bulb DODGE JOURNEY 2014 1.G User Guide

CavityCar-
tridge Fuse Mini-
Fuse Description
F181 100 AmpBlue Electrohydraulic
Steering (EHPS) – If Equipped
F182 50 Amp Red Cabin Heater #3 – If
Equipped
F184 30 Amp Pink Front Wiper Motor
REPLACEMENT BULBS
Interior Bulbs
Bulb Number
Courtesy/Reading
Lamps (Incandescent) 578
Courtesy/Reading
Lamps (Optional LED) LED (Serviced at
Authorized Dealer)
Glove Box Lamp 194
Cargo Lamp 579
Optional Door Map
Pocket/Cupholder LED (Serviced at
Authorized Dealer)
For lighted switches, see your authorized dealer for
replacement instructions.
594 MAINTAINING YOUR VEHICLE

Exterior Bulbs
Bulb Number
Low Beam Headlamp 9006
High Beam Headlamp 9005
Front Park/Turn Signal 3757AK
Side Marker Lamp 168
Front Fog Lamp PSX24W
Center High Mounted
Stop Lamp (CHMSL) LED (Serviced at
Authorized Dealer)
License Lamp 168
Exterior Bulbs – Rear (LED Version)
Bulb Number
Rear Tail/Stop Lamp LED (Serviced at
Authorized Dealer)
Rear Tail (Liftgate) Lamp LED (Serviced at Authorized Dealer)
Rear Turn Signal Lamp WY21W
Backup Lamp W21W
Exterior Bulbs – Rear (Bulb Version)
Bulb Number
Rear Tail/Stop/Turn
Signal Lamp P27/7W
Rear Tail (Liftgate) Lamp P27/7W
Backup Lamp P27/7W
7
MAINTAINING YOUR VEHICLE 595

BULB REPLACEMENT
NOTE:Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
Front Low/High Beam Headlamp, Turn
Signal/Park Lamp, And Side Marker Lamp
1. Open the hood.
NOTE: It may be necessary to remove the air cleaner
filter housing and position the Totally Integrated Power
Module (TIPM) aside to replace certain lamps in the left
headlamp housing.
2. Rotate the applicable bulb and connector assembly ¼ turn counterclockwise and remove the assembly from
the headlamp housing. 3. Disconnect the bulb from the harness connector and
then connect the replacement bulb.
1 — Front Turn Signal/Park Lamp Bulb
2 — Side Marker Lamp Bulb
3 — Low Beam Headlamp Bulb
4 — High Beam Headlamp Bulb
596 MAINTAINING YOUR VEHICLE

CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
4. Install the bulb and connector assembly into the headlamp housing and rotate it ¼ turn clockwise to
lock it in place.
Front Fog Lamp
NOTE: Turn the steering wheel to the right if replacing
the left front fog lamp or to the left if replacing the right
front fog lamp to allow for easier access to the front of the
wheel well.
1. Remove the fasteners retaining the front lower wheel well access panel and remove the access panel. 2. Remove the electrical connector from the fog lamp
housing.
3. Squeeze the two tabs on the side of the bulb socket and pull straight out from the fog lamp.
Front Fog Lamp Electrical Connector
7
MAINTAINING YOUR VEHICLE 597

CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
4. Install the replacement bulb and connector assembly straight into the fog lamp until it locks into place.
5. Reinstall the front lower wheel well access panel and fasteners.
Rear Turn Signal And Backup Lamp
The tail lamps are a two-piece design. The tail/stop/rear
turn signal lamps are located in the rear corner body
panels. The tail and backup lamps are located in the
liftgate.
Changing The Rear Turn Signal Lamp
1. Open the liftgate.
2. Remove the two fasteners from the inboard side of thetail lamp housing.
Inboard Tail Lamp Housing Fasteners
598 MAINTAINING YOUR VEHICLE

3. Carefully insert a trim stick (plastic flat-blade tool)between the body panel and the outboard side of the
tail lamp housing with one hand and grasp the flange
on the inboard side of the tail lamp housing with the
other hand. Use the trim stick and hand pressure
together to disengage the tail lamp housing from the
vehicle.
4. Rotate the applicable bulb’s electrical connector ¼ turn counterclockwise and remove it from the tail lamp
housing.
5. Remove the bulb from the connector socket and install the replacement bulb.
6. Install the bulb and connector assembly into the tail lamp housing and rotate the connector ¼ turn clock-
wise to lock it in place.
7. Reinstall the tail lamp housing and fasteners.Changing The Backup Lamp
1. Open the liftgate.
2. Remove the two fasteners retaining the tail lamp housing to the liftgate from the inboard face of the
liftgate.
Tail Lamp Housing Retainers
7
MAINTAINING YOUR VEHICLE 599

