radio antenna DODGE GRAND CARAVAN 2016 5.G Owners Manual

Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmis-
sion of the radio-frequency signal it is recommended that
a new battery be placed in the hand-held transmitter of
the device that is being programmed to the HomeLink
system.
To erase the channels place the ignition in the ON/RUN
position and push and hold the two outside HomeLink
buttons (I and III) for up 20 seconds or until the red
indicator flashes.NOTE:
•
Erasing all channels should only be performed when
programming HomeLink for the first time. Do not
erase channels when programming additional buttons.
• If you have any problems, or require assistance, please
call toll-free 800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
Programming A Rolling Code
For programming garage door openers that were manu-
factured after 1995. These garage door openers can be
identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is attached to the garage door
opener. It is NOT the button that is normally used to
open and close the door. The name and color of the
button may vary by manufacturer.
256 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Electronic Serial Number/Sirius Identification
Number (ESN/SID)
Please have the following information available when
calling:
1. The Electronic Serial Number/Sirius IdentificationNumber (ESN/SID).
2. Your Vehicle Identification Number.
To access the ESN/SID, refer to the following steps:
ESN/SID Access
With the ignition switch in the ON/RUN or ACC posi-
tion and the radio on, push the SETUP button and scroll
using the TUNE/SCROLL control knob until Sirius ID is
selected. Push the TUNE/SCROLL control knob and the
Sirius ID number will display. The Sirius ID number
display will time out in two minutes. Push any button on
the radio to exit this screen.
Selecting Uconnect (Satellite) Mode
Push the SAT button until SATappears in the display. A
CD may remain in the radio while in the Satellite radio
mode.
Satellite Antenna
To ensure optimum reception, do not place items on the
roof around the rooftop antenna location. Metal objects
placed within the line of sight of the antenna will cause
decreased performance. Larger luggage items such as
bikes should be placed as far rearward as possible, within
the loading design of the rack. Do not place items directly
on or above the antenna.
Reception Quality
Satellite reception may be interrupted due to one of the
following reasons:
• The vehicle is parked in an underground parking
structure or under a physical obstacle.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 381

•Dense tree coverage may interrupt reception in the
form of short audio mutes.
• Driving under wide bridges or along tall buildings can
cause intermittent reception.
• Placing objects over or too close to the antenna can
cause signal blockage.
Operating Instructions — Uconnect (Satellite)
Mode
NOTE: The ignition switch must be in the ON/RUN or
ACC position to operate the radio.
SEEK Buttons
Push and release the SEEK buttons to search for the next
listenable station in AM/FM mode. Push the right switch
to seek up and the left switch to seek down. The radio
will remain tuned to the new station until you make another selection. Holding either button will bypass
stations without stopping, until you release it.
SCAN Button
Pushing the SCAN button causes the tuner to search for
the next channel, pausing for eight seconds before con-
tinuing to the next. To stop the search, push the SCAN
button a second time.
INFO Button
Pushing the INFO button will cycle the display informa-
tion between Artist, Song Title, and Composer (if avail-
able). Also, pushing and holding the INFO button for an
additional three seconds will make the radio display the
Song Title all of the time (push and hold again to return
to normal display).
382 UNDERSTANDING YOUR INSTRUMENT PANEL

CD/DVD/Blu-ray Disc MAINTENANCE
To keep a CD/DVD/Blu-ray Disc in good condition, take
the following precautions:
1. Handle the disc by its edge; avoid touching thesurface.
2. If the disc is stained, clean the surface with a soft cloth, wiping from center to edge.
3. Do not apply paper or tape to the disc; avoid scratch- ing the disc.
4. Do not use solvents such as benzene, thinner, cleaners, or anti-static sprays.
5. Store the disc in its case after playing.
6. Do not expose the disc to direct sunlight.
7. Do not store the disc where temperatures may become too high. NOTE:
If you experience difficulty in playing a particular
disc, it may be damaged (i.e., scratched, reflective coating
removed, a hair, moisture or dew on the disc) oversized,
or have protection encoding. Try a known good disc
before considering disc player service.
RADIO OPERATION AND MOBILE PHONES
Under certain conditions, the mobile phone being on in
your vehicle can cause erratic or noisy performance from
your radio. This condition may be lessened or eliminated
by relocating the mobile phone antenna. This condition is
not harmful to the radio. If your radio performance does
not satisfactorily “clear” by the repositioning of the
antenna, it is recommended that the radio volume be
turned down or off during mobile phone operation when
not using Uconnect (if equipped).
4
UNDERSTANDING YOUR INSTRUMENT PANEL 439

