ball joints DODGE POWER WAGON 2005 2.G Owners Manual

▫Power Steering—Fluid Check............367
▫Front Suspension Ball Joints..............367
▫Steering Linkage—Inspection............368
▫Front Prop Shaft Lubrication.............368
▫Body Lubrication.....................369
▫Windshield Wiper Blades................369
▫Windshield Washers...................369
▫Exhaust System......................370
▫Cooling System.......................371
▫Hoses And Vacuum/Vapor Harnesses.......375
▫Brake System........................376
▫Clutch Hydraulic System................377
▫Clutch Linkage.......................378▫Rear Axle And 4X4 Front Driving Axle Fluid
Level..............................378
▫Transfer Case........................379
▫Front Drive Shaft.....................379
▫Manual Transmission..................379
▫Automatic Transmission................380
▫Front Wheel Bearings..................383
▫Selection Of Lubricating Grease...........383
▫Noise Control System Required Maintenance
& Warranty.........................384
▫Appearance Care And Protection From
Corrosion...........................388

Fuse And Relay Center...................393

Vehicle Storage........................393
350 MAINTAINING YOUR VEHICLE

Power Steering—Fluid Check
Checking the power steering fluid level at a defined
service interval is not required. The fluid should only be
checked if a leak is suspected, abnormal noises are
apparent, and/or the system is not functioning as antici-
pated. Coordinate inspection efforts through a certified
DaimlerChrysler Dealership.
WARNING!
Fluid level should be checked on a level surface and
with the engine off to prevent injury from moving
parts and to insure accurate fluid level reading. Do
not overfill. Use only manufacturers recommended
power steering fluid.
If necessary, add fluid to restore to the proper indicated
level. With a clean cloth, wipe any spilled fluid from all
surfaces. Refer to Recommended Fluids, Lubricants, and
Genuine Parts for correct fluid type.
Front Suspension Ball Joints
4x2Models
The ball joints and seals should be inspected whenever
the vehicle is serviced for other reasons.
The ball joints originally supplied with the vehicle are
permanently lubricated at the factory and do not require
service. However, if the seals on the ball joints are
damaged, the joints should be replaced. Serviceable
replacement ball joints are available.
MAINTAINING YOUR VEHICLE 367
7

Front suspension ball joints should be replaced only by a
qualified service technician using tools specially de-
signed for this purpose. Damage to the joints and/or
suspension components may result if improper replace-
ment procedures are used.
If seals are damaged the ball joints should be replaced to
prevent leakage or contamination of the grease.
Steering Linkage—Inspection
Whenever the vehicle is hoisted, all steering linkage
joints should be inspected for evidence of damage. If
seals are damaged, parts should be replaced to prevent
leakage or contamination of the grease. Lubricate the
steering linkage regularly according to the“Maintenance
Schedule”in this manual.
Front Prop Shaft Lubrication
Lubricate the front driveshaft grease fitting at each oil
change listed in the appropriate Maintenance Schedule
for your vehicle (Schedule“A”and“B”). Use Mopar
type MS-6560 (lithium based grease), or equivalent.
Front Driveshaft Grease Fitting
368 MAINTAINING YOUR VEHICLE

Adding Fuel........................309,335
Air Cleaner, Engine (Engine Air Cleaner Filter) . 361,385
Air Conditioner Maintenance............... 365
Air Conditioning Refrigerant.............365,366
Air Conditioning System................203,365
Air Conditioning System, Zone Control........ 207
Air Pressure, Tires....................296,304
Airbag..............................47,53
Airbag Light.........................73,158
Airbag On/Off Switch..................... 53
Airbag, Side............................ 56
Alarm..............................31,161
Alignment and Balance................... 303
Alterations/Modifications, Vehicle............. 7
Antifreeze (Engine Coolant)..............374,406
Anti-Lock Warning Light...............162,284
Anti-Theft System.....................31,161
Appearance Care........................ 388
Ashtray............................... 140Automatic Transmission
Adding Fluid......................... 380
Fluid and Filter Changes................. 382
Fluid Level Check...................... 380
Fluid Type........................382,408
Shift Indicator........................ 161
Shifting............................. 270
Special Additives...................... 383
Axle Fluid.......................320,378,408
Axle Lubrication.....................320,378
Ball Joints............................. 367
Battery............................... 364
Emergency Starting..................... 344
Bearings.............................. 383
Belts, Drive............................ 360
Belts, Seat.............................. 36
Body Mechanism Lubrication............... 369
B-Pillar Location........................ 291
440 INDEX