cooling system DODGE DURANGO 1998 1.G Workshop Manual

DODGE DURANGO 1998 1.G Workshop Manual DURANGO 1998 1.G DODGE DODGE https://www.carmanualsonline.info/img/12/5703/w960_5703-0.png DODGE DURANGO 1998 1.G Workshop Manual

Page 12 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine Otherwise the indicated compression pressures may
not be valid for diagnosis purposes.
(1) Clean the spark plug recesses with compressed
air.
(

Page 31 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine ENGINE ASSEMBLY
REMOVAL
NOTE: This procedure applies to both the 4X2 and
4X4 vehicles, steps that apply to the 4X4 vehicle
only, are identified

Page 34 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (20) Install both breathers. Connect tube to both
crankcase breathers (Fig. 44).
(21) Connect throttle and speed control cables.
(22) Install t

Page 35 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine INTAKE MANIFOLD
REMOVAL
(1) Disconnect negative cable from battery.
(2) Remove resonator assembly and air inlet hose.
(3) Disconnect throttle a

Page 36 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (10) Position and install heater hoses and tubes
onto intake manifold.
(11) Install the heater hoses to the heater core and
engine front cover.

Page 38 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (9) Install A/C compressor and fasteners.
(10) Install accessory drive belt.
(11) Install air cleaner assembly, resonator assem-
bly and air in

Page 40 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine CAUTION: DO NOT allow other components includ-
ing the wire harness to rest on or against the
engine cylinder head cover. Prolonged contact wit

Page 41 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (4) For rocker arm installation on cylinders 1 and
7 Rotate the crankshaft until cylinder #2 is at TDC
compression stroke.
(5) Using special to

Page 44 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (14) Install the crankshaft damper. Tighten
damper bolt 175 N´m (130 Ft. Lbs.).
(15) Install the power steering pump.
(16) Install the fan bla

Page 46 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (14) Install the crankshaft damper. Tighten
damper bolt 175 N´m (130 Ft. Lbs.).
(15) Install accessory drive belt.
(16) Install the fan shroud
Page:   1-10 11-20 21-30 31-40 41-50 ... 50 next >