homelink DODGE DAKOTA 2010 3.G Owners Manual

Electronic Speed Control — If Equipped ..... 138
▫ To Activate ......................... 139
▫ To Set a Desired Speed ................ 139
▫ To Deactivate ....................... 139
▫ To Resume Speed .................... 139
▫ To Vary The Speed Setting .............. 139
▫ To Accelerate For Passing .............. 140
 Overhead Console ..................... 141
▫ Courtesy/Reading Lights .............. 142
 Compass/Temperature Mini-Trip Computer . . . 142
▫ US/M Button ....................... 142
▫ Reset Button ........................ 143
▫ Step Button ........................ 143 ▫
Average Fuel Economy (AVG ECO) ....... 144
▫ Distance To Empty (DTE) .............. 144
▫ Trip Odometer (ODO) ................. 145
▫ Elapsed Time (ET) ................... 145
▫ C/T Button ........................ 145
▫ Global Reset ........................ 146
▫ Compass/Temperature Display .......... 146
▫ Automatic Compass Calibration .......... 146
▫ Manual Compass Calibration ............ 146
▫ To Put Into a Calibration Mode .......... 147
▫ Outside Temperature .................. 148
 Garage Door Opener — If Equipped ........ 148
▫ Programming HomeLink .............. 149
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 81

▫Gate Operator/Canadian Programming .... 152
▫ Using HomeLink ................... 152
▫ Reprogramming A Single HomeLink
Button ............................ 153
▫ Security ........................... 153
▫ Troubleshooting Tips .................. 153
▫ General Information .................. 154
 Electrical Power Outlets ................. 154
 Cupholders .......................... 156
 Rear Crate ’N Go Storage — If Equipped .... 157
▫ Plastic Grocery Bag Retainers ............ 159
 Console Features — If Equipped ........... 159
▫ Floor Console Features ................ 159 
Cargo Area Features ................... 161
▫
Rear Cargo Area Utility Rails — If Equipped. . 161
 Rear Window Features .................. 162
▫ Rear Window Defroster — If Equipped ..... 162
▫ Sliding Rear Window — If Equipped ...... 163
 Slide-In Campers ...................... 164
▫ Camper Applications .................. 164
▫ General Information .................. 164
▫ Carbon Monoxide Warning-Vehicles
Equipped With A Cap Or Slide-In Campers . . 164
 Tailgate ............................ 165
▫ Tailgate Removal .................... 165
▫
Two–Position Tailgate/Upper Load Platform. . 166
82 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Outside Temperature
Because the ambient temperature sensor is located under
the hood, engine temperature can influence the displayed
temperature; therefore, temperature readings are slowly
updated when the vehicle speed is below 20 mph
(30 km/h) or during stop-and-go driving.
GARAGE DOOR OPENER — IF EQUIPPED
HomeLinkreplaces up to three remote controls (hand-
held transmitters) that operate devices such as garage
door openers, motorized gates, lighting or home security
systems. The HomeLink unit operates off of your vehi-
cle’s battery.
The HomeLink buttons are located in the overhead
console, and contain one, two or three dots/lines desig-
nating the different HomeLink channels.NOTE:
HomeLink is disabled when the Vehicle Theft
Alarm is active.
HomeLink Buttons
148 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!
•Your motorized door or gate will open and close
while you are training the Universal Transceiver.
Do not train the transceiver if people, pets or other
objects are in the path of the door or gate. Only use
this transceiver with a garage door opener that has
a “stop and reverse” feature as required by federal
safety standards. This includes most garage door
opener models manufactured after 1982. Do not
use a garage door opener without these safety
features. Call toll-free 1–800–355–3515 or, on the
Internet at www.HomeLink.com for safety infor-
mation or assistance.
•Vehicle exhaust contains carbon monoxide, a dan-
gerous gas. Do not run your vehicle in the garage
while training the transceiver. Exhaust gas can
cause serious injury or death.
Programming HomeLink
Before You Begin
The Compass Mini-Trip Computer (CMTC) illuminates
the HomeLinksymbol (a house with an arrow inside it)
along with 1, 2 or 3 indicators under it, when a
HomeLink button is pressed.
Pay attention to the indicator(s), as they will flash at
different rates, or remain solid during training.
If you have not trained any of the HomeLink buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for
20 seconds. Release the buttons when the indicators start
to flash.
It is recommended that a new batterybe placed in the
handheld transmitter of the device being copied to
HomeLink for more efficient training and accurate
transmission of the radio-frequency signal.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 149

