wheel DODGE VIPER 2006 ZB / 2.G Owner's Manual

▫Body Lubrication.....................186
▫Front And Rear Suspension Ball Joints......186
▫Steering Linkage......................187
▫Body Mechanism Lubrication.............187
▫Windshield Washers...................189
▫Exhaust System......................189
▫Cooling System.......................190
▫Hoses And Vacuum/Vapor Harnesses.......195
▫Brake System........................195
▫Brake, Power Steering, And Fuel System
Hoses.............................196
▫Brake And Clutch Fluid.................197
▫Master Cylinder......................197▫Hydraulic Clutch.....................198
▫Transmission........................198
▫Rear Axle...........................199
▫Wheel Bearings.......................200
▫Appearance Care.....................200

Fuses — Power Distribution Center..........203

Vehicle Storage........................208

Replacement Bulbs......................211
▫Interior Light Bulbs....................211
▫Exterior Light Bulbs — Convertible Models . . . 211
▫Exterior Light Bulbs — Coupe Models......212

Exterior Light Bulb Service................212
166 MAINTAINING YOUR VEHICLE

Parts that should not be lubricated are as follows:
•Generator bearings
•Drive belt
•Accessory drive belt idler pulley
•Idler arm assembly
•Front wheel bearing
•Rubber bushings
•Starter bearing
•Throttle control cable
•Water pump bearings
Windshield Washers
The fluid reservoir in the right side engine compartment
should be checked for fluid level at regular intervals. Fill
the reservoir with windshield antifreeze (not radiator
antifreeze).
Exhaust System
The best protection against carbon monoxide entry into
the vehicle body is a properly maintained engine exhaust
system.
If you notice a change in the sound of the exhaust system;
or if exhaust fumes can be detected inside the vehicle; or
when the underside or side of the vehicle is damaged;
have a competent mechanic inspect the complete exhaust
system and adjacent body areas for broken, damaged,
deteriorated, or mispositioned parts. Open seams or
loose connections could permit exhaust fumes to seep
into the passenger compartment. In addition, inspect the
exhaust system each time the vehicle is raised for lubri-
cation or oil change. Replace as required.
MAINTAINING YOUR VEHICLE 189
7

Fluid Level Check
The fluid in the transmission should be checked when-
ever other underhood services are done. Check the fluid
level by removing the fill plug located on the left side of
the transmission. The fluid level should be at the bottom
of the fill hole. Add fluid, if necessary, to maintain the
proper level.
Frequency of Fluid Change
Under normal operating conditions, the fluid installed at
the factory will give satisfactory lubrication for the life of
the vehicle. If the vehicle is operated under severe
conditions, change the fluid as specified in Maintenance
ScheduleB. If contaminated with water, the fluid should
be changed immediately.
Rear Axle
Fluid Level Check
Every 12 months or 6,000 miles (10 000 km) the exterior of
the axle should be checked for evidence of gear oil
leakage. This check should be made with the vehicle in a
level position, supported by the suspension, on an axle
and wheel type hoist, or on the ground. The axle fluid
level should be between the bottom of the filler plug and
a point approximately 3/8 inch (9.5mm) below the filler
plug.
Lubricant Selection
Use only the manufacturer’s recommended transmission
fluid. Refer to the Recommended Fluids, Lubricants and
Genuine Parts section for correct fluid type. This Limited
Slip Differential requires that a friction control additive
be added to the gear oil whenever a fluid change is made.
MAINTAINING YOUR VEHICLE 199
7

Frequency of Oil Change
Drain and fill the axle at the interval specified in the
Maintenance Schedules. Change the fluid immediately if
contaminated with water.
Wheel Bearings
Your Viper has permanently sealed wheel bearings that
do not require periodic maintenance.
Appearance Care
Your manufacturer’s dealer offers a complete line of
products for cleaning your Viper. Follow the instructions
on each container.
Leather or Vinyl Seat/Trim Care and Cleaning
Leather is best preserved by regular cleaning with a
damp soft cloth. Small particles of dirt can act as an
abrasive and damage the leather surface and should be
removed immediately with a damp cloth. Stubborn soils
can be removed easily with a soft cloth and Mopar Total
Clean or equivalent. Care should be taken to avoidsoaking the leather with any liquid. Please do not use
polishes, oils, cleaning fluids, solvents, detergents, or
ammonia based cleaners to clean the leather. Application
of a leather conditioner is not required to maintain the
original condition.
Paint and Trim
Your vehicle is exposed to the corrosive effects of chemi-
cal fall out, salt spray, and road film. To protect not only
the paint and trim, but also exposed mountings and
fixtures, it is important you wash it often and thoroughly.
After washing, allow all surfaces to drain and dry before
parking in a closed garage. Prompt washing may not
thoroughly remove these deposits. Additional cleaners
may be required. When using chemical cleaners formu-
lated for this purpose, be certain they are safe for use on
urethane painted surfaces.
200 MAINTAINING YOUR VEHICLE

