washer fluid DODGE DAKOTA 2007 3.G Owners Manual

after the washer knob is released. It will then resume the
intermittent interval previously selected. If the washer
knob is pushed, for a period greater than 1 second, while
in the OFF position, the wiper will wipe approximately
three wipes, after the wash knob is released.
To prevent freeze-up of your windshield washer system
in cold weather, select a solution or mixture that meets or
exceeds the temperature range of your climate. This
rating information can be found on most washer fluid
containers.
TILT STEERING COLUMN
To tilt the column, pull rearward on the lever below the
turn signal control and move the wheel up or down, as
desired. Push the lever forward to lock the column firmly
in place.Tilt Steering Column Lever
98 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Drive Shaft Constant Velocity Joints
All four wheel drive models are equipped with four
constant velocity joints. Periodic lubrication of these
joints is not required. However, the joint boot should be
inspected for external leakage or damage periodically. If
external leakage or damage is evident, the joint boot and
grease should be replaced immediately. Continued op-
eration could result in failure of the joint due to water
and dirt contamination of the grease. This would require
complete replacement of the joint assembly. Refer to the
Service Manual for the detailed replacement procedure.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, doors and hood hinges, should be lubricated
periodically to assure quiet, easy operation and to protect
against rust and wear. Prior to the application of any
lubricant, the parts concerned should be wiped clean to
remove dust and grit; after lubricating excess oil and
grease should be removed. Particular attention shouldalso be given to hood latching components to insure
proper function. When performing other underhood ser-
vices, the hood latch, release mechanism and safety catch
should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the fall and spring. Apply a small
amount of a high quality lubricant such as MoparLock
Cylinder Lubricant directly into the lock cylinder.
Windshield Wiper Blades
The rubber edges of the wiper blades and the windshield
should be cleaned periodically with a sponge or soft cloth
and a mild nonabrasive cleaner. This will remove accu-
mulations of salt or road film.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
MAINTAINING YOUR VEHICLE 307
7

Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
Windshield Washers
The fluid reservoir should be checked for fluid level at
regular intervals. When freezing weather is anticipated,
flush out the water in the reservoir by operating the
system. Fill the reservoir with windshield washer anti-
freeze (not radiator antifreeze), and operate the system
for a few seconds to flush out the residual water.
To prevent freeze-up of your windshield washer system
in cold weather, select a solution or mixture that meets or
exceeds the temperature range of your climate. This
rating information can be found on most washer fluid
containers.
WARNING!
Commercially available windshield washer solvents
are flammable. They could ignite and burn you. Care
must be exercised when filling or working around
the washer solution.
After the engine has warmed, operate the defroster for a
few minutes to reduce the possibility of smearing or
freezing the fluid on the cold windshield. MoparAll
Weather Windshield Washer Solution used with water as
directed on the container, aids cleaning action, reduces
freezing point to avoid line clogging, and is not harmful
to paint or trim.
308 MAINTAINING YOUR VEHICLE

At Each Stop for Fuel
•Check the engine oil level about 5 minutes after a fully
warmed engine is shut off. Checking the oil level while
the vehicle is on level ground will improve the accu-
racy of the oil level reading. Add oil only when the
level is at or below the ADD or MIN mark.
•Check the windshield washer solvent and add, if
required.
Once a Month
•Check tire pressure and look for unusual wear or
damage.
•Inspect the battery and clean and tighten the terminals
as required.
•Check the fluid levels of coolant reservoir, brake
master cylinder, and transmission and add as needed.
•Check all lights and all other electrical items for correct
operation.
At Each Oil Change
•Change the engine oil filter.
•Inspect the exhaust system.
•Inspect the brake hoses.
•Inspect the CV joints (if equipped) and front suspen-
sion components.
•Check the automatic transmission fluid level (if
equipped).
•Check the manual transmission fluid level (if
equipped).
•Check the coolant level, hoses, and clamps.
352 MAINTENANCE SCHEDULES
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Transaxle............................. 190
Automatic......................... 12,190
Manual.............................. 14
Operation........................... 190
Transfer Case........................... 321
Fluid ............................... 347
Transmission........................191,318
Automatic......................187,191,318
Filter ............................... 320
Fluid .........................318,320,347
Maintenance.......................... 318
Manual........................187,196,318
Shifting ............................. 197
Transmitter Battery Service (Remote Keyless Entry) . 25
Transmitter, Garage Door Opener (HomeLink)..110
Transmitter Programming (Remote Keyless Entry) . 23
Tread Wear Indicators.................... 232
Trip Computer.......................... 104
Trip Odometer.......................... 140Trip Odometer Reset Button................ 143
Turn Signals....................... 94,136,338
Uniform Tire Quality Grades................ 375
Universal Transmitter..................... 110
Unlock, Auto........................... 30
Vacuum/Vapor Harnesses................. 315
Variance, Compass....................... 108
Vehicle Identification Number (VIN)............ 6
Vehicle Loading......................223,247
Vehicle Modifications/Alterations.............. 7
Vehicle Storage......................... 332
Warning Lights (Instrument Cluster Description) . 136
Warnings and Cautions..................... 6
Warranty Information..................... 373
Washers, Windshield...................... 97
Washing Vehicle......................... 323
INDEX 393
10

Weight Load Carrying.................... 247
Wheel Alignment and Balance............... 234
Wheel and Wheel Trim.................... 325
Wheel and Wheel Trim Care................ 325
Wheel Changing........................ 273
Wheel Mounting........................ 278
Wheel Nut Torque....................... 281
Wind Buffeting.......................... 33
Window Fogging........................ 179
Windows.............................. 32
Power............................... 32Rear Sliding.......................... 124
Windshield Defroster..................... 177
Windshield Washers.................. 96,97,308
Fluid ............................. 96,308
Windshield Wiper Blades.................. 307
Windshield Wipers....................... 96
Wiper Blade Replacement.................. 307
Wipers, Intermittent....................... 97
Wrecker Towing......................... 286
YES EssentialsFabric Cleaning Procedure...... 325
394 INDEX