battery DODGE JOURNEY 2009 1.G Owner's Guide

off the message. If the problem persists, the message will
appear the next time the vehicle is started.
A loose, improperly installed, or damaged fuel filler cap
may also turn on the MIL.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of this vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.For states that require an Inspection and Mainte-
nance (I/M), this check verifies the Malfunction
Indicator Light (MIL) is functioning and is not on
when the engine is running, and that the OBD II system
is ready for testing.
Normally, the OBD II system will be ready. The OBD II
system may notbe ready if the vehicle was recently serviced, recently had a dead battery, or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, the vehicle may fail the test.
This vehicle has a simple ignition key-actuated test,
which you can use prior to going to the test station. To
check if this vehicle’s OBD II system is ready, you must
do the following:
1. Insert the ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn the ignition key to the ON
position, you will see the MIL symbol come on as part of
a normal bulb check.
422 MAINTAINING YOUR VEHICLE

5. Approximately 15 seconds later, one of two things will
happen:a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition key or start the engine. This means that the
vehicle’s OBD II system is not readyand you should
not proceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn OFF the ignition key or start
the engine. This means that the vehicle’s OBD II
system is ready,and you can proceed to the I/M
station.
If the OBD II system is not ready,you should see an
authorized dealer or repair facility. If this vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive the vehicle as you normally would in order for the OBD II system to
update. A recheck with the above test routine may then
indicate that the system is now ready.
Regardless of whether the vehicle’s OBD II system is
ready or not ready, if the MIL is illuminated during
normal vehicle operation, you should have the vehicle
serviced before going to the I/M station. The I/M station
can fail the vehicle because the MIL is on with the engine
running.
REPLACEMENT PARTS
Use of genuine Mopar
parts for normal/scheduled
maintenance and repairs is highly recommended to en-
sure the designed performance. Damage or failures
caused by the use of non-Mopar parts for maintenance
and repairs will not be covered by the manufacturer’s
warranty.
MAINTAINING YOUR VEHICLE 423
7

Disposing of Used Engine Oil and Oil Filters
Care should be taken in disposing of used engine oil and
oil filters from your vehicle. Used oil and oil filters,
indiscriminately discarded, can present a problem to the
environment. Contact your authorized dealer, service
station, or governmental agency for advice on how and
where used oil and oil filters can be safely discarded in
your area.
Engine Oil Filter
The engine oil filter should be replaced at every engine
oil change.
Engine Oil Filter Selection
This manufacturer’s engines have a full-flow type dispos-
able oil filter. Use a filter of this type for replacement. The
quality of replacement filters varies considerably. Only
high quality filters should be used to assure most efficient
service. MoparEngine Oil Filters are high quality oil
filters and are recommended.
Drive Belts — Check Condition and Tension
Belt tension is controlled by means of an automatic
tensioner. Therefore, no belt tension adjustments are
required. However, belt and belt tensioner condition
should be inspected periodically and replaced if re-
quired. Improper belt tension can cause belt slippage and
failure. Low generator belt tension can cause battery
failure.
Inspect belts for evidence of cuts, cracks, glazing, or
frayed cords and replace if there is indication of damage
that could result in belt failure. Also, check belt routing to
make sure there is no interference between the belts and
other engine components. Refer to the Maintenance
Schedule in Section 8 for specified service intervals. See
your authorized dealer for service.
428 MAINTAINING YOUR VEHICLE

