ignition DODGE POWER WAGON 2005 2.G Manual PDF

2. Park the booster vehicle within cable reach but with-
out letting the vehicles touch. Set the parking brake on
both vehicles, place the automatic transmission in Park or
the manual transmission in Neutral, and turn the ignition
OFF.
3. Turn off the heater, radio, and all unnecessary electri-
cal loads.
4. Connect one end of a jumper cable to the positive
terminal of the booster battery. Connect the other end of
the same cable to the positive terminal of the discharged
battery.
WARNING!
Do not permit vehicles to touch each other as this
could establish a ground connection and personal
injury could result.
WHAT TO DO IN EMERGENCIES 345
6

For states which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)
is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle’s OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL light will blink for approximately 5 sec-
onds and then remain on until the first engine crank or
the key is turned off. This means that your vehicle’s
OBD system isnot readyand you shouldnotproceed
to the I/M station.
354 MAINTAINING YOUR VEHICLE

To minimize the possibility of catalyst damage:
•Do not shut off the engine or interrupt the ignition
when the transmission is in gear and the vehicle is in
motion.
•Do not try to start engine by pushing or towing the
vehicle.
•Do not idle the engine with any spark plug wires
disconnected or removed, such as when diagnostic
testing, or for prolonged periods during very rough
idling or malfunctioning operating conditions.
Emission-Related Components
Positive Crankcase (PCV) Valve
Proper operation of the crankcase ventilation system
requires that the PCV valve be free of sticking or plug-
ging from deposits. Deposits can accumulate in the PCV
valve and passages with increasing mileage. Have the
PCV valve, hoses, and passages checked for proper
operation at the intervals specified. If the valve is
plugged or sticking, replace with a new valve—do not
attempt to clean the old PCV valve!Check the ventila-
tion hoses for indications of damage, weepage or plug-
ging with deposits. Replace if necessary.
Maintenance Free Battery
The top of the maintenance free battery is permanently
sealed. You will never have to add water, nor is periodic
maintenance required.
364 MAINTAINING YOUR VEHICLE

FUSE AND RELAY CENTER
Your vehicle is equipped with a fuse and relay center
located in the engine compartment near the battery.
Located on the underside of the cover is a label that
identifies each component.
1. Disconnect the battery negative (-) cable before remov-
ing the cover.2. Use specified fuses only.
3. Always properly reinstall the cover.
VEHICLE STORAGE
If you are storing your vehicle for more than 21 days, we
recommend that you take the following steps to mini-
mize the drain on your vehicle’s battery:
•Disconnect the Ignition-Off Draw fuse (I.O.D.) fuse
located in the Fuse and Relay Center, located in the
engine compartment. The I.O.D. cavity includes a
snap-in retainer that allows the fuse to be discon-
nected, without removing it from the fuse block.
•The electronic shift transfer case should be placed in
the 4HI mode and kept in this position to minimize the
battery drain.
•As an alternative to the above steps you may, discon-
nect the negative cables from both batteries.
MAINTAINING YOUR VEHICLE 393
7