3. Carefully insert a trim stick (plastic flat-blade tool)between the tail lamp housing and the liftgate. Use the
trim stick and hand pressure together to disengage the
tail lamp housing from the liftgate. 4. Rotate the applicable bulb’s electrical connector ¼ turn
counterclockwise and remove it from the housing.
5. Remove the bulb from the connector socket and install the replacement bulb.
6. Install the bulb and connector assembly into the housing and rotate the connector ¼ turn clockwise to
lock it in place.
7. Reinstall the tail lamp housing and fasteners.
Tail Gate Lamp
600 MAINTAINING YOUR VEHICLE

License Plate Lamp
1. Push the small locking tab sticking out of the end ofthe lens toward the side of the vehicle and hold it in
that position. 2. Insert a small flat-blade tool between the end of the
lens with the locking tab and the surrounding housing
and then pivot the tool to separate the lens from the
housing.
3. Hold the lens with one hand and rotate the bulb’s electrical connector ¼ turn counterclockwise with the
other hand and then separate the bulb and connector
assembly from the lens.
4. Remove the bulb from the connector socket and install the replacement bulb.
5. Install the bulb and connector assembly into the lens and rotate the connector ¼ turn clockwise to lock it in
place.
6. Insert the end of the lens without the locking tab into the housing on the liftgate and then push the opposite
end of the lens into the housing, making sure it locks
in the housing.
License Lamp
7
MAINTAINING YOUR VEHICLE 601

Parking............................. .434
Warning Light ........................ .307
Brake/Transmission Interlock .................419
Break-In Recommendations, New Vehicle ........106
Brightness, Interior Lights ...................230
Bulb Replacement ........................ .594
Bulbs, Light .............................111
Camera, Rear ............................251
Capacities, Fluid ..........................602
Caps, Filler Fuel .................................492
Oil (Engine) .......................... .545
Power Steering ........................ .434
Radiator (Coolant Pressure) ................570
Carbon Monoxide Warning ..................108
Cargo Area Cover ........................ .287
Cargo Area Features .......................284
Cargo Compartment .......................284 Light
............................... .284
Luggage Carrier ........................293
Cargo Load Floor ........................ .285
Cargo Management System ..................285
Rollaway Tonneau Cover ..................287
Tri-Fold Load Floor ..................... .285
Cargo Tie-Downs ........................ .286
Cargo (Vehicle Loading) ....................285
Car Washes ............................ .580
Cellular Phone .......................... .375
Certification Label ........................ .494
Chains, Tire ............................ .471
Changing A Flat Tire .......................518
Chart, Tire Sizing ........................ .451
Check Engine Light (Malfunction Indicator Light) . .302
Checking Your Vehicle For Safety ..............107
Checks, Safety .......................... .107
Child Restraint ............................80
628 INDEX

Speedometer..........................309
Tachometer ............................302
Gear Ranges ............................ .421
Gear Select Lever Override ..................538
General Information .......................147
Glass Cleaning .......................... .585
Gross Axle Weight Rating ...................495
Gross Vehicle Weight Rating ..................495
GVWR .................................495
Hazard Driving Through Flowing, Rising, or Shallow
Standing Water ........................ .431
Hazard Warning Flasher ....................515
Headlights Automatic ............................226
Bulb Replacement .......................596
Cleaning ............................ .584
Delay ............................... .227High Beam
............................596
High Beam/Low Beam Select Switch .........230
Lights On Reminder .....................227
On With Wipers ........................226
Passing ............................. .230
Switch ...............................225
Time Delay ............................227
Head Restraints ..........................209
Heated Mirrors .......................... .123
Heated Seats ............................ .202
Heater, Engine Block .......................417
High Beam/Low Beam Select (Dimmer) Switch . . . .230
Hill Start Assist .......................... .448
Hitches Trailer Towing ........................ .500
Holder, Coin ............................ .278
Holder, Cup ............................ .275
634 INDEX