garage door opener DODGE RAM 2500 DIESEL 2009 4.G Owners Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 2009, Model line: RAM 2500 DIESEL, Model: DODGE RAM 2500 DIESEL 2009 4.GPages: 532, PDF Size: 9.37 MB
Page 82 of 532
▫Automatic Compass Calibration ......... 151
▫ Manual Compass Calibration ........... 151
▫ Recalibrating The Compass ............ 151
▫ Outside Temperature ................ 153
Garage Door Opener — If Equipped ....... 153
▫ Programming HomeLink ............. 154
▫ Gate Operator/Canadian Programming . . . 157
▫ Using HomeLink .................. 158
▫ Reprogramming A Single HomeLink
Button ............................ 158
▫ Security .......................... 158
▫ Troubleshooting Tips ................. 158
▫ General Information ................. 159
Power Sunroof — If Equipped ........... 159
▫ Open Sunroof — Express Mode ......... 160
▫ Closing Sunroof — Express ............ 160
▫ Pinch Protect Feature ................ 160
▫ Pinch Protect Override ............... 161
▫ Venting Sunroof — Express ............ 161
▫ Sunshade Operation ................. 161
▫ Wind Buffeting ..................... 161
▫ Sunroof Maintenance ................ 162
▫ Sunroof Fully Closed ................ 162
Electrical Power Outlets ................ 162
Cigar Lighter And Ash Receiver .......... 164
Cupholders ......................... 165
80 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 147 of 532
OVERHEAD CONSOLE — IF EQUIPPEDThe two optional overhead consoles may consist of the
following features:•
Courtesy/Reading Lights
•
Compass/Temperature Mini-Trip Computer
(CMTC) — If Equipped
•
Universal Garage Door Opener — If Equipped
Courtesy/Reading LightsIn the middle of the console are two courtesy/reading
lights.
Both lights illuminate as courtesy lights when a door is
opened, when the dimmer control is rotated to the
courtesy light position (fully-upward position), or when
the UNLOCK button is pressed on the Remote Keyless
Entry (RKE) transmitter, if equipped. These lights are also
operated individually as reading lights by pressing the
recessed area of the corresponding lens.
NOTE:The courtesy/reading lights will remain on until
the switch is pressed a second time, so be sure they have
been turned off before leaving the vehicle. If the interior
lights are left on after the vehicle is turned off, they will
extinguish after 15 minutes.
Overhead Console Features
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 145
3
Page 155 of 532
RESET button approximately five seconds. The last vari-
ance zone number will be displayed. Press the STEP
button to select the new variance zone and press the
RESET button to resume normal operation.Outside TemperatureBecause the ambient temperature sensor is located under
the hood, engine temperature can influence the displayed
temperature, therefore, temperature readings are slowly
updated when the vehicle speed is below 20 mph
(30 km/h) or during stop and go driving.GARAGE DOOR OPENER — IF EQUIPPEDHomeLinkreplaces up to three remote controls (hand-
held transmitters) that operate devices such as garage
door openers, motorized gates, lighting, or home security
systems. The HomeLink unit operates off of your vehi-
cle’s battery. The HomeLink
buttons are located in the overhead
console, and contain one, two, or three dots/lines desig-
nating the different HomeLink channels.
NOTE: HomeLink is disabled when the Vehicle Theft
Alarm is active.
HomeLink Buttons
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 153
3
Page 156 of 532
WARNING!
•
Your motorized door or gate will open and close
while you are training the Universal Transceiver.
Do not train the transceiver if people or pets are in
the path of the door or gate. Only use this trans-
ceiver with a garage door opener that has a “stop
and reverse” feature as required by federal safety
standards. This includes most garage door opener
models manufactured after 1982. Do not use a
garage door opener without these safety features.
Call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for safety information or as-
sistance.
•
Vehicle exhaust contains carbon monoxide, a dan-
gerous gas. Do not run your vehicle in the garage
while training the transceiver. Exhaust gas can
cause serious injury or death.
Programming HomeLink
Before You BeginThe Compass Mini-Trip Computer (CMTC) illuminates
the HomeLink symbol (a house with an arrow inside it)
along with 1, 2 or 3 indicators under it, when a
HomeLink button is pressed.
Pay attention to the indicator(s), as they will flash at
different rates, or remain solid during training.
If you have not trained any of the HomeLink buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for
20 seconds. Release the buttons when the indicators start
to flash.
It is recommended that a new batterybe placed in the
hand-held transmitter of the device being programmed
to HomeLink for more efficient training and accurate
transmission of the radio-frequency signal.
154 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 157 of 532
Your vehicle should be parked outside of the garage
while training.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to
8 cm) from the HomeLinkbuttons while keeping the
HomeLink display in view.
For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink.
3. Simultaneously, press and hold both the chosen
HomeLinkbutton and the hand-held transmitter button
until the indicator(s) change from a slow to a rapid flash
rate.
Then release both the HomeLink and hand-held trans-
mitter buttons.
It may take up to 30 seconds or longer in rare cases. The
garage door may open and close while you train. If the signal is too weak to train, replace the battery in the
original hand-held transmitter.
NOTE:
Some gate operators and garage door openers
may require you to replace Step #3 with procedures
noted in the “Gate Operator/Canadian Programming”
section.
