garage door opener DODGE RAM 2500 DIESEL 2004 3.G Owners Manual

NTo Set At A Desired Speed...............110
NTo Deactivate........................110
NTo Resume Speed.....................110
NTo Vary The Speed Setting...............111
NTo Accelerate For Passing...............111
mOverhead ConsoleÐ If Equipped...........112
NCourtesy/Reading Lights................113
mOverhead Console With Compass/Temperature
Mini-Trip Computer Ð If Equipped..........113
NUS/M Button........................114
NReset Button.........................114
NGlobal Reset.........................115
NStep Button.........................115NAverage Fuel Economy (AVG ECO)........115
NDistance To Empty (DTE)...............115
NTrip Odometer (ODO)..................116
NElapsed Time (ET).....................116
NC/T Button.........................117
NAutomatic Compass Calibration...........117
NManual Compass Calibration.............118
NTo Put Into a Calibration Mode...........118
NOutside Temperature...................119
mGarage Door Opener Ð If Equipped.........120
NProgramming Homelink................121
NCanadian Programming/Gate Programming . . 123
NUsing Homelink......................124
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 73
3

Vehicles equipped with a 4±speed automatic transmis-
sion may exhibit several 4-3 downshifts under the above
conditions. To reduce the frequency of the downshifts
and to improve vehicle performance, it is advisable to
lock out overdrive by pressing the O/D OFF button
located at the end of the gear shifter.
WARNING!
Speed Control can be dangerous where the system
can't maintain a constant speed. Your vehicle could
go too fast for the conditions, and you could lose
control. An accident could be the result. Don't use
Speed Control in heavy traffic or on roads that are
winding, icy, snow-covered, or slippery.
OVERHEAD CONSOLEÐ IF EQUIPPED
The two optional overhead consoles may consist of the
following features:
²Courtesy/Reading Lights
²Compass/Temperature Mini-Trip Computer
(CMTC) Ð If Equipped
²Universal Garage Door Opener Ð If Equipped
112 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

GARAGE DOOR OPENER Ð IF EQUIPPED
The HomeLinktUniversal Transceiver replaces up to
three remote controls (hand held transmitters) that oper-
ate devices such as garage door openers, motorized
gates, or home lighting. It triggers these devices at the
push of a button. The Universal Transceiver operates off
your vehicle's battery and charging system; no batteries
are needed.For additional information on HomeLinkt, call 1±800±
355±3515, or on the internet at www.homelink.com.
WARNING!
A moving garage door can cause injury to people and
pets in the path of the door. People or pets could be
seriously or fatally injured. Only use this transceiver
with a garage door opener that has a ªstop and
reverseº feature as required by federal safety stan-
dards. This includes most garage door opener mod-
els manufactured after 1982. Do not use a garage
door opener without these safety features it could
cause injury or death. Call toll-free 1±800±355±3515
or, on the Internet at www.homelink.com for safety
information or assistance.
120 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Programming HomeLink
NOTE:When programming a garage door opener, it is
advised to park outside the garage. It is also recom-
mended that a new battery be placed in the hand-held
transmitter of the device being programmed to
HomeLink for quicker training and accurate transmis-
sion of the radio-frequency signal.
1. Press and hold the two outer HomeLink buttons, and
release only when the indicator light begins to flash (after
20 seconds).Do nothold the buttons for longer than 30
seconds anddo notrepeat step one to program a second
and/or third hand-held transmitter to the remaining two
HomeLink buttons.
WARNING!
Vehicle exhaust contains carbon monoxide, a danger-
ous gas. Do not run the vehicle's exhaust while
training the transceiver. Exhaust gas can cause seri-
ous injury or death.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 121
3

WARNING!
Your motorized door or gate will open and close
while you are training the Universal Transceiver. Do
not train the transceiver if people or pets are in the
path of the door or gate. A moving door or gate can
cause serious injury or death to people and pets or
damage to objects.
2. Position the end of your hand-held transmitter 1-3
inches (3-8 cm) away from the HomeLink buttons while
keeping the indicator light in view.
3. Simultaneously press and hold both the HomeLink
button that you want to train and the hand-held trans-
mitter buttons.Do not release the buttons until step 4
has been completed.NOTE:Some gate operators and garage door openers
may require you to replace this Programming Step 3 with
procedures noted in the9Gate Operator/Canadian Pro-
gramming9section.
4. The HomeLink indicator light will flash slowly and
then rapidly after HomeLink successfully receives the
frequency signal from the hand-held transmitter. Release
both buttons after the indicator light changes from the
slow to the rapid flash.
5. Press and hold the just trained HomeLink button and
observe the indicator light. If the indicator lightstays on
constantly, programming is completeand your device
should activate when the HomeLink button is pressed
and released.
NOTE:To program the remaining two HomeLink but-
tons, begin with9Programming9step two. Do not repeat
step one.
122 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

If the indicator light blinksrapidly for two seconds and
then turns to a constant light, continue with(Program-
ming(steps 6-8to complete the programming of a rolling
code equipped device (most commonly a garage door
opener).
6. At the garage door opener receiver (motor-head unit)
in the garage, locate the9learn9or9smart9button. This
can usually be found where the hanging antenna wire is
attached to the motor-head unit.
7. Firmly press and release the9learn9or9smart9button.
(The name and color of the button may vary by manu-
facturer.)
NOTE:There are 30 seconds in which to initiate step
eight.
8. Return to the vehicle and firmlypress, hold for two
seconds and releasethe programmed HomeLink button.
Repeat the(press/hold/release(sequence a second time,and, depending on the brand of the garage door opener
(or other rolling code equipped device), repeat this
sequence a third time to complete the programming.
HomeLink should now activate your rolling code
equipped device.
NOTE:To program the remaining two HomeLink but-
tons, begin with9Programming9step two. Do not repeat
step one. For questions or comments, please contact
HomeLink atwww.homelink.com or 1-800-355-3515.
Canadian Programming/Gate Programming
Canadian radio-frequency laws require transmitter sig-
nals to9time-out9(or quit) after several seconds of
transmission which may not be long enough for
HomeLink to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to9time-out9in the same manner.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 123
3

