warning DODGE DAKOTA 2006 3.G Owners Manual

WARNING!
The warning words “DO NOT OPEN HOT” on the
coolant pressure cap are a safety precaution. Heat
causes pressure to build up in the cooling system. To
prevent scalding or injury, do not remove the pres-
sure cap when the system is hot or under pressure.
Coolant Level
The coolant bottle system provides a quick visual method
for determining that the coolant level is adequate. With
the engine idling, and warmed to normal operating
temperature, the level of the coolant on the overflow
bottle should be between the fluid level marks. Check
the coolant level whenever the hood is raised.
The radiator normally remains completely full, so there is
no need to remove the pressure cap except checking
coolant freeze point or replacement with new antifreeze coolant. Your service attendant should be advised of this.
When additional coolant is needed to maintain the
proper level, it should be added to the coolant bottle. Do
not overfill.
Points To Remember
A. Do not overfill the coolant bottle.
B. Check coolant freeze point in the radiator and in the
coolant bottle. If antifreeze needs to be added, contents of
coolant bottle also must be protected against freezing.
C. If frequent coolant additions are required, or if the
level in the coolant bottle does not drop when the engine
cools, the cooling system should be pressure tested for
leaks.
D. Maintain a minimum coolant concentration of 50%
ethylene glycol and distilled water.
324 MAINTAINING YOUR VEHICLE

PCV valve and passage with increasing mileage. Have
the PCV valve, hoses, and passages checked for proper
operation at the intervals specified. If the valve is
plugged or sticking, replace with a new valve – Do not
attempt to clean the oil PCV valve! Check ventilating
hose for indication of damage or plugging with deposits.
Replace if necessary.
Brake System
Power Disc Brakes (Front)
Disc brakes do not require adjustment; however, several
hard stops during the break-in period are recommended
to seat the linings and wear off any foreign material.
Brake Master Cylinders
The fluid level in the master cylinders should be checked
whenever the vehicle is serviced, or immediately if the
brake system warning light is on. If necessary, add fluid
to bring level to the full mark on the side of the reservoir
of the brake master cylinder. Be sure to clean the top of the master cylinder area before removing the cap. With
disc brakes, fluid level can be expected to fall as the brake
pads wear. Brake fluid level should be checked when
pads are replaced. If the brake fluid level is abnormally
low, check system for leaks.
Refer to Fluids, Lubricants and Genuine Parts for correct
fluid type.
WARNING!
Use of brake fluid that may have a lower initial
boiling point, or is unidentified as to specifications,
may result in sudden brake failure during hard
prolonged braking. You could have an accident.
326 MAINTAINING YOUR VEHICLE

WARNING!
Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts and the
brake fluid catching fire.
Use only brake fluid that has been in a tightly closed
container to avoid contamination from foreign matter or
moisture.
CAUTION!
Do not allow a petroleum-base fluid to contaminate
the brake fluid. Seal damage may result.
Brake Linings
Your vehicle is equipped with self-adjusting brakes.
During normal driving, a few brake applications while moving in reverse will maintain your brakes at the
specified adjustment. Adjustment will continue until the
brake linings are worn. To avoid brake failure, brake pull
or damage to the rotors or drums, inspect the brake
linings as specified in the maintenance schedule. If
excessively worn, the brake linings must be replaced.
Brake Hoses
Inspection should be performed whenever the brake
system is serviced or at intervals specified. Inspect hy-
draulic brake hoses for surface cracking, scuffing or worn
spots. If there is any evidence of cracking, scuffing, or
worn spots, the hose should be replaced immediately!
Eventual deterioration of the hose can take place with
possible burst failure.
MAINTAINING YOUR VEHICLE 327
7

