set clock DODGE POLARA 1965 3.G Owners Manual

-
RADIO
&Ii. Push-Bullon "AM": Ignition sWitch ~ must be at "On" or "Acc" position to operate.
This transistorIZed radio plays the moment you turn the left-hand knob clockwise to "On" posItion. This same knob adjusts the volume. Tone control ring, behind left knob, provides selection of tone quality. Stations can be tuned by pressing the push-buttons fully in or by turning the knob at right.
NOTE: For best reception With this radiO adjust the antenna height to 40".
NOTE: Radios designed for Chrysler Cor­poration automobiles are Identified by the car name appearing on either the radio dial lens or the control panel.
To Set Push Bullons: Permit radio to warm up for at least 10 minutes with antenna fully extended to recommended height. Pull out a bullon and, using manual tuning knob, carefully tune In a desired station. Press bullon firmly into lock station. This same procedure is used for selling the remaining buttons.
"fM/ AM" Radio: ThiS transistorIZed radio plays the moment you turn the left-hand knob clockWise to "On" posItion. ThiS same knob adjusts the volume. Tone control ring, behind left knob, prOVides selection of tone quality. Stations can be tuned by preSSing the push·buttons fully In or by turning knob at right.
You can enjoy either FM or AM reception by rotating the selector SWitch ring, located behind the tUning' knob at right, to the deSired band of operation.
NOTE: For best FM reception adjust antenna height to 31"; adjust to 40" for AM reception. The FM/AM band indication appears on the radiO dial. When changing bands, the dual purpose of thiS radiO does not permit push­buttons, already set for AM stations, to be set for FM stations or vice-versa. To obtain maximum pleasure With your FM AM radiO, refer to the booklet entitled "Facts About FM Reception" In the glove compartment.
Rear Seat Radio Speaker (dealer Installed): Equalized full sound reception IS available uSing both front and rear speakers, or either
In and turn the "On-Oft" knob. NOTE: The radio and Reverberator are separately con-
speaker indiVidually by turning the speaker trolled and powered units. Therefore, when fader control, located near the radiO on the the radio IS turned oft the Reverberator Instrument panel. Turning the knob fully to should also be turned oft by pushing the
the left selects front speaker only. Far right control knob "in" .
selects rear speaker. Proper balance"betwee~ 0 Remote-Control Outside Mirror. Mirror can front and rear can be achieved by mixing be adjusted from the driver's seat by a front and rear speakers. Rear speaker IS control located on the door panel just below located under the rear Window. the vent Window. To adjust the mirror, simply
Reverberator-Equipped Rear Seat Speaker: move the control in the direction you want Equalized, full·fidellty reception With "concert the mirror to move. hall" quality is available from your radiO With the use of the Reverberator -Equipped R ear Seat Speaker Unit. The reverberator mech­anically delays radiO sound Signals to the rear seat speaker, creating the sound presence heard In large auditOriums.
To operate, pull " out" the "On·Oft" knob, located on the Instrument panel, near the radiO. Push knob "in" to turn off. Because the sound quality of some types of musIc IS Improved more by reverberation than others, the degree of reverberatron can be controlled by rotating the "On-Off" knob. Rotating to the right provides Increased reverberation. To operate the rear seat speaker only, push