radiator DODGE DURANGO 1997 1.G Workshop Manual

DODGE DURANGO 1997 1.G Workshop Manual DURANGO 1997 1.G DODGE DODGE https://www.carmanualsonline.info/img/12/5703/w960_5703-0.png DODGE DURANGO 1997 1.G Workshop Manual

Page 12 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine Otherwise the indicated compression pressures may
not be valid for diagnosis purposes.
(1) Clean the spark plug recesses with compressed
air.
(

Page 13 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine CYLINDER COMBUSTION PRESSURE LEAKAGE DIAGNOSIS CHART
CONDITION POSSIBLE CAUSE CORRECTION
AIR ESCAPES THROUGH
THROTTLE BODYIntake valve bent, bu

Page 31 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine ENGINE ASSEMBLY
REMOVAL
NOTE: This procedure applies to both the 4X2 and
4X4 vehicles, steps that apply to the 4X4 vehicle
only, are identified

Page 33 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (2)4X4 vehiclesInstall locknuts onto the engine
mount brackets. Tighten locknuts to 41 N´m (30 ft.
lbs.).
(3) Remove jack from under the trans

Page 47 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine INSTALLATION
(1) Install hydraulic lash adjuster making sure
adjusters are at least partially full of oil. This can be
verified by little or no

Page 48 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (3) Using Special Tool 8512, press damper onto
crankshaft (Fig. 72).
(4) Install then tighten crankshaft damper bolt to
175 N´m (130 ft. lbs.)

Page 49 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (3) Install the A/C compressor and generator.
(4) Install crankshaft damper. Refer to procedure
in this section.
(5) Install accessory drive be

Page 55 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (24) Coat the large threaded access plug with
MopartThread Sealant with Teflon, then install
into the right cylinder head and tighten to 81 N´

Page 71 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (2) Remove accessory drive belt refer to Group 7,
Cooling System for procedure.
(3) Remove A/C compressor mouning fasteners and
set aside.(4) D

Page 72 of 193

DODGE DURANGO 1997 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine CAUTION: Special Tool 8512, is assembled in a
specific sequence. Failure to assemble this tool in
this sequence can result in tool failure and
Page:   1-10 11-20 next >