battery DODGE DURANGO 2013 3.G Workshop Manual

Trailer Towing........................ .558
Tread Wear Indicators ...................517
Tire Safety Information .....................498
Tongue Weight/Trailer Weight ................555
Tow Hooks, Emergency .....................596
Towing ............................... .548
24-Hour Towing Assistance ................147
Disabled Vehicle ...................... .598
Guide .............................. .554
Recreational ......................... .563
Weight ............................. .554
Towing Assistance ........................ .147
Traction Control ......................... .487
Trailer Sway Control (TSC) ..................493
Trailer Towing .......................... .548
Cooling System Tips ....................562
Hitches ............................. .553
Minimum Requirements ..................556
Trailer and Tongue Weight ................555 Wiring
............................. .559
Trailer Towing Guide ...................... .554
Trailer Weight ........................... .554
Transfer Case ........................... .633
Electronically Shifted ....................469
Maintenance ......................... .633
Transmission Automatic ........................... .449
Maintenance ......................... .634
Shifting ............................. .447
Transmitter Battery Service (Remote Keyless Entry) . .27
Transmitter, Garage Door Opener (HomeLink ) . . . .262
Transmitter Programming (Remote Keyless Entry) . . .24
Transmitter, Remote Keyless Entry (RKE) .........24
Tread Wear Indicators ..................... .517
Turn Signals ............................ .315
UCI Connector .......................... .380
Uniform Tire Quality Grades .................675
694 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained personnel.
The following must be observed during installation.
The positive power connection should be made directly to
the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the roof
or the rear area of the vehicle. Care should be used in
mounting antennas with magnet bases. Magnets may affect
the accuracy or operation of the compass on vehicles so
equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.