battery replacement DODGE DURANGO 1997 1.G Workshop Manual

DODGE DURANGO 1997 1.G Workshop Manual DURANGO 1997 1.G DODGE DODGE https://www.carmanualsonline.info/img/12/5703/w960_5703-0.png DODGE DURANGO 1997 1.G Workshop Manual

Page 14 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine filter runoff, and main bearing cap to cylinder
block mating surfaces.
(4) If no leaks are detected, pressurize the crank-
case as outlined in

Page 107 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (2) Position the cylinder head cover onto the gas-
ket. Tighten the bolts to 11 N´m (95 in. lbs.) torque.
(3) Install closed crankcase ventila

Page 115 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine After the distributor has been installed, its rota-
tional position must be set using theSET SYNC
mode of the DRB scan tool. Refer to Checking

Page 148 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine All gauge pressure indications should be equal,
with no more than 25% leakage.
FOR EXAMPLE:At 552 kPa (80 psi) input pres-
sure, a minimum of 4

Page 167 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (2) Disconnect closed ventilation system and evap-
oration control system from cylinder head cover.
(3) Remove the air inlet hose.
(4) Remove c

Page 175 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine CRANKSHAFT MAIN BEARINGS
REMOVAL
(1) Remove the oil pan.
(2) Remove the oil pump from the rear main bear-
ing cap.
(3) Identify bearing caps be