In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may indicate severe
and abnormal catalyst overheating. If this occurs, safely
bring the vehicle to a complete stop, shut the engine OFF,
and allow the vehicle to cool. Thereafter, obtain service,
including a tune-up to manufacturer’s specifications im-
mediately.
To minimize the possibility of catalyst damage:
•Do not shut OFF the engine or interrupt the ignition
when the transaxle is in gear and the vehicle is in
motion.
•Do not try to start the engine by pushing or towing the
vehicle.
•Do not idle the engine with any ignition coil connec-
tors disconnected for prolonged periods.
Maintenance-Free Battery
You will never have to add water, nor is periodic main-
tenance required.
NOTE:The battery is stored in a compartment that is
located behind the left front fender and is accessible
through the wheel well. The wheel and tire assemble do
not need to be removed to access the compartment.
Remote battery terminals are located in the engine com-
partment for jump-starting.
To access the battery, turn the steering wheel fully to the
right and remove the access panel from the inner fender
shield.
MAINTAINING YOUR VEHICLE 431
7

WARNING!
•Battery fluid is a corrosive acid solution and can
burn or even blind you. Don’t allow battery fluid
to contact your eyes, skin, or clothing. Don’t lean
over a battery when attaching clamps. If acid
splashes in eyes or on skin, flush the area imme-
diately with large amounts of water.
•Battery gas is flammable and explosive. Keep
flame or sparks away from the battery. Don’t use a
booster battery or any other booster source with an
output greater than 12 Volts. Don’t allow cable
clamps to touch each other.
•Battery posts, terminals, and related accessories
contain lead and lead compounds. Wash hands
after handling.
CAUTION!
•It is essential when replacing the cables on the
battery that the positive cable is attached to the
positive post and the negative cable is attached to
the negative post. Battery posts are marked posi-
tive (+) and negative (-) and identified on the
battery case. Cable clamps should be tight on the
terminal posts and free of corrosion.
•If a “fast charger” is used while the battery is in
the vehicle, disconnect both vehicle battery cables
before connecting the charger to the battery. Do
not use a “fast charger” to provide starting voltage
as battery damage can result.
432 MAINTAINING YOUR VEHICLE

CavityCartridge
Fuse Mini-
Fuse Description
M37
—10 Amp
Red
Anti-Lock Brake Sys-
tem (ABS), Electronic
Stability Program
(ESP), STOP LIGHT
Switch
M38 —25 Amp
Natural Lock/Unlock Motors
K1
—— Ignition Run/
Accessory Relay
K2 — — Ignition Run Relay
K3 — — Starter Solenoid Relay
K4 —— Ignition Run/Start
Relay
K5 —— (NGC) Powertrain
Control Module Relay
K6 —— Electric Back Light
(EBL) Relay
K7 — — —
K8 — — —
K9 — — Rear Blower Relay
K10 —— ASD Relay (Feed for
M19 and M21)
K11 —— Radiator Fan Relay
Low Speed
VEHICLE STORAGE
If you will not be using your vehicle for more than 21
days you may want to take steps to preserve your battery.
You may:
•Remove the IOD (Ignition Off-Draw) mini-fuses from
the Totally Integrated Power Module located in the
engine compartment.
•Or, disconnect the batter negative cable.
464 MAINTAINING YOUR VEHICLE

At Each Stop for Fuel
•Check the engine oil level. Refer to “Engine Oil” under
“Maintenance Procedures” in Section 7.
•Check the windshield washer solvent and add if
required.
Once a Month
•Check tire pressure and look for unusual wear or
damage.
•Inspect the battery, and clean and tighten the terminals
as required.
•Check the fluid levels of coolant reservoir, brake
master cylinder, power steering, and transaxle, and
add as needed.
•Check all lights and other electrical items for correct
operation. At Each Oil Change
•Change the engine oil filter.
•Inspect the brake hoses and lines.
CAUTION!
Failure to perform the required maintenance items
may result in damage to the vehicle.
480 MAINTENANCE SCHEDULES
8
M
A I
N T
E
N A
N CE
S
C
H E
D
U L
E
S

