Window regulator DODGE RAM 1999 Service User Guide

Fig. 9: Removing Window Motor & Regulator Mounting Screws (Ram
Pickup)
Courtesy of Chrysler Corp.
NOTE: On Ram Van and Ram Wagon, power window motor is integral to
window regulator unit. If power window motor is faulty,
entire window regulator must be replaced.
Removal & Installation (Ram Van & Ram Wagon)
1) Remove door trim panel. See DOOR TRIM PANEL. Remove inside
door handle actuator. Disconnect window motor wire connector. Remove
watershield. Remove inner and outer belt weatherstrip from door.
2) Lower glass enough to expose window glass-to-regulator
bolts. Loosen window glass-to-regulator bolts. Loosen bolts at front
and rear glass channels. Lift glass upward while rotating forward to
remove.
3) Remove bolts attaching window regulator to inner door
panel. Remove window regulator assembly. To install, reverse removal
procedure. Tighten window glass-to-regulator bolts to 96 INCH lbs. (11
N.m).
POWER VENT WINDOW MOTOR
Removal & Installation (Caravan, Town & Country, & Voyager)
Remove "D" pillar trim panel. See "D" PILLAR TRIM PANEL.