key DODGE VIPER 2005 ZB / 2.G Owner's Manual

Before leaving the vehicle, make sure you fully apply the
parking brake. Place the transmission in REVERSE. Fail-
ure to do so may cause the vehicle to roll and cause
damage or injury.
As an added precaution, turn the front wheels toward the
curb on a downhill grade and away from the curb on an
uphill grade.
Always apply the parking brake whenever you are not in
the vehicle.WARNING!
Leaving children in a vehicle unattended is danger-
ous for a number of reasons. A child or others could
be injured. Children should be warned not to touch
the parking brake release lever or the gear selection
lever as doing so may move the vehicle. Don’t leave
the keys in the ignition. Be sure the parking brake is
fully disengaged before driving: failure to do so can
lead to brake failure, and an accident.
BRAKE SYSTEM
The Anti-Lock Brake System (ABS) is designed to aid the
driver in maintaining vehicle control under adverse
braking conditions. The system operates with a separate
computer to modulate hydraulic pressure to prevent
wheel lock-up and help avoid skidding on slippery
surfaces.
STARTING AND OPERATING 117
5

HAZARD WARNING FLASHER
The flasher switch is on the top of the steering
column, just behind the steering wheel. Depress
the flasher button and all front and rear directional
signals will flash. Depress the flasher button again to turn
the flashers off.Do not use this emergency warning system when the
vehicle is in motion. Use it when your vehicle is disabled
and is creating a safety hazard for other motorists.
If it is necessary to leave the vehicle to go for service, the
flasher system will continue to operate with the ignition
key removed.
NOTE:With extended use, the flasher may run down
your battery.
IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the
potential for overheating by taking the appropriate ac-
tion.
•On the highways—Slow down and use the highest
gear possible.
•In city traffic—While stopped, put the transmission
in neutral, but do not increase engine idle speed.
Hazard Flasher Switch
148 WHAT TO DO IN EMERGENCIES

EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)
is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle’s OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn off the
162 MAINTAINING YOUR VEHICLE

ignition key or start the engine. This means that your
vehicle’s OBD system isnot readyand you shouldnot
proceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn off the ignition key or start
the engine. This means that your vehicle’s OBD system
isreadyand you can proceed to the I/M station.
If your OBD system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD
system to update. A recheck with the above test routine
may then indicate that the system is now ready.
Regardless of whether your vehicle’s OBD system is
ready or not ready, if the MIL symbol is illuminated
during normal vehicle operation, you should have yourvehicle serviced before going to the I/M station. The I/M
station can fail your vehicle because the MIL symbol is on
with the engine running.
REPLACEMENT PARTS
Use of genuine Moparparts for normal/scheduled
maintenance and repairs is highly recommended to in-
sure the designed performance. Damage or failures
caused by the use of non-Moparparts for maintenance
and repairs will not be covered by the manufacturer’s
warranty.
DEALER SERVICE
Your dealer has the qualified service personnel, special
tools and equipment to perform all service operations in
an expert manner. Service Manuals are available which
include detailed service information for your vehicle.
Refer to these manuals before attempting any procedure
yourself.
MAINTAINING YOUR VEHICLE 163
7

Start the battery save feature by doing the following:
1. Insert the key into the ignition.
2. Cycle the ignition from OFF to ACC four times with-
out going into ON. Leave the switch in the OFF position
after the fourth cycle.3. Depress the driver’s side Power Door Lock switch in
the UP direction. A single chime and a horn chirp indicate
that the process has begun.
4. Remove the key from the ignition and exit the vehicle.
5. The feature is cancelled when the ignition is cycled to
ON/RUN.
6. The vehicle will enter Battery Save Mode 45 seconds
after all doors are closed.
NOTE:The remote keyless entry and passenger exterior
door handle will not work when the Battery Save feature
is enabled. Enter the vehicle either by using the key to
open the door manually or by using the outside door
handle.
NOTE:The Vehicle Theft Alarm is disabled when the
vehicle is in Battery Save mode. Therefore, the vehicle is
not protected when the Battery Save feature is enabled.
Ignition Key Positions
MAINTAINING YOUR VEHICLE 175
7

NOTE:The exterior and interior lighting functions will
not work when the vehicle is in Battery Save Mode.
Exit Battery Save Mode by doing the following:
1. Press the driver’s door exterior handle to wake up the
vehicle.
2. If the door does not open (vehicle is armed) press the
remote keyless entry unlock button to unlock the vehicle.
3. Press the driver’s door exterior handle again to open
the door.
4. Cycle the Ignition to ON/RUN. If the ignition is NOT
cycled to ON/RUN, then the vehicle will re-enter Battery
Save Mode 45 seconds after the driver’s door is closed.Air Conditioner
Check the air conditioning system operation at the start
of the warm weather season.
NOTE:If air conditioning operation seems to be lower
than expected, check the front of the A/C condenser,
located in front of the radiator for dirt or insect accumu-
lation. Clean with a gentle water spray as required. Front
end fascia protectors may reduce air flow to the con-
denser and radiator, reducing A/C and engine cooling
performance.
176 MAINTAINING YOUR VEHICLE