WARNING!
Worn brake hoses can burst and cause brake failure.
You could have an accident. If you see any sign of
cracking, scuffing, or worn spots, have the brake
hoses replaced immediately.
Clutch Hydraulic System
The clutch hydraulic system is a sealed maintenance free
system. In the event of leakage or other malfunction, the
system must be replaced.
Manual Transmission
Fluid Level Check
This fluid should be checked whenever other underhood
services are performed. The fluid level is checked by
removing the fill plug. If the level of the lubricant is more
than 1/4 (6.35 mm) below the bottom of the filler hole
while the vehicle is level, enough lubricant should be added to bring the level to the bottom of the filler hole.
This fluid does not require periodic changing. However,
if it becomes necessary to add or replace the fluid in these
transmissions, refer to Fluids, Lubricants and Genuine
Parts for correct fluid type.
Automatic Transmission
Fluid Level Check
Check the fluid level while the transmission is at normal
operating temperature 180°F (82°C). This occurs after at
least 15 miles (24 km) of driving. At normal operating
temperature the fluid cannot be held comfortably be-
tween the fingertips.
To check the automatic transmission fluid level properly,
the following procedure must be used:
1. Operate the engine at idle speed and normal operating
temperature.
2. The vehicle must be on level ground.
328 MAINTAINING YOUR VEHICLE

•If you carry special cargo such as chemicals, fertilizers,
de-icer salt, etc., be sure that such materials are well
packaged and sealed.
•If a lot of driving is done on gravel roads, consider
mud or stone shields behind each wheel.
•Use Mopar touch up paint on scratches as soon as
possible. Your dealer has touch up paint to match the
color of your vehicle.
Interior Care
Use Mopar  Fabric Cleaner to clean fabric upholstery
and carpeting.
Use Mopar Vinyl Cleaner to clean vinyl upholstery and
trim.
Mopar  Total Clean is specifically recommended for
leather upholstery. Your leather upholstery can be best preserved by regular
cleaning with a damp soft cloth. Small particles of dirt
can act as an abrasive and damage the leather upholstery
and should be removed promptly with a damp cloth.
Stubborn soils can be removed easily with a soft cloth
and Mopar
Total Clean. Care should be taken to avoid
soaking your leather upholstery with any liquid. Please
do not use polishes, oils, cleaning fluids, solvents, deter-
gents, or ammonia based cleaners to clean your leather
upholstery. Application of a leather conditioner is not
required to maintain the original condition.
WARNING!
Do not use volatile solvents for cleaning purposes.
Many are potentially flammable, and if used in
closed areas they may cause respiratory harm.
MAINTAINING YOUR VEHICLE 335
7

WARNING!
You can be badly injured working on or around a
motor vehicle. Do only that service work for which
you have the knowledge and the right equipment. If
you have any doubt about your ability to perform a
service job, take your vehicle to a competent me-
chanic.
SCHEDULE “A” 379
8
M A I
N T
E
N A
N C E
S
C
H E
D
U L
E
S

on specified government test surfaces of asphalt and
concrete. A tire marked C may have poor traction perfor-
mance.
WARNING!
The traction grade assigned to this tire is based on
straight-ahead braking traction tests, and does not
include acceleration, cornering, hydroplaning, or
peak traction characteristics.
Temperature Grades
The temperature grades are A (the highest), B, and C,
representing the tire’s resistance to the generation of heat
and its ability to dissipate heat when tested under
controlled conditions on a specified indoor laboratory
test wheel. Sustained high temperature can cause the
material of the tire to degenerate and reduce tire life, and
excessive temperature can lead to sudden tire failure. The grade C corresponds to a level of performance which all
passenger car tires must meet under the Federal Motor
Vehicle Safety Standard No. 109. Grades B and A repre-
sent higher levels of performance on the laboratory test
wheel than the minimum required by law.
WARNING!
The temperature grade for this tire is established for
a tire that is properly inflated and not overloaded.
Excessive speed, underinflation, or excessive load-
ing, either separately or in combination, can cause
heat buildup and possible tire failure.
388 IF YOU NEED CONSUMER ASSISTANCE