cleaner. Use caution when cleaning the inside rear win-
dow equipped with electric defrosters or windows
equipped with radio antennas. Do not use scrapers or
other sharp instrument that may scratch the elements.
When cleaning the rear view mirror, spray cleaner on the
towel or cloth that you are using. Do not spray cleaner
directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft cloth. A mild soap solution maybe used, but do not use high alcohol content or
abrasive cleaners. If soap is used, wipe clean with a
clean damp cloth.
2. Dry with a soft cloth.
Seat Belt Maintenance
Do not bleach, dye, or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage can also weaken the fabric.
If the belts need cleaning, use MOPAR Total Clean, a mild
soap solution, or lukewarm water. Do not remove the
belts from the vehicle to wash them. Dry with a soft cloth.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
WARNING!
A frayed or torn belt could rip apart in a collision and
leave you with no protection. Inspect the belt system
periodically, checking for cuts, frays, or loose parts.
Damaged parts must be replaced immediately. Do
not disassemble or modify the system. Seat belt
(Continued)
7
MAINTAINING YOUR VEHICLE 645

About Your Brakes....................... .488
Adding Engine Coolant (Antifreeze) ............631
Adding Fuel ............................ .543
Adding Washer Fluid ..................... .628
Additives, Fuel .......................... .538
AirBag.................................78 Advance Front Air Bag ....................80
Air Bag Operation .......................81
Air Bag Warning Light ....................90
Driver Knee Air Bag ......................82
Enhanced Accident Response ................89
Event Data Recorder (EDR) .................92
FrontAirBag...........................78
If A Deployment Occurs ...................88
Knee Impact Bolsters .....................82
Maintaining Your Air Bag System ............91
Side Air Bags ...........................83
Transporting Pets .......................117
Air Bag Deployment ........................78 Air Bag Light
..................... .90, 120, 315
Air Bag Maintenance .......................91
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . .621
Air Conditioner Maintenance .................625
Air Conditioning ......................... .440
Air Conditioning Controls ...................440
Air Conditioning Filter ..................459, 626
Air Conditioning, Operating Tips ..............458
Air Conditioning, Rear Zone ..............445, 455
Air Conditioning Refrigerant ..............625, 626
Air Conditioning System .............440, 448, 625
Air Conditioning System, Zone Control ..........440
Air Pressure, Tires ........................ .513
Alarm (Security Alarm) ..................17, 324
Alterations/Modifications, Vehicle ...............7
Antenna, Satellite Radio .....................381
Antifreeze (Engine Coolant) ...............631, 660
Disposal ............................. .634
Anti-Lock Brake System (ABS) ................489
684 INDEX

Rear Camera........................... .248
Rear Cross Path ......................... .142
Rear Heater ............................ .445
Rear ParkSense System .....................240
Rearview Mirrors ........................ .131
Rear Window Features .....................290
Reclining Front Seats ...................... .192
Recorder, Event Data .......................92
Recreational Towing ...................... .562
Reformulated Gasoline .....................536
Refrigerant ............................. .626
Reminder, Seat Belt .........................57
Remote Keyless Entry (RKE) ..................20
FCC General Information ..................30
Programming Additional Key Fobs ...........17
Programming Additional Transmitters .........17
Remote Sound System (Radio) Controls .........437
Remote Starting System ......................30
Removable Floor Console ...................288 Replacement Bulbs
....................... .655
Replacement Keys .........................16
Replacement Parts ........................ .617
Replacement Tires ........................ .523
Reporting Safety Defects ....................678
Restraint, Head .......................... .193
Restraints, Child ...........................93
Rocking Vehicle When Stuck .................605
Roof Rack (Luggage Rack) ...................291
Rotation, Tires .......................... .526
Safety Checks Inside Vehicle .................120
Safety Checks Outside Vehicle ................122
Safety Defects, Reporting ....................678
Safety, Exhaust Gas ........................119
Safety Information, Tire .....................501
Safety Tips ..............................119
Satellite Radio Antenna .....................381
Schedule, Maintenance .....................666
10
INDEX 697

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.