If you live in Canada or you are having difficulties
programming a gate operator by using the9Program-
ming9procedures (regardless of where you live),replace
(Programming HomeLink(step 3with the following:
NOTE:If programming a garage door opener or gate
operator, it is advised to unplug the device during the
9cycling9process to prevent possible overheating.
3. Continue to press and hold the HomeLink button
while youpress and release every two seconds(9cycle9)
your hand-held transmitter until the frequency signal has
successfully been accepted by HomeLink. (The indicator
light will flash slowly and then rapidly.) Proceed with
9Programming9step four to complete.
Using HomeLink
To operate, simply press and release the programmed
HomeLink button. Activation will now occur for the
trained device (i.e. garage door opener, gate operator,
security system, entry door lock, home/office lighting,etc.). For convenience, the hand-held transmitter of the
device may also be used at any time. In the event that
there are still programming difficulties or questions,
contact HomeLink at:www.homelink.com or 1-800-355-
3515.
Erasing HomeLink Buttons
To erase programming from the three buttons (individual
buttons cannot be erased but can be9reprogrammed9-
note below), follow the step noted:
²Press and hold the two outer HomeLink buttons until
the indicator light begins to flash-after 20 seconds.
Release both buttons. Do not hold for longer that 30
seconds. HomeLink is now in the train (or learning)
mode and can be programmed at any time beginning
with9Programming9- step 2.
124 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Used Coolant......................... 346
Door Ajar............................. 145
Door Locks............................. 16
Door Opener, Garage..................... 120
Draining Fuel/Water Separator Filter.......... 334
Drive Belts............................ 331
Dual Rear Wheels.....................263,306
Electric Rear Window Defrost..........78,191,195
Electrical Power Outlets................... 126
Electronic Speed Control................... 109
Emergency Brake........................ 238
Emergency, In Case of
Freeing Vehicle When Stuck............... 313
Hazard Warning Flasher................. 296
Jacking............................. 300
Jump Starting......................... 310
Tow Hooks.......................... 314
Towing............................. 315Emission Control System Maintenance......... 384
Engine............................... 320
Air Cleaner.......................... 331
Block Heater.......................205,212
Break-In Recommendations................ 67
Compartment......................... 320
Coolant..........................345,380
Cooling............................. 343
Data Plate........................... 294
Identification......................... 320
Idling.............................. 214
Jump Starting......................... 310
Oil ..............................325,380
Oil Synthetic......................... 214
Runaway............................ 264
Temperature Gauge..................... 146
Ethylene Glycol Antifreeze................. 345
Exhaust Gas Caution................69,136,342
Exhaust System....................69,342,358
INDEX 415
10

Exterior Lighting........................ 101
Fan .................................. 347
Filters
Engine Oil.....................325,328,380
Flashers
Turn Signal.......................... 103
Flat Tire Stowage.....................299,309
Fluid, Brake........................... 381
Fluid Capacities......................... 379
Fluid Level Checks
Brake............................... 348
Manual Transmission................... 352
Power Steering........................ 339
Transfer Case......................... 352
Fog Lights..........................102,378
Fold Flat Load Floor..................... 130
Four Wheel Drive....................... 226
Four-Way Hazard Flasher.................. 296Freeing A Stuck Vehicle................... 313
Front Axle..........................340,351
Fuel..............................264,297
Diesel.........................264,297,380
Gauge.............................. 149
Requirements......................... 264
Specifications......................... 267
Tank Capacity........................ 379
Fuses................................ 366
Garage Door Opener..................... 120
Gauges............................... 150
Coolant Temperature.................... 146
Fuel................................ 149
Oil Pressure.......................... 145
Speedometer......................... 145
Tachometer.......................... 144
Voltmeter............................ 144
Gear Ranges........................... 218
416 INDEX

Trailer Towing......................79,279
Modifications/Alterations, Vehicle............. 7
Mopar Parts.........................322,407
Multi-Function Control Lever............... 103
New Vehicle Break-In Period................ 67
Noise Control
Maintenance.......................... 357
Tampering Prohibited................... 358
Noise Emission Warranty...............357,359
Occupant Restraints....................... 33
Odometer..........................148,149
Trip .............................148,149
Off-Pavement Driving.................... 292
Off-Road Driving........................ 292
Oil, Engine............................ 380
Capacity............................ 379
Change Interval....................... 326Dipstick............................. 325
Disposal............................ 331
Filter.........................325,328,380
Pressure Gauge....................... 145
Recommendation...................... 327
Viscosity............................ 327
Oil Filter, Change........................ 328
Onboard Diagnostic System................ 321
Opener, Garage Door..................... 120
Operating Precautions.................... 321
Outside Rearview Mirrors.................. 76
Overdrive............................. 220
Overdrive OFF Switch.................... 220
Overhead Console.................... 112,113
Overhead Travel Information Center.......... 113
Owner's Manual........................ 408
Parking Brake.......................... 238
Passenger Airbag On/Off Switch............. 50
420 INDEX