key battery DODGE POWER WAGON 2005 2.G Owners Manual

Language Selection
To change the language that the UConnect™system is
using, press the’Phone’button and say the name of the
language you wish to switch to (English, Español, or
Français as equipped). After selecting one of the lan-
guages, all prompts and voice commands will be in the
selected language.
Turning Confirmation Prompts On/Off
Turning confirmation prompts off will stop the system
from confirming your choices (e.g. the UConnect™sys-
tem will not repeat a phone number before you dial it).
•Press the’Phone’button to begin.
•After theReadyprompt, saySetup Confirmation.
The UConnect™system will play the current confir-
mation prompt status and you will be given the choice
to change it.
Low Signal, Battery Strength, and Roam
Notification
The UConnect™system will provide notification to
inform you if your cellular phone is in roaming status,
has low signal strength, or has a low battery when you
are trying to place a phone call.
Dialing Using the Cellular Phone Keypad
You can dial a phone number with your cellular phone
keypad and still use the UConnect™system. By dialing a
number with your paired Bluetooth™cellular phone, the
audio will be played through your vehicle’s stereo sys-
tem. The UConnect™system will work the same as if
you dialed the number using voice recognition.
100 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Interior Lights
Courtesy/ dome lights are turned on when the front
doors are opened, when the dimmer control (rotating
wheel on the right side of the switch) is rotated to the
second upward detent position, or if equipped, when the
UNLOCK button is pressed on the key fob. Rotating the
dimmer control to the optional fully upward position willturn on the cargo light located on the back of the cab.
When a door is open and the interior lights are on,
rotating the dimmer control all the way down to the OFF
detent will cause all the interior lights to go out. This is
also known as thePartymode because it allows the
doors to stay open for extended periods of time without
discharging the vehicle’s battery.
The brightness of the instrument panel lighting can be
regulated by rotating the dimmer control up (brighter) or
down (dimmer). When the headlights are ON you can
supplement the brightness of the odometer, trip odom-
eter, radio and overhead console by rotating the control
up until you hear a click. This feature is termed the
“Parade”mode and is useful when headlights are re-
quired during the day.
110 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

For states which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)
is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle’s OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL light will blink for approximately 5 sec-
onds and then remain on until the first engine crank or
the key is turned off. This means that your vehicle’s
OBD system isnot readyand you shouldnotproceed
to the I/M station.
354 MAINTAINING YOUR VEHICLE

b. The MIL light will remain fully illuminated until the
first engine crank or the key is turned off. This means
that your vehicle’s OBD system isreadyand you can
proceed to the I/M station.
If your OBD system isnot ready,you should see your
dealer or repair facility. If your vehicle was recently
serviced or had a battery failure or replacement, you may
need to do nothing more than drive your vehicle as you
normally would in order for your OBD system to update.
A recheck with the above test routine may then indicate
that the system is now ready.
Regardless of whether your vehicle’s OBD system is
ready or not ready, if the MIL symbol is illuminated
during normal vehicle operation, you should have your
vehicle serviced before going to the I/M station. The I/M
station can fail your vehicle because the MIL symbol is on
with the engine running.DEALER SERVICE
Your dealer has the qualified service personnel, special
tools and equipment to perform all service operations in
an expert manner. Service manuals are available which
include detailed service information for your vehicle.
Refer to these manuals before attempting any procedure
yourself.
NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
MAINTAINING YOUR VEHICLE 355
7

Infant Restraint.......................... 59
Inflation Pressure Tires.................... 304
Inside Rearview Mirror.................... 84
Instrument Cluster....................156,157
Instrument Panel and Controls.............. 155
Instrument Panel Lens Cleaning............. 392
Interior Appearance Care.................. 391
Intermittent Wipers...................... 116
Introduction............................. 4
Jack Location........................... 336
Jack Operation.......................... 338
Jump Starting.......................... 344
Key, Replacement........................ 14
Key, Sentry............................. 13
Key-In Reminder......................... 12
Keyless Entry System...................... 24
Keys................................12,18Lane Change and Turn Signals.............. 113
Lap Belts.............................. 44
Lap/Shoulder Belts....................... 36
LATCH (Lower Anchors and Tether for CHildren) . 63
Lights..............................74,109
Airbag............................58,158
Anti-Lock Warning..................162,284
Battery Saver......................... 111
Brake Warning........................ 162
Bulb Replacement...................... 394
Cap Top Clearance..................... 402
Center Mounted Stop................... 400
Check Engine......................... 157
Courtesy/Reading..................... 122
Cruise.............................. 161
Daytime Running...................... 112
Dual Wheel Assembly Rear............... 403
Fog ............................. 113,405
Four-Wheel Drive Indicator............... 280
446 INDEX

Hazard Warning Flasher................. 334
Headlights........................... 111
High Beam........................ 115,158
High Beam Indicator.................... 158
High Beam/Low Beam Select.............. 115
Instrument Cluster..................... 157
Intensity Control....................... 110
Interior........................... 110,122
Lights On Reminder.................... 113
Low Washer Fluid..................... 164
Passing............................. 114
Seat Belt Reminder..................... 159
Service.............................. 394
Transfer Case......................... 280
Transmission Warning................165,327
Turn Signal.................. 113,158,394,398
Warning (Instrument Cluster Description)..... 157
Limited-Slip Differential................281,379
Loading Vehicle......................... 315Tires ............................... 291
Locks................................. 18
Child Protection........................ 23
Door................................ 18
Ignition.............................. 15
Keys................................ 12
Power Door........................... 19
Steering Wheel......................... 15
Lower Anchors and Tether for CHildren (LATCH) . 63
Lubricants............................. 383
Lubrication, Body....................... 369
Lug Nuts............................. 341
Lumbar Support........................ 105
Maintenance........................... 356
Maintenance Free Battery.................. 364
Maintenance Procedures................... 356
Maintenance Schedule.................... 410
ScheduleA......................... 424
INDEX 447
10