High Intensity Discharge Headlights (HID)
The headlights are a type of high voltage discharge tube.
High voltage can remain in the circuit even with the
headlight switch off and the key removed.Because of
this, you should not attempt to service a headlight bulb
yourself. If a headlight bulb fails, take your vehicle to
an authorized dealer for service.
WARNING!
A transient high tension occurs at the bulb sockets of
High Intensity Discharge (HID) headlights when the
headlight switch is turned ON. It may cause serious
electrical shock or electrocution if not serviced prop-
erly. See your authorized dealer for service.
NOTE:If High Intensity Discharge (HID) lights are not
working, recycle the headlight switch 4 times to see if it
will restrike.
Tail, Tail/Stop, and Marker Lamp Bulb
Replacement
1. Open the trunk. Remove two access panel fasteners.
Remove the access panel.
MAINTAINING YOUR VEHICLE 207
7

Gas Caution.......................... 173
Jump Starting......................... 150
Keyless Transmitter Replacement............ 19
Bearings.............................. 194
Belt System, Six Point..................... 32
Belts, Drive............................ 168
Belts, Seat.............................. 26
Body Damage.......................... 195
Body Mechanism Lubrication............179,180
Body Mechanisms....................... 181
Boot, Convertible Top...................59,64
B-Pillar Location........................ 126
Brake, Parking.......................... 116
Brake System........................ 117,188
Anti-Lock............................ 117
Fluid Check.......................190,214
Hoses.............................. 189
Master Cylinder....................... 191
Warning Light......................... 91Break-In Recommendations, New Vehicle.....50,121
Bulb Replacement....................... 205
Bulbs, Light.........................204,205
Capacities, Antifreeze (Engine Coolant)........ 212
Capacities, Fluid........................ 212
Capacity, Cargo Weight................... 146
Caps, Filler
Power Steering........................ 178
Radiator (Coolant Pressure)............... 185
Car Washes............................ 197
Carbon Monoxide Warning...............51,145
Cargo Compartment
Capacity............................ 146
Carpeting............................. 196
Catalytic Converter...................... 168
CD Player............................95,98
CD Player Maintenance................... 103
Chains, Tire............................ 140
INDEX 245
10

Fuses................................ 197
GasCap .............................. 145
Gasoline.............................. 142
Gasoline, Clean Air...................... 142
Gasoline, Reformulated................... 142
Gasoline/Oxygenate Blends................ 143
Gauges................................ 92
Coolant Temperature..................90,92
Fuel................................ 93
Oil Pressure........................... 92
Speedometer.......................... 86
Tachometer........................... 92
Voltmeter............................ 93
General Information...................... 18
Glass Cleaning.......................... 195
Ground Clearance....................... 141
Hazard Warning Flasher.................87,148Headlights............................ 207
Aiming............................. 212
High Beam........................... 78
High Beam/Low Beam Select Switch......... 78
Passing.............................. 78
Switch............................... 75
Time Delay........................... 76
Heater............................... 104
High Beam Indicator...................... 89
Hood Latch Maintenance.................. 180
Hood Release........................... 71
Hoses.............................188,189
Hydraulic Clutch Fluid.................... 192
Ignition
Key ................................. 11
Timing.............................. 170
Wiring System........................ 170
Infant Restraint.......................... 34
INDEX 249
10

Inside Rearview Mirror.................... 67
Instrument Cluster........................ 86
Instrument Panel and Controls............... 85
Instrument Panel Lens Cleaning............. 195
Interior and Instrument Lights..........See Lights
Interior Lighting......................... 74
Interior Lights........................... 74
Intermittent Wipers....................... 82
Introduction............................. 4
Jump Starting.......................... 150
Key-In Reminder......................... 12
Keyless Entry System...................... 15
Keys.................................. 11
Knee Bolster............................ 41
Lap/Shoulder Belts....................... 27
LATCH (Lower Anchors and Tether for CHildren) . 36Latches
Hood.............................71,180
Lead Free Gasoline...................... 142
Light Bulbs............................ 205
Lights...............................52,73
Airbag.............................44,91
Anti-Lock Warning...................... 87
Back-Up............................. 74
Brake Warning......................... 91
Bulb Replacement...................... 204
Daytime Running....................... 76
Dimmer Switch, Headlight..............74,78
Engine Temperature Warning.............. 90
Exterior Check......................... 52
Fog .............................75,77,90
Hazard Warning Flasher...............87,148
Headlight Switch....................... 75
Headlights.........................75,207
High Beam........................... 78
250 INDEX