Miles 48,000 51,000 54,000 57,000 60,000
(Kilometers) (77 000) (82 000) (86 000) (91 000) (96 000)
Change engine oil and engine oil filter, or at 3
months, whichever comes first.X X XXX
Lubricate Drive Shaft Fitting. X X X X X
Rotate tires. X X X
Lubricate tie rod end links. X X X X X
Drain and refill transfer case fluid.X
Change rear axle fluid.X
Change front axle fluid.X
Change 6-spd manual transmission (G-56) fluid. X
Inspect brake linings. X X
Inspect engine air cleaner filter, replace if neces-
sary.X
Replace spark plugs.X
Replace ignition cables.X
Inspect PCV valve, replace as necessary.**X
SCHEDULE“B”417
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 105,000 108,000 111,000 114,000 117,000 120,000
(Kilometers) (168 000) (173 000) (178 000) (182 000) (187 000) (192 000)
Change engine oil and engine oil filter, or at 3
months, whichever comes first.X X XXXX
Lubricate Drive Shaft Fitting. X XXXXX
Rotate tires. X X X
Lubricate tie rod end links. X XXXXX
Drain and refill transfer case fluid.X
Change rear axle fluid. X X
Change front axle fluid. X X
Change 6-spd manual transmission (G-56)
fluid.X
Inspect brake linings. X X
Inspect engine air cleaner filter, replace if
necessary.XX
Replace spark plugs.X
Replace ignition cables.X
422 SCHEDULE“B”
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 36,000 42,000 48,000 54,000 60,000 66,000
(Kilometers) (58 000) (67 000) (77 000) (84 000) (96 000) (106 000)
[Months] [36] [42] [48] [54] [60] [66]
Change engine oil and engine oil filter. X XXXXX
Lubricate Front Prop Shaft fitting. X XXXXX
Rotate tires. X XXXXX
Check transfer case fluid level. X
Lubricate tie rod end links. X XXXXX
Flush and replace engine coolant at 60
months, regardless of mileage.X
Inspect brake linings. X X
Inspect engine air cleaner filter, replace if
necessary.X
Replace spark plugs.X
Inspect PCV valve, replace as necessary.**X
Replace ignition cables.X
SCHEDULE“A”425
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 102,000 108,000 114,000 120,000
(Kilometers) (163 000) (173 000) (182 000) (192 000)
[Months] [102] [108] [114] [120]
Change engine oil and engine oil filter. X X X X
Lubricate Front Prop Shaft fitting. X X X X
Rotate tires. X X X X
Drain and refill transfer case fluid.X
Flush and replace engine coolant, if not done at 60 mos. X
Lubricate tie rod end links. X X X X
Inspect brake linings. X
Inspect auto tension drive belt and replace if required. X X
Replace ignition cables.X
Inspect engine air cleaner filter, replace if necessary.X
Replace spark plugs.X
Inspect PCV Valve, replace as necessary.** X
SCHEDULE“A”427
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Gasoline.............................. 307
Gasoline, Reformulated................... 307
Gauges............................... 161
Coolant Temperature.................... 160
Fuel................................ 164
Oil Pressure.......................... 159
Speedometer......................... 159
Tachometer.......................... 158
Voltmeter............................ 158
Gear Ranges........................... 270
Gear Ratios............................. 80
Glass Cleaning.......................... 392
GVWR............................... 315
Hands-Free Phone........................ 90
Hazard Warning Flasher................... 334
Head Restraints......................... 104
Headlights.......................... 111,394
High Beam........................... 115High Beam/Low Beam Select Switch........ 115
Lights On Reminder.................... 113
Passing............................. 114
Switch.............................. 111
Heated Mirrors.....................88,207,211
Heated Seats........................... 107
Heater............................... 203
High Beam/Low Beam Select (Dimmer) Switch . . 115
Hitches
Trailer Towing........................ 321
Hoisting.............................. 343
Homelink Transmitter.................... 130
Hood Release.......................... 108
Hoses................................ 375
Hub Caps............................. 342
Ignition.............................15,266
Key ...............................12,16
Lock..............................15,16
INDEX 445
10

Hazard Warning Flasher................. 334
Headlights........................... 111
High Beam........................ 115,158
High Beam Indicator.................... 158
High Beam/Low Beam Select.............. 115
Instrument Cluster..................... 157
Intensity Control....................... 110
Interior........................... 110,122
Lights On Reminder.................... 113
Low Washer Fluid..................... 164
Passing............................. 114
Seat Belt Reminder..................... 159
Service.............................. 394
Transfer Case......................... 280
Transmission Warning................165,327
Turn Signal.................. 113,158,394,398
Warning (Instrument Cluster Description)..... 157
Limited-Slip Differential................281,379
Loading Vehicle......................... 315Tires ............................... 291
Locks................................. 18
Child Protection........................ 23
Door................................ 18
Ignition.............................. 15
Keys................................ 12
Power Door........................... 19
Steering Wheel......................... 15
Lower Anchors and Tether for CHildren (LATCH) . 63
Lubricants............................. 383
Lubrication, Body....................... 369
Lug Nuts............................. 341
Lumbar Support........................ 105
Maintenance........................... 356
Maintenance Free Battery.................. 364
Maintenance Procedures................... 356
Maintenance Schedule.................... 410
ScheduleA......................... 424
INDEX 447
10