radio antenna DODGE GRAND CARAVAN 2013 5.G Owners Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 2013, Model line: GRAND CARAVAN, Model: DODGE GRAND CARAVAN 2013 5.GPages: 683, PDF Size: 5.5 MB
Page 260 of 683
Before You Begin Programming HomeLink®
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmis-
sion of the radio-frequency signal it is recommended that
a new battery be placed in the hand-held transmitter of
the device that is being programmed to the HomeLink®
system.
Erase all channels before you begin programming. To
erase the channels place the ignition in the ON/RUN
position and press and hold the two outside HomeLink®
buttons (I and III) for up 20 seconds or until the red
indicator flashes.NOTE:
•Erasing all channels should only be performed when
programming HomeLink® for the first time. Do not
erase channels when programming additional buttons.
•If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
Programming A Rolling Code
For programming garage door openers that were manu-
factured after 1995. These garage door openers can be
identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is attached to the garage door
opener. It is NOT the button that is normally used to
open and close the door. The name and color of the
button may vary by manufacturer.
258 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 375 of 683
Selecting Uconnect® (Satellite) Mode
Press the SAT button untilSATappears in the display.
A CD may remain in the radio while in the Satellite radio
mode.
Satellite Antenna
To ensure optimum reception, do not place items on the
roof around the rooftop antenna location. Metal objects
placed within the line of sight of the antenna will cause
decreased performance. Larger luggage items such as
bikes should be placed as far rearward as possible, within
the loading design of the rack. Do not place items directly
on or above the antenna.
Reception Quality
Satellite reception may be interrupted due to one of the
following reasons:
•The vehicle is parked in an underground parking
structure or under a physical obstacle.
•Dense tree coverage may interrupt reception in the
form of short audio mutes.
•Driving under wide bridges or along tall buildings can
cause intermittent reception.
•Placing objects over or too close to the antenna can
cause signal blockage.
Operating Instructions - Uconnect® (Satellite) Mode
NOTE:The ignition switch must be in the ON/RUN or
ACC position to operate the radio.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 373
Page 433 of 683
NOTE:If you experience difficulty in playing a particu-
lar disc, it may be damaged (i.e., scratched, reflective
coating removed, a hair, moisture or dew on the disc)
oversized, or have protection encoding. Try a known
good disc before considering disc player service.
RADIO OPERATION AND MOBILE PHONES
Under certain conditions, the mobile phone being on in
your vehicle can cause erratic or noisy performance from
your radio. This condition may be lessened or eliminated
by relocating the mobile phone antenna. This condition is
not harmful to the radio. If your radio performance does
not satisfactorily “clear” by the repositioning of the
antenna, it is recommended that the radio volume be
turned down or off during mobile phone operation when
not using Uconnect® (if equipped).
CLIMATE CONTROLS
The Climate Control system allows you to regulate the
temperature, amount, and direction of air circulating
throughout the vehicle. The controls are located on the
instrument panel, below the radio.
Manual Heating And Air Conditioning
System — If Equipped
The controls for the manual system in this vehicle contain
a series of outer rotary dials and inner push knobs. These
comfort controls can be set to obtain desired interior
conditions.
With the Three-Zone Temperature Control system, each
front seat occupant can independently control the Heat-
ing, Ventilation, and Air Conditioning operations coming
from the outlets on their side of the vehicle.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 431
Page 626 of 683
To minimize the possibility of scratching the lenses and
reducing light output, avoid wiping with a dry cloth. To
remove road dirt, wash with a mild soap solution fol-
lowed by rinsing.
Do not use abrasive cleaning components, solvents, steel
wool or other aggressive material to clean the lenses.
Glass Surfaces
All glass surfaces should be cleaned on a regular basis
with MOPAR® Glass Cleaner, or any commercial
household-type glass cleaner. Never use an abrasive type
cleaner. Use caution when cleaning the inside rear win-
dow equipped with electric defrosters or the right rear
quarter window equipped with the radio antenna. Do
not use scrapers or other sharp instrument that may
scratch the elements.When cleaning the rear view mirror, spray cleaner on the
towel or rag that you are using. Do not spray cleaner
directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
2. Dry with a soft cloth.
624 MAINTAINING YOUR VEHICLE
Page 664 of 683
Adding Engine Coolant (Antifreeze)............611
Adding Fuel.............................537
Adding Washer Fluid......................608
Additives, Fuel...........................531
Adjustable Pedals.........................235
Airbag..................................74
Airbag Deployment........................85
Airbag Light.............................82
Airbag Maintenance........................87
Airbag, Side..............................78
Airbag, Window (Side Curtain)................78
Air Cleaner, Engine (Engine Air Cleaner Filter). . . .599
Air Conditioner Maintenance.................604
Air Conditioning..........................431
Air Conditioning Controls...................431
Air Conditioning Filter.....................455
Air Conditioning, Rear Zone.................437
Air Conditioning Refrigerant.................604
Air Conditioning System....................431Air Conditioning System, Zone Control..........431
Air Pressure, Tires.........................507
Alarm Light.............................320
Alarm (Security Alarm)......................17
Alterations/Modifications, Vehicle...............7
Antenna, Satellite Radio.....................373
Antifreeze (Engine Coolant)..................610
Disposal..............................613
Anti-Lock Warning Light....................314
Anti-Theft System..........................17
Appearance Care.........................619
Ashtray................................278
Assistance Towing.........................160
Assist, Hill Start..........................493
Auto Down Power Windows..................42
Automatic Dimming Mirror..................131
Automatic Door Locks......................38
Automatic Headlights......................222
Automatic Temperature Control (ATC)..........440
662 INDEX
Page 677 of 683
Restraint, Head...........................192
Restraints, Child...........................89
Rocking Vehicle When Stuck.................583
Roof Rack (Luggage Rack)...................295
Rotation, Tires...........................518
Safety Checks Inside Vehicle..................118
Safety Checks Outside Vehicle................120
Safety Defects, Reporting....................655
Safety, Exhaust Gas........................117
Safety Information, Tire.....................496
Safety Tips..............................117
Satellite Radio Antenna.....................373
Schedule, Maintenance.....................642
Seat Belt Maintenance......................625
Seat Belt Reminder.........................72
Seat Belts................................56
Adjustable Shoulder Belt...................65
Adjustable Upper Shoulder Anchorage.........65And Pregnant Women.....................73
Child Restraint..........................89
Extender..............................74
Front Seat.............................60
Inspection............................118
Pretensioners...........................68
Rear Seat..............................60
Seats..................................183
Adjustment...........................183
Fold in Floor (Stow nGo).................196
Memory..............................215
Power...............................184
Reclining.............................191
Stow n Go (Fold in Floor).................196
Security Alarm (Theft Alarm)..................17
Selection of Coolant (Antifreeze)...............639
Sentry Key (Immobilizer)....................15
Sentry Key Programming....................17
Sentry Key Replacement.....................16
10
INDEX 675
Page 682 of 683
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained personnel.
The following must be observed during installation.
The positive power connection should be made directly to
the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the roof
or the rear area of the vehicle. Care should be used in
mounting antennas with magnet bases. Magnets may affect
the accuracy or operation of the compass on vehicles so
equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.