Adding Fuel........................ 253,282
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 313
Air Conditioner Maintenance ............... 316
Air Conditioning ........................ 189
Air Conditioning, Operating Tips ..........189,192
Air Conditioning Refrigerant .............316,317
Air Conditioning System ................189,316
Air Filter .............................. 313
Air Pressure, Tires .................... 239,247
Airbag ........................... 40,54,158
Airbag Light ............................ 53
Airbag On/Off Switch ..................... 54
Alarm, Panic ............................ 23
Alarm (Security Alarm) .................26,154
Alignment and Balance ................... 246
Alterations/Modifications, Vehicle ............. 6
Antenna, Satellite Radio ................... 185
Antifreeze (Engine Coolant) ...........322,323,355
Anti-Lock Brake System (ABS) ............225,226 Anti-Lock Warning Light
.................. 155
Anti-Theft System ..................... 26,154
Appearance Care ........................ 333
Arming Theft System (Security Alarm) ......... 26
Auto Unlock, Doors ....................... 17
Automatic Dimming Mirror ................. 79
Automatic Door Locks ..................... 17
Automatic Transaxle ...................... 204
Automatic Transmission .............201,204,328
Adding Fluid ......................... 329
Fluid and Filter Changes ................. 330
Fluid Level Check ...................... 328
Fluid Type ........................ 330,357
Gear Ranges .......................... 204
Special Additives ...................... 330
Torque Converter ...................... 208
Axle Fluid ............................. 357
Axle Lubrication (Axle Fluid) ............... 331
390 INDEX

Ball Joints............................. 317
Battery ............................... 315
Charging ............................ 293
Emergency Starting ..................... 293
Gas Caution .......................... 293
Keyless Transmitter Replacement (RKE) ....... 25
Saving Feature (Protection) ............... 114
Belts, Drive ............................ 312
Belts, Seat .............................. 31
Body Mechanism Lubrication ............... 318
B-Pillar Location ........................ 234
Brake Fluid ............................ 357
Brake System ........................ 225,326
Anti-Lock (ABS) .................... 225,226
Disc Brakes .......................... 326
Fluid Check .......................... 326
Hoses .............................. 327
Master Cylinder ....................... 326
Parking ............................. 224 Warning Light
..................... 155,156
Brake/Transmission Interlock ............... 204
Break-In Recommendations, New Vehicle ........ 70
Bulb Replacement ....................... 342
Bulbs, Light ............................ 341
Calibration, Compass ..................... 129
Camper ............................... 145
Capacities, Fluid ........................ 355
Caps, Filler Oil (Engine) .......................... 310
Power Steering ........................ 317
Car Washes ............................ 333
Carbon Monoxide Warning ..............146,256
Cargo Light ............................ 117
Cargo (Vehicle Loading) ................... 258
Catalytic Converter .................... 256,313
CD (Compact Disc) Player ...............160,168
Cellular Phone ........................ 82,188
INDEX 391
10

Block Heater......................... 203
Break-In Recommendations ................ 70
Compartment ......................... 303
Coolant (Antifreeze) ................. 322,356
Cooling ............................. 320
Exhaust Gas Caution .................. 71,256
Fails to Start .......................... 202
Flooded, Starting ...................... 202
Fuel Requirements ..................... 355
Jump Starting ......................... 293
Oil ........................... 307,355,356
Oil Filler Cap ......................... 310
Oil Selection .......................... 355
Oil Synthetic ......................... 311
Overheating .......................... 323
Starting ............................. 201
Temperature Gauge ..................... 152
Entry System, Illuminated .................. 14
Equipment Identification Plate .............. 279 Ethylene Glycol Antifreeze
................. 322
Event Data Recorder ...................... 55
Exhaust Gas Caution ................71,256,320
Exhaust System ....................... 71,320
Extender, Seat Belt ........................ 39
Exterior Lighting ........................ 115
Filters Air Cleaner .......................... 313
Engine Fuel .......................... 313
Engine Oil ........................ 31 1,356
Engine Oil Disposal .................... 311
Flashers Hazard Warning ....................... 282
Turn Signal ..................... 1 17,152,348
Flat Tire Stowage ........................ 293
Flooded Engine Starting ................... 202
Floor Console .......................... 142
Fluid, Brake ........................... 357
394 INDEX