Shifting ............................. 281
Transmitter Battery Service
(Remote Keyless Entry).................... 23
Transmitter, Garage Door Opener (HomeLink) . . 143
Transmitter Programming
(Remote Keyless Entry).................... 20
Transmitter, Remote Keyless Entry (RKE)........ 20
Transporting Pets........................ 73
Tread Wear Indicators.................... 320
Trip Odometer.......................... 175
Turn Signals.........................130,177
UCI Connector......................... 251
UConnect™ (Hands-Free Phone)........... 87,225
Uniform Tire Quality Grades................ 448
Universal Consumer Interface (UCI) Connector . . . 251
Universal Serial Bus (USB) Port...........205,225
Universal Transmitter..................... 143
Unleaded Gasoline....................... 337Untwisting Procedure, Seat Belt.............. 45
USB Port...........................205,225
Vacuum/Vapor Harnesses................. 402
VanityMirrors ........................... 86
Variance, Compass....................... 196
Vehicle Certification Label................. 344
Vehicle Identification Number (VIN)............ 6
Vehicle Loading...................313,344,345
Vehicle Modifications/Alterations.............. 7
Vehicle Storage.......................267,420
Vehicle Theft Alarm (Security Alarm).......... 18
Video Entertainment System
(Rear Seat Video System).................. 247
Viscosity, Engine Oil...................... 386
Voice Recognition System (VR).............. 113
Warning Flasher, Hazard.................. 364
INDEX 471
10
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle's electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle's electronic systems.