Audio Systems (Radio).................234,266
Auto Down Power Windows ................ 35
Auto Unlock, Doors ....................... 31
Automatic Dimming Mirror ................. 89
Automatic Door Locks ................... 30,31
Automatic Headlights .................... 147
Automatic Oil Change Indicator ..........210,225
Automatic Temperature Control (ATC) ......... 293
Automatic Transaxle ................... 31 1,449
Adding Fluid ...................... 449,476
Filter ............................... 451
Fluid and Filter Changes ................. 451
Fluid Level Check ...................... 449
Interlock System .................... 312,313
Reset Mode .......................... 316
Selection Of Lubricant ................... 476
Shifting ............................. 311
Special Additives ...................... 451
Autostick ............................. 317 Auxiliary Electrical Outlet (Power Outlet)
...... 174
Auxiliary Power Outlet ................... 174
Back-Up Lights ......................... 468
Ball Joints ............................. 437
Battery ............................... 431
Charging System Light .................. 212
Emergency Starting ..................... 407
Gas Caution .......................... 432
Jump Starting ......................... 407
Keyless Transmitter Replacement (RKE) ....... 25
Location .......................... 407,431
Bearings .............................. 451
Belts, Drive ............................ 428
Belts, Seat ............................ 41,80
Beverage Cooler ........................ 180
Body Mechanism Lubrication ............... 437
Booster Seat ............................ 67
B-Pillar Location ........................ 341
INDEX 497
10

Latch Plate............................. 42
Latches ................................ 81
Hood ............................... 144
Lead Free Gasoline ...................... 368
Leaks, Fluid ............................ 81
Life of Tires ............................ 352
Liftgate ................................ 38
Liftgate Window Wiper/Washer ............. 193
Light Bulbs .......................... 81,465
Light Replacement ....................... 466
Lights ........................... 81,146,466
Airbag ........................ 57,63,80,218
Anti-Lock ........................... 329
Anti-Lock Warning ..................... 215
Automatic Headlights ................... 147
Back-Up ............................. 468
Battery Saver ......................... 152
Brake Assist Warning ................. 216,334
Brake Warning ........................ 217 Bulb Replacement
...................... 466
Cargo .............................. 151
Courtesy/Reading ..................... 151
Cruise .............................. 212
Daytime Running ...................... 148
Dimmer Switch, Headlight .............146,150
Electronic Stability Program (ESP)
Indicator ....................... 216,332,334
Electronic Throttle Control Warning ......... 211
Exterior .............................. 81
Fog .......................... 148,207,467
Hazard Warning Flasher ................. 394
Headlight Switch ...................... 146
Headlights ........................ 146,466
Headlights On Reminder ................. 148
Headlights On With Wipers ............147,156
High Beam ..................... 150,207,466
High Beam Indicator .................... 207
High Beam/Low Beam Select ............. 150
INDEX 507
10

Lubrication, Body....................... 437
Luggage Rack (Roof Rack) ................. 196
Lumbar Support ........................ 127
Maintenance Free Battery .................. 431
Maintenance, General ..................... 424
Maintenance Procedures ................... 424
Maintenance Schedule .................... 478
Maintenance, Sunroof ..................... 173
Malfunction Indicator Light (Check Engine) . . 215,422
Manual, Service ......................... 492
Map/Reading Lights ..................... 151
Marker Lights, Side ...................... 466
Master Cylinder (Brakes) .................. 447
Methanol ............................. 369
Mini-Trip Computer ...................... 226
Mirrors ............................. 88,163
Automatic Dimming ..................... 89
Electric Powered ....................... 90 Electric Remote
........................ 90
Exterior Folding ........................ 90
Heated .............................. 91
Outside .............................. 89
Rearview ............................. 88
Vanity ............................... 91
Mode Fuel Saver ........................... 226
Modifications/Alterations, Vehicle ............. 7
Monitor, Tire Pressure System ............... 355
Mopar Parts ......................... 423,491
MP3 Player ......................... 234,266
MTBE/ETBE ........................... 369
Multi-Function Control Lever ............... 146
Navigation Radio ........................ 266
Navigation System ....................... 266
New Vehicle Break-In Period ................ 77
INDEX 509
10