set clock DODGE INTREPID 2004 2.G Owners Manual

UNDERSTANDING YOUR INSTRUMENT PANEL
CONTENTS
Instruments And Controls.................86
Instrument Cluster......................87
Instrument Cluster Description.............88
Electronic Digital Clock..................93
▫To Set The Clock.......................93
Sales Code RAZ—AM/ FM Stereo Radio With
Cassette Tape Player And CD Player — If
Equipped
.............................93
▫Operating Instructions — Radio............93
▫Power Switch, Volume Control.............93
▫Seek Button (Radio Mode)................94
▫Tuning..............................94▫PTY (Program Type) Button...............94
▫Balance.............................95
▫Fade...............................95
▫Tone Control.........................95
▫AM/FM Selection......................96
▫Scan Button..........................96
▫To Set The Radio Push-Button Memory.......96
▫To Change From Clock To Radio Mode.......96
▫Operating Instructions — Tape Player........96
▫Seek Button..........................97
▫Fast Forward (FF)......................97
▫Rewind (RW).........................97
4

ELECTRONIC DIGITAL CLOCK
The clock and radio each use the display panel built into
the radio. A digital readout indicates the time in hours
and minutes whenever the ignition switch is in the ON or
ACC position.
When the ignition switch is in the OFF position, pressing
the Time button will cause the radio to display time for
several seconds, then turn off.
To Set The Clock:
1. Use a ballpoint pen or similar object to press the hour
(H) or minute (M) buttons on the radio, The time setting
will increase each time you press the button.
2. Press any other button to exit from the clock setting
mode or it will exit the mode automatically if left alone
for 5 or 6 seconds.
SALES CODE RAZ—AM/ FM STEREO RADIO
WITH CASSETTE TAPE PLAYER AND CD PLAYER
— IF EQUIPPED
Operating Instructions — Radio
NOTE:
Power to operate the radio is controlled by the
ignition switch. It must be in the ON or ACC position to
operate the radio.
Power Switch, Volume Control
Press the ON/VOL control to turn the radio on. Turn the
volume control clockwise to increase the volume. The
volume will be displayed and continuously updated
while the button is pressed.
UNDERSTANDING YOUR INSTRUMENT PANEL 93
4

AM/FM Selection
Press the AM/FM button to change from AM to FM. The
operating mode will be displayed next to the station
frequency. The display will show ST when a stereo
station is received.
Scan Button
Pressing the SCAN button causes the tuner to search for
the next station, in either AM or FM, pausing for 5
seconds at each listenable station before continuing to the
next.
Pressing the AM/FM button continues the search in the
alternate frequency band.
To stop the search, press SCAN a second time.
To Set The Radio Push-button Memory
When you are receiving a station that you wish to
commit to push-button memory, press the SET button.
SET 1 will show in the display window. Select the
push-button you wish to lock onto this station and press
and release that button. If a station is not selected within
5 seconds after pressing the SET button, the station willcontinue to play but will not be locked into push-button
memory.
You may add a second station to each push-button by
repeating the above procedure with this exception: Press
the SET button twice and SET 2 will show in the display
window. Each button can be set for SET 1 and SET 2 in
both AM and FM. This allows a total of 10 AM and 10 FM
stations to be locked into memory. You can recall the
stations stored in SET 2 memory by pressing the push-
button twice.
To Change From Clock To Radio Mode
Press the Time button to change the display between
radio frequency and time.
Operating Instructions — Tape Player
Insert the cassette with the exposed tape side toward the
right and the mechanical action of the player will gently
pull the cassette into the play position.
NOTE:When subjected to extremely cold temperatures,
the tape mechanism may require a few minutes to warm
up for proper operation. Sometimes poor playback may
96 UNDERSTANDING YOUR INSTRUMENT PANEL

You also may choose to customize your comfort by
selecting the fan speed and Mode. This will place the
system into manual operation
Interior ATC Sensors
There are two interior sensors in the vehicle. The Sun
Sensor is mounted in the center of the instrument panel
near the windshield glass. The In-Car Temperature Sen-
sor is mounted behind the ATC control panel. These
sensors transmit data on sun strength and vehicle interior
temperatures to enhance system performance.
CAUTION!
Do not cover either sensor with any foreign material
as improper operation of the system will result.
Level Of Automatic Control
72°F (22°C) is the recommended setting for maximum
comfort for the average person, however, this may vary.
NOTE:The temperature setting can be adjusted at any
time without affecting automatic control operation.The control also will show what Mode the system is in by
the figure shown in the display.
NOTE:The Mode can change when the system is in the
Auto Mode. This will be indicated in changes in the
display window. This shows automatic changes in air
direction.
Fan Control
Use this control to regulate the amount of air forced
through the system in any mode you select. Turn the
control clockwise to increase fan speed.
In ambient temperatures below 70°F (21°C), fan opera-
tion is delayed when the engine is first started. The fan
will automatically start when the engine coolant is warm
enough to heat the air. This feature can be defeated by
turning the fan control.
AUTO Control
Press the top of the button to turn the ATC system On.
Press the lower portion of the button to turn the entire
system Off.
118 UNDERSTANDING YOUR INSTRUMENT PANEL

Service Engine Soon Light................ 169
Service Manuals........................ 233
Setting the Clock........................ 93
Shoulder Belts.......................... 31
Side Airbag............................ 38
Side View Mirror Adjustment............... 54
Side Window Demisters.................. 122
Signals, Turn........................... 64
Slippery Surfaces, Driving On............. 161
Snow Chains.......................... 140
Snow Tires............................ 140
Spare Tire............................ 139
Spark Plugs........................... 178
Specifications.......................... 208
Engine............................. 208
Speed Control........................67,89
Speedometer........................... 89
Starting.............................. 127
Steering
Linkage............................ 184
Power...........................135,183
Tilt Column.......................... 65
Stuck, Freeing......................... 162Sulfur in Gasoline...................... 145
Sun Roof............................76,77
Supplemental Restraint System - Airbag....... 33
Synthetic Engine Oil..................... 177
Tachometer............................ 88
Temperature Gauge, Engine Coolant......... 153
Theft Alarm............................ 23
Theft System........................... 23
Tilt Steering Column..................... 65
Time Delay, Headlight.................... 62
Timing Belt........................... 180
Tires ...........................48,136,235
Air Pressure......................136,137
Alignment.......................... 143
Balancing........................... 143
Chains............................. 140
Changing........................153,154
Flat Changing........................ 153
High Speed......................... 138
Jacking............................. 154
Pressure Label....................... 137
Quality Grading...................... 235
INDEX 247
10