Your vehicle should be parked outside of the garage
while training.
1. Turn the ignition switch to the ON/RUN position.
2. Place the handheld transmitter 1 to 3 inches (3 to 8 cm)
from the HomeLinkbuttons while keeping the
HomeLink display in view.
For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink.
3. Simultaneously, press and hold both the chosen
HomeLinkbutton and the handheld transmitter button
until the indicator(s) change from a slow to a rapid flash
rate.
Then release both the HomeLink and handheld trans-
mitter buttons.
It may take up to 30 seconds or longer in rare cases. The
garage door may open and close while you train. If the signal is too weak to train, replace the battery in the
handheld transmitter.
NOTE:
Some gate operators and garage door openers
may require you to replace Step 3 with procedures noted
in the “Gate Operator/Canadian Programming” section.
4. Press and hold the just-trained HomeLink button. If
the indicator(s) blink rapidly for two seconds and then
remains constant, continue with the next section: “Pro-
gramming A Rolling Code System”.
NOTE: After training a HomeLink channel, if the
garage door does not operate with HomeLink and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading, “Programming A Rolling Code System.”
5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.
150 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).6. Firmly press and release the LEARN or TRAINING
button. The name and color of the button may vary by
manufacturer.
NOTE:
You have 30 seconds in which to initiate the next
step after the LEARN button has been pressed.
7. Return to the vehicle and press the programmed
HomeLink button twice (holding the button for two
seconds each time). If the device is plugged in and
activates, programming is complete.
If the device does not activate, press the button a third
time (for two seconds) to complete the training.
If you are have any problems, or require assistance,
please call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
1 — Garage Door Opener
2 — Training Button
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 151

Gate Operator/Canadian Programming
Canadian radio-frequency laws require transmitter sig-
nals to “time-out” (or quit) after several seconds of
transmission – which may not be long enough for
HomeLinkto pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to “time-out” in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink,” Step 3, with the following:
3. Continue to press and hold the HomeLink button,
while you press and release (“cycle”), your handheld
transmitter every two seconds until HomeLink hassuccessfully accepted the frequency signal. The indica-
tor(s) will change from a slow flash to a rapid flash
when trained.
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under, “Programming
HomeLink,” earlier in this section.
Using HomeLink
To operate, press and release the programmed
HomeLink
button. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.,). The handheld transmitter of the device may also be
used at any time.
152 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Reprogramming A Single HomeLinkButton
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button for
20 seconds until the indicator(s) starts to flash. Do not
release the button.
3. Without releasing the button, proceed with Program-
ming HomeLink, Step #2, and follow all remaining
steps.
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the indicators begin to flash. Note that
all channels will be erased. Individual channels cannot be
erased. The HomeLink
Universal Transceiver is disabled when
the Vehicle Theft Alarm is active.
Troubleshooting Tips
If you are having trouble programming HomeLink , here
are some of the most common solutions:
•Replace the battery in the original transmitter.
•Press the LEARN button on the garage door opener to
complete the training for Rolling Code.
•Did you unplug the device for training and remember
to plug it back in?
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com, for information or assistance.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 153

Engine Oil........................... 359
Power Steering ........................ 268
Transfer Case ......................... 379
Fluids, Lubricants and Genuine Parts .......... 400
Fog Lights .......................... 132,399
Four Wheel Drive ....................... 258
Operation ........................... 258
Four-Way Hazard Flasher .................. 332
Freeing A Stuck Vehicle ................... 347
Front Axle (Differential) ................... 380
Fuel ................................. 298
Adding ............................. 307
Gauge .............................. 174
Octane Rating ...................... 298,400
Requirements ...................... 298,399
Tank Capacity ........................ 399
Fuel, Flexible ............. See Flexible Fuel Vehicles
Fueling ............................... 307
Fuses ................................ 385 Garage Door Opener (HomeLink) ........... 148
Gas Cap (Fuel Filler Cap)
............307,308,355
Gas Gauge (Fuel Gauge) ................... 174
Gasoline (Fuel) ......................... 298
Gasoline, Reformulated ................... 299
Gauges Coolant Temperature ................... 174
Fuel ............................... 174
Odometer ......................... 177,179
Speedometer ......................... 176
Tachometer .......................... 177
Gear Ranges ........................... 253
General Information ................... 1 15,298
Glass Cleaning .......................... 384
Grocery Bag Retainer ..................... 159
Gross Axle Weight Rating ...............310,312
Gross Cargo Weight ...................... 309
Gross Vehicle Weight Rating ................ 312
GVWR ............................... 309
10
INDEX 437

Hands-Free Phone (uconnect™).............. 86
Hazard Driving Through Flowing, Rising, or Shallow
Standing Water ........................ 265
Hazard Warning Flasher ................... 332
Headlights ............................ 391
High Beam .......................... 134
High Beam/Low Beam Select Switch ........ 134
Lights On Reminder .................... 132
Passing ............................. 134
Switch .............................. 131
Heated Seats ........................... 126
Heater, Engine Block ..................... 251
High Beam Indicator ..................... 175
High Beam/Low Beam Select (Dimmer) Switch . . 134
Hitches Trailer Towing ........................ 316
Holder, Cup ........................... 156
HomeLink (Garage Door Opener) Transmitter . . . 148 Hood Release
.......................... 127
Ignition Key ................................ 12
Illuminated Entry ........................ 20
Immobilizer (Sentry Key) ................... 16
Infant Restraint .......................... 61
Inside Rearview Mirror .................... 83
Instrument Cluster ....................... 174
Instrument Panel and Controls .............. 172
Instrument Panel Lens Cleaning ............. 384
Interior Appearance Care .................. 383
Interior Lights .......................... 129
Intermittent Wipers (Delay Wipers) ........... 135
Introduction ............................. 4
Jack Operation ....................... 333,337
Jacking Instructions ...................... 338
Jump Starting .......................... 343
438 INDEX