immobilizer DODGE NITRO 2011 1.G Owners Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 2011, Model line: NITRO, Model: DODGE NITRO 2011 1.GPages: 497, PDF Size: 3.89 MB
Page 17 of 497
Key-In-Ignition Reminder
If you open the driver’s door and the key is in the
ignition, a chime will sound to remind you to remove the
key.
NOTE:The Key-In-Ignition reminder only sounds
when the ignition key is placed in the LOCK or ACC
position.
SENTRY KEY
The Sentry Key Immobilizer System prevents unauthor-
ized vehicle operation by disabling the engine. The
system does not need to be armed or activated. Operation
is automatic, regardless of whether the vehicle is locked
or unlocked.
The system uses ignition keys that have an embedded
electronic chip (transponder) to prevent unauthorized
vehicle operation. Therefore, only keys that are pro-
grammed to the vehicle can be used to start and operate the vehicle. The system will shut the engine off in two
seconds if someone uses an invalid key to try to start the
engine.
NOTE:
A key that has not been programmed is also
considered an invalid key, even if it is cut to fit the
ignition switch lock cylinder for that vehicle.
During normal operation, after turning on the ignition
switch, the Vehicle Security Light will turn on for three
seconds for a bulb check. If the light remains on after the
bulb check, it indicates that there is a problem with the
electronics. In addition, if the Vehicle Security Light
begins to flash after the bulb check, it indicates that
someone used an invalid key to try to start the engine.
Either of these conditions will result in the engine being
shut off after two seconds.
14 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Page 18 of 497
If the Vehicle Security Light turns on during normal
vehicle operation (vehicle running for longer than 10 sec-
onds), it indicates that there is a fault in the electronics.
Should this occur, have the vehicle serviced as soon as
possible by an authorized dealer.
CAUTION!
The Sentry KeyImmobilizer system is not compat-
ible with some after-market remote starting systems.
Use of these systems may result in vehicle starting
problems and loss of security protection.
All of the keys provided with your new vehicle have
been programmed to the vehicle electronics.
Replacement Keys
NOTE: Only keys that are programmed to the vehicle
electronics can be used to start and operate the vehicle.
Once a Sentry Key is programmed to a vehicle, it cannot
be programmed to any other vehicle.
CAUTION!
Always remove the Sentry Keys from the vehicle
and lock all doors when leaving the vehicle unat-
tended.
At the time of purchase, the original owner is provided
with a four-digit Personal Identification Number (PIN).
Keep the PIN in a secure location. This number is
required for authorized dealer replacement of keys. Du-
plication of keys may be performed at an authorized
dealer or by following the customer key programming
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 15
Page 19 of 497
procedure. This procedure consists of programming a
blank key to the vehicle electronics. A blank key is one
that has never been programmed.
NOTE:When having the Sentry Key Immobilizer
System serviced, bring all vehicle keys with you to an
authorized dealer.
Customer Key Programming
If you have two valid Sentry Keys, you can program
new Sentry Keys to the system by performing the
following procedure:
1. Cut the additional Sentry Key Transponder blank(s)
to match the ignition switch lock cylinder key code.
2. Insert the first valid key into the ignition switch. Turn
the ignition switch to the ON/RUN position for at least
three seconds, but no longer than 15 seconds. Then, turn
the ignition switch to the LOCK position and remove the
first key. 3. Insert the second valid key into the ignition switch.
Turn the ignition switch to the ON/RUN position within
15 seconds. After 10 seconds, a chime will sound. In
addition, the Vehicle Security Light will begin to flash.
Turn the ignition switch to the LOCK position and
remove the second key.
4. Insert a blank Sentry Key
into the ignition switch.
Turn the ignition switch to the ON/RUN position within
60 seconds. After 10 seconds, a single chime will sound.
In addition, the Vehicle Security Light will stop flashing.
To indicate that programming is complete, the Vehicle
Security Light will turn on again for three seconds and
then turn off.
The new Sentry Key is programmed.The Remote
Keyless Entry (RKE) transmitter will also be pro-
grammed during this procedure.
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Page 484 of 497
HomeLink® (Garage Door Opener) Transmitter . . 169
Hood Release.......................... 149
Ignition ............................... 12
Key ............................... 12
Ignition Key Removal ..................... 12
Illuminated Entry ........................ 19
Immobilizer (Sentry Key) ................... 14
Infant Restraint ........................ 76,77
Information Center, Vehicle ................. 216
Inside Rearview Mirror .................... 97
Instrument Cluster .................... 197,198
Instrument Panel and Controls .............. 196
Instrument Panel Lens Cleaning ............. 431
Integrated Power Module (Fuses) ............ 432
Interior Appearance Care .................. 430
Interior Lights .......................... 155
Intermittent Wipers (Delay Wipers) ........... 158
Introduction ............................. 4 Jack Location
........................... 382
Jack Operation ....................... 381,384
Jacking Instructions ...................... 384
Jump Starting .......................... 388
Key-In Reminder ......................... 14
Key, Programming ........................ 16
Key, Replacement ........................ 15
Key, Sentry (Immobilizer) ................... 14
Keyless Entry System ...................... 20
Keys ................................. 12
Lane Change Assist ...................... 154
Lap/Shoulder Belts ....................... 43
LATCH
(Lower Anchors and Tether for CHildren) .....81,82
Latches ................................ 91
Lead Free Gasoline ...................... 351
Leaks, Fluid ............................ 91
10
INDEX 481
Page 490 of 497
Sentry Key (Immobilizer)................... 14
Sentry Key Programming ................... 16
Sentry Key Replacement ................... 15
Service Assistance ....................... 465
Service Contract ......................... 467
Service Engine Soon Light
(Malfunction Indicator) .................... 210
Service Manuals ........................ 469
Setting the Clock .................. 229,248,257
Settings, Personal ........................ 224
Shift Lever Override ...................... 393
Shifting Automatic Transmission .............295,300
Shoulder Belts ........................... 43
Side Window Demisters (Defrosters) .......... 284
Signals, Turn .............. 91,153,201,439,440,441
Snow Chains (Tire Chains) ................. 338
Spare Tire ....................... 333,334,382Specifications
Fuel (Gasoline) ...................... 351
Oil ............................... 408
Speed Control (Cruise Control) .............. 160
Speedometer ........................... 200
Starting ............................... 291
Cold Weather ....................... 291
Engine Block Heater .................. 293
Engine Fails to Start .................. 292
Remote ............................ 26
Steering Power .......................... 307,308
Tilt Column ........................ 159
Wheel, Tilt ......................... 159
Steering Wheel Audio Controls .............. 271
Steering Wheel Mounted Sound
System Controls ......................... 271
Storage ............................... 183
Storage Bin ............................ 183
10
INDEX 487