4. Press and hold the just-trained HomeLink button. If
the indicator(s) blink rapidly for two seconds and then
remains constant, continue with the next section: “Pro-
gramming A Rolling Code System”.
NOTE: After training a HomeLink channel, if the
garage door does not operate with HomeLink and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading, “Programming A Rolling Code System.”
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 155
3
Page 158 of 532
5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the “learn” or “training” button.
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).6. Firmly press and release the “learn” or “training”
button. The name and color of the button may vary by
manufacturer.
NOTE:There are 30 seconds in which to initiate the next
step after the “Learn” button has been pressed.
1 — Garage Door Opener
2 — Training Button
156 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 159 of 532
7. Return to the vehicle and press the programmed
HomeLinkbutton twice (holding the button for two
seconds each time). If the device is plugged in and
activates, programming is complete.
If the device does not activate, press the button a third
time (for two seconds) to complete the training.
If you are have any problems, or require assistance,
please call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.Gate Operator/Canadian ProgrammingCanadian radio-frequency laws require transmitter sig-
nals to “time-out” (or quit) after several seconds of
transmission – which may not be long enough for
HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are
designed to “time-out” in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink,” Step 3, with the following:
3. Continue to press and hold the HomeLink
button,
while you press and release )“cycle”), your hand-held
transmitter every two seconds until HomeLink has
successfully accepted the frequency signal. The indica-
tor(s) will change from a slow flash to a rapid flash
when trained.
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under, “Programming
HomeLink,” earlier in this section.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157
3
Page 160 of 532
Using HomeLinkTo operate, simply press and release the programmed
HomeLinkbutton. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.) The hand-held transmitter of the device may also be
used at any time.Reprogramming A Single HomeLink ButtonTo reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button for
20 seconds until the indicator(s) starts to flash. Do not
release the button.
3. Without releasing the button, proceed with Program-
ming Homelink, Step #2, and follow all remaining steps.
SecurityIt is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the indicators begin to flash. Note that
all channels will be erased. Individual channels cannot be
erased.
The HomeLink Universal Transceiver is disabled when
the Vehicle Theft Alarm is active.Troubleshooting TipsIf you are having trouble programming HomeLink, here
are some of the most common solutions:•
Replace the battery in the original transmitter.
•
Press the “Learn” button on the garage door opener to
complete the training for Rolling Code.
158 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 515 of 532
Dealer Service.......................... 430
Defroster, Rear Window ................... 172
Defroster, Windshield ................76,235,238
Delay (Intermittent) Wipers ................. 138
Differential, Limited-Slip .................. 304
Dipsticks Automatic Transmission ................. 450
Power Steering ........................ 328
Disposal Antifreeze (Engine Coolant) ............... 445
Door Locks ............................. 27
Door Opener, Garage ..................... 153
Driving Off-Pavement ......................... 284
Off-Road ............................ 284
Through Flowing, Rising, or Shallow Standing
Water .............................. 305
Dual Rear Wheels ..................... 365,416
DVD Player (Video Entertainment System™) .... 231Electric Rear Window Defrost
............... 172
Electrical Power Outlets ................... 162
Electronic Brake Control System ............. 333
Anti-Lock Brake System ................. 333
Brake Assist System .................... 335
Electronic Roll Mitigation ................ 339
Electronic Stability Program ............... 340
Traction Control System ................. 334
Electronic Roll Mitigation (ERM) ............. 339
Electronic Speed Control (Cruise Control) ...... 142
Electronic Stability Program (ESP) .........197,340
Electronically Shifted Transfer Case ........264,272
Emergency Brake ........................ 329
Emergency, In Case of Freeing Vehicle When Stuck ............... 421
Hazard Warning Flasher ................. 406
Jacking ............................. 409
Jump Starting ......................... 419
Tow Hooks .......................... 422
INDEX 513
10
Page 517 of 532
Fluids, Lubricants and Genuine Parts.......... 479
Fog Lights ....................... 135,193,468
Fold Flat Load Floor ..................... 174
Four Wheel Drive ....................... 260
Four-Way Hazard Flasher .................. 406
Freeing A Stuck Vehicle ................... 421
Front Axle (Differential) ................... 448
Fuel ................................. 375
Adding ............................. 379
Filler Cap (Gas Cap) .................... 381
Gauge .............................. 200
Octane Rating ...................... 375,479
Requirements ...................... 375,478
Tank Capacity ........................ 478
Fuses ................................ 458
Garage Door Opener (HomeLink) ........... 153
Gas Cap (Fuel Filler Cap) ...............381,428
Gasoline (Fuel) ......................... 375 Gasoline, Reformulated
................... 375
Gauges ............................... 188
Coolant Temperature ................... 190
Fuel ............................... 200
Oil Pressure .......................... 190
Speedometer ......................... 189
Tachometer .......................... 189
Voltmeter ............................ 188
Gear Ranges ........................... 255
General Information ................. 18,114,374
Glass Cleaning .......................... 456
Grocery Bag Retainer ..................... 172
Gross Axle Weight Rating .................. 384
Gross Vehicle Weight Rating ................ 384
Guide, Body Builders ...................... 6
GVWR ............................... 381
Hands-Free Phone (uconnect) ............... 86
INDEX 515
10