bulb DODGE DURANGO 2014 3.G User Guide

“Understanding Your Instrument Panel” for further in-
formation. Tighten the fuel filler cap properly and press
the SELECT button to turn off the message. If the
problem continues, the message will appear the next time
the vehicle is started.
A loose, improperly installed, or damaged fuel filler cap
may also turn on the Malfunction Indicator Light (MIL).
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.For states that require an Inspection and Mainte-
nance (I/M), this check verifies the “Malfunction
Indicator Light (MIL)” is functioning and is not
on when the engine is running, and that the OBD II
system is ready for testing. Normally, the OBD II system will be ready. The OBD II
system may
notbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition actuated test, which
you can use prior to going to the test station. To check if
your vehicle’s OBD II system is ready, you must do the
following:
1. Cycle the ignition switch to the ON position, but do not crank or start the engine.
NOTE: If you crank or start the engine, you will have to
start this test over.
2. As soon as you cycle the ignition switch to the ON position, you will see the MIL symbol come on as part
of a normal bulb check.
564 MAINTAINING YOUR VEHICLE

REPLACEMENT BULBS
Interior Bulbs
Bulb Number
Glove Box Lamp 194
Grab Handle Lamp L002825W5W
Overhead Console Reading Lamps VT4976
Visor Vanity Lamp V26377
Rear Cargo Lamp 214–2
Underpanel Courtesy Lamps 906
Instrument Cluster (General Illumination) 103
Telltale/Hazard Lamp 74
Exterior Bulbs
Bulb Number
Low Beam/High Beam (Bi-Xenon) Headlamps D3S (Service at Authorized Dealer)
Low Beam/High Beam/Daytime Running Lamp (DRL) Bi-
Halogen Headlamps (Base) HIR2
612 MAINTAINING YOUR VEHICLE

Bulb Number
Low Beam/High Beam (Bi-Halogen) Headlamps (Uplevel) HIR2
Front Park/Turn Signal Lamps (Base) 3157NAK
Front Turn Signal Lamps (Uplevel & Premium) 3157NAK
Front Park Lamp/Daytime Running Lamp (Uplevel & Premium) LED (Serviced at Authorized Dealer)
Front Side Marker Lamps LED (Serviced at Authorized Dealer)
Front Fog Lamps H11
Rear Tail Lamps/Sidemarker Lamps LED (Serviced at Authorized Dealer)
Rear Stop/Turn Signal Lamps LED (Serviced at Authorized Dealer)
Rear Liftgate Tail Lamps LED (Serviced at Authorized Dealer)
Rear Backup Lamps 921 (W16W)
Rear License Lamps LED (Serviced at Authorized Dealer)
Center High-Mounted Stop Lamp (CHMSL) LED (Serviced at Authorized Dealer)
7
MAINTAINING YOUR VEHICLE 613

BULB REPLACEMENT
NOTE:Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
High Intensity Discharge Headlamps (Bi-Xenon)
— If Equipped
The headlamps are a type of high voltage discharge tube.
High voltage can remain in the circuit even with the
headlamp switch off. Because of this, you should not
attempt to service a headlamp bulb yourself. If a
headlamp bulb fails, take your vehicle to an authorized
dealer for service.
WARNING!
A transient high voltage occurs at the bulb sockets of
High Intensity Discharge (HID) headlamps when the
headlamp switch is turned ON. It may cause serious
electrical shock or electrocution if not serviced prop-
erly. See your authorized dealer for service.
NOTE: On vehicles equipped with High Intensity Dis-
charge (HID) headlamps, when the headlamps are
turned on, there is a blue hue to the lamps. This dimin-
ishes and becomes more white after approximately 10
seconds, as the system charges.
Bi-Halogen Headlamps — If Equipped
1. Turn the steering wheel to the left to replace the bulb from the right hand lamp, or to the right to replace the
bulb from the left hand lamp.
614 MAINTAINING YOUR VEHICLE

2. Turn the access cap located on the wheel liner coun-terclockwise to remove from liner.
3. Locate the headlamp bulb access cap through the opening in the wheel liner.
4. Firmly grasp the access cap and rotate counterclock- wise to remove lamp housing.
5. Firmly grasp the low/high beam bulb and connector assembly and rotate counterclockwise to remove from
housing.
6. Disconnect the electrical connector and then connect the replacement bulb.
7. Install the bulb and connector assembly into the headlamp housing and rotate clockwise to lock in
place.
8. Install the bulb access cap in the headlamp housing and rotate clockwise to lock it in place. 9. Install the access cap in the wheel liner and rotate
clockwise to lock it in place.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
Front Turn Signal
1. Open the hood.
2. Turn the turn signal bulb one–quarter turn counter-clockwise to remove from housing.
3. Disconnect the electrical connector and replace the bulb.
7
MAINTAINING YOUR VEHICLE 615

CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
Front Fog Lamps
1. Reach through the cutout in the splash shield androtate the bulb’s electrical connector one-quarter turn
counterclockwise and remove it from the fog lamp
housing.
2. Remove the bulb from the connector and install the replacement bulb.
3. Install the bulb and connector assembly into the fog lamp housing and rotate the connector one-quarter
turn clockwise to lock it in place.
CAUTION!
•Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If
the bulb comes in contact with any oily surface,
clean the bulb with rubbing alcohol.
• Always use the correct bulb size and type for
replacement. An incorrect bulb size or type may
overheat and cause damage to the lamp, the socket
or the lamp wiring.
616 MAINTAINING YOUR VEHICLE

Rear Tail, Stop And Turn Signal Lamps
The rear tail, stop, and turn signal lamps are LED. See
your authorized dealer for replacement.
Rear Liftgate Mounted Back-up Lamps
1. Raise the liftgate.
2. Use a fiber stick or flat blade screw driver to pry thelower trim from the liftgate.
3. Back-up lamps are now visible. Rotate socket(s) coun- ter clockwise.
4. Remove/replace bulb(s).
5. Reinstall the socket(s)
6. Reverse process to reinstall the liftgate trim.
Center High-Mounted Stop Lamp (CHMSL)
The center high-mounted stop lamp is an LED assembly.
See your authorized dealer for replacement.
Rear License Lamp
The rear license lamps are LED. See your authorized
dealer for replacement.
7
MAINTAINING YOUR VEHICLE 617

Fluid and Filter Changes..................595
Fluid Change ......................... .595
Fluid Level Check ...................... .594
Fluid Type ........................... .594
Gear Ranges .......................... .416
Special Additives ...................... .594
Auxiliary Electrical Outlet (Power Outlet) ........256
Auxiliary Power Outlet .....................256
Battery ................................ .305
Charging ............................ .305
Keyless Transmitter Replacement (RKE) ........26
Belts, Seat ...............................54
Blind Spot Monitoring ..................... .136
Body Mechanism Lubrication .................578
B-Pillar Location ......................... .460
Brake Assist System ...................... .444
Brake Control System, Electronic ..............442
Brake Fluid ............................ .590Brake System
........................... .590
Anti-Lock (ABS) ....................... .443
Fluid Check .......................... .590
Master Cylinder ....................... .590
Parking ............................. .439
Warning Light ........................ .295
Brake/Transmission Interlock .................414
Bulb Replacement ........................ .612
Bulbs, Light .............................118
Camera, Rear ........................... .239
Capacities, Fluid ......................... .618
Caps, Filler Fuel ................................ .544
Oil (Engine) .......................... .569
Power Steering ........................ .438
Radiator (Coolant Pressure) ................587
Carbon Monoxide Warning ..................115
Cargo Area Cover ........................ .273
10
INDEX 643

GVWR................................ .499
Hazard Warning Flasher ....................526
Headlights ............................. .614
Automatic ........................... .176
Bulb Replacement ...................... .614
Cleaning ............................ .600
On With Wipers ....................... .176
Passing ............................. .185
Replacing ............................ .614
Heated Mirrors .......................... .134
Heater, Engine Block .......................411
High Beam Indicator ...................... .292
Hill Start Assist .......................... .449
Hitches Trailer Towing ........................ .505
Holder, Cup ............................ .263
HomeLink® (Garage Door Opener) ............244Hood Release
........................... .173
Ignition Key..................................14
Illuminated Entry ..........................23
Immobilizer (Sentry Key) ....................17
Infant Restraint ...........................85
Information Center, Vehicle ..................301
Inside Rearview Mirror .....................126
Instrument Cluster ....................... .292
Instrument Panel and Controls ................290
Instrument Panel Lens Cleaning ...............601
Interior Appearance Care ....................599
Intermittent Wipers (Delay Wipers) .............186
Introduction ..............................4
Inverter, Power .......................... .261
Jacking And Tire Changing Instructions .........535
Jacking Instructions ....................... .535
10
INDEX 649

Jack Location........................... .530
Jack Operation .......................... .529
Jump Starting ........................... .545
KeyFob.................................15 Arm The Alarm .........................20
Disarm The Alarm .......................21
Panic Alarm ............................26
Programming Additional Key Fobs ...........19
Programming Additional Transmitters .........19
Unlock Liftgate .........................46
Key-In Reminder ..........................16
Keyless Enter-N-Go ........................36
KEYLESS ENTER-N-GO™ KEYLESS ENTER-N-GO™ ..................36
Lock The Vehicle’s Doors ..................332
Passive Entry ...........................36
Passive Entry Programming .................36
Unlock Liftgate .........................46 Keyless Entry System
.......................23
Keyless Go ...............................14
Key, Replacement ..........................18
Keys ...................................14
Key, Sentry (Immobilizer) ....................17
Lane Change Assist ....................... .185
Lap/Shoulder Belts .........................54
Latches ................................118
Lead Free Gasoline ....................... .486
Leaks, Fluid .............................118
Life of Tires ............................ .473
Liftgate .................................46
Liftgate Window Wiper/Washer ...............276
Light Bulbs ..............................118
Lights .................................118
Airbag ................................77
Anti-Lock ............................ .292
Automatic Headlights ....................176
650 INDEX