Headlights Automatic ..............................62
Cleaning ...............................370
High Beam/Low Beam Select Switch ...........61
Lights On Reminder .......................63
On With Wipers ..........................63
Passing ................................62
Switch .................................60
Time Delay ..............................63
Washers ...............................327
Head Restraints .......................51, 52,
53
Head Rests .......................... .51, 52, 53
Heated Mirrors .............................59
Heater, Engine Block ........................215
High Beam/Low Beam Select (Dimmer) Switch ......61
Hill Start Assist ............................143
Holder, Coin ...............................97
HomeLink (Garage Door Opener) ................90
Hood Prop ................................86
12
INDEX 477

Tire Service Kit...............301, 302, 304, 307, 308
To Open Hood .............................86
Towing ................................. .275
Behind A Motorhome ..................... .275
Recreational ............................275
Traction .................................276
Traction Control .......................... .145
Trailer Towing ............................ .275
Transfer Case Fluid .................................385
Transmission Automatic ..........................221, 345
Fluid ............................. .385, 387
Maintenance ............................345
Shifting ...............................219
Transporting Pets ..........................203
Tread Wear Indicators .......................360
Trunk Lid (Deck Lid) .........................87
Trunk Release Remote Control ..................87
Turn Signals ............................64, 129
Uconnect Uconnect Settings .................19, 20, 31, 393
Uconnect 4C/4C Nav With 8.4-Inch Display ........394Uconnect Settings
Customer Programmable Features ........31, 37, 393
Passive Entry Programming ..................37
Uniform Tire Quality Grades ..................368
Universal Garage Door Opener (HomeLink) ........90
Universal Transmitter ........................90
Unleaded Gasoline ........................ .379
Untwisting Procedure, Seat Belt ................169
USB....................................447
Vanity Mirrors .............................59
Vehicle Certification Label ....................274
Vehicle Identification Number (VIN) .............376
Vehicle Loading .....................274, 275, 353
Vehicle Modifications/Alterations .................5
Vehicle Security Alarm ........................33
Vehicle Storage ..........................78, 369
Viscosity, Engine Oil ....................... .330
V oice

Command .......................... .449
Voice Recognition System (VR) .................449
Warning Flashers, Hazard ....................280
Warning Lights (Instrument Cluster Descriptions) . . . .125
Warnings And Cautions .......................5
Warranty Information .......................469
12
INDEX 485