Convertible Top Care — Convertible Models Only
Use a mild detergent to clean the top. Avoid heavy
scrubbing and rinse with plenty of clean water. Allow to
dry thoroughly before storage.
Carpeting
Vacuum your carpeting regularly to prevent a soil
buildup. Shampoo soiled carpeting with a reliable uphol-
stery cleaner, using a natural sponge or soft bristle brush.
After carpeting dries, vacuum it thoroughly.
Underbody Maintenance
The corrosive materials used for ice and snow removal or
dust control may accumulate on the underbody of your
vehicle. If not removed, these materials may accelerate
rusting and deterioration of underbody components such
as fuel lines, frame, floor pan, exhaust system, etc.
At least twice during the winter months hose down the
wheel wells and underside of the vehicle. Make sure youremove mud and salt from panels, crevices and ledges,
and that all drain holes and channels are free of debris.
NOTE:You can do more harm by hosing off the vehicle
without removing caked mud and debris.
The frame of your Viper is galvanized for rust-through
protection. It is also dipped in a black E-Coat to protect
the welded areas. Avoid any scratches through to bare
metal.
Commercial Car Washes
We do not recommend that you take your Viper through
a commercial car wash.
In the event that you do take your Viper to a commercial
car wash, move the Heater/Air Conditioning blower
control to the lowest setting. This will prevent the possi-
bility of water entering the system.
202 MAINTAINING YOUR VEHICLE

Check the battery every 4 to 6 weeks to ensure that the
voltage is above 12.40. Voltage will drop more rapidly
in hot temperatures. If battery voltage drops below
12.40, follow the battery recharge procedure in the
Service Manual.
•Check that the radiator coolant level of protection is to
at least -20°F (-29°C).
•Block the wheels. Do not apply the Parking Brake.
•Make sure that all tires are inflated to the optimum
pressure, (29 PSI).
•Cut blocks of plywood about the same size of the tires.
Cover each block with indoor/outdoor carpeting and
place them between the tires and concrete. This will
prevent tire flat spotting.
•For long term storage, remove the tires and put the
vehicle up on blocks. Stack the tires on plywood and
cover with a tarp to prevent flat spotting.
•Move the wiper blades away from the windshield.
NOTE:To help prevent the battery from discharging
during shorter periods of inactivity, perform the follow-
ing:
1. Make sure that the trunk/liftgate, hood, doors, win-
dows and convertible top are completely closed.
2. Make sure that remote transmitter is operating and
that the battery is good.
3. Make sure that the hood, trunk/liftgate and door
switches are in adjustment. Perform the quick system
check which follows.
Use the remote transmitter to set the alarm. If the alarm
SET light comes on and flashes, the system is operating
properly. If not, there is a problem with a switch or the
system. See your dealer for service.
210 MAINTAINING YOUR VEHICLE

Traction Grades
The traction grades, from highest to lowest, are A, B, and C,
and they represent the tire’s ability to stop on wet pave-
ment as measured under controlled conditions on specified
government test surfaces of asphalt and concrete. A tire
marked C may have poor traction performance.
WARNING!
The traction grade is based on braking (straight-
ahead) traction tests and does not include cornering
(turning) performance.
Temperature Grades
The temperature grades are A (highest), B, and C, repre-
senting the tire’s resistance to the generation of heat and
its ability to dissipate heat when tested under controlled
conditions on a specified indoor laboratory test wheel.
Sustained high temperature can cause the material of thetire to degenerate and reduce tire life, and excessive
temperature can lead to sudden tire failure. The grade C
corresponds to a level of performance which all passen-
ger car tires must meet under the Federal Motor Vehicle
Safety Standard No. 109. Grades B and A represent
higher levels of performance on the laboratory test wheel
than the minimum required by law.
WARNING!
The temperature grade is established for a tire that is
properly inflated and not overloaded. Excessive
speed, underinflation, or excessive loading, either
separately or in combination, can cause heat buildup
and possible tire failure.
248 IF YOU NEED CONSUMER ASSISTANCE

Power
Accessory Delay......................14,28
Brakes.............................. 125
Distribution Center..................... 203
Steering..........................129,185
Windows............................. 27
Pregnant Women and Seat Belts.............. 35
Programming Transmitters.................. 19
Radial Ply Tires......................... 141
Radiator Cap (Coolant Pressure Cap).......... 192
Radio Antenna.......................... 111
Radio Broadcast Signals.................... 98
Radio Operation......................... 111
Radio, Satellite.......................... 106
Radio (Sound Systems).................... 99
Rear Axle............................. 199
Rear Liftgate............................ 26
Rear Wheel Bearings..................... 200Rearview Mirrors........................ 69
Reclining Front Seats...................... 73
Reformulated Gasoline.................... 149
Refrigerant............................ 185
Reminder, Lights On...................... 78
Reminder, Seat Belt.....................33,93
Remote Keyless Entry..................... 16
Replacement Parts....................... 171
Replacement Tires....................... 143
Reporting Safety Defects................... 245
Restraints, Child......................... 36
Restraints, Infant......................... 36
Restraints, Occupant...................... 29
Rocking Vehicle When Stuck................ 163
Rotation, Tires.......................... 147
Run Flat Feature........................ 146
Safety Checks Inside Vehicle................. 53
Safety Checks Outside Vehicle............... 54
INDEX 259
10

Warranty Information..................... 245
Washer, Adding Fluid..................... 189
Washers, Windshield...................84,189
Wheel Alignment and Balance............... 145
Wheel Bearings......................... 200
Wind Buffeting.......................... 29
Windows.............................. 27
Power............................... 27
Windshield Defroster...................... 53
Windshield Washers....................84,189
Windshield Wipers....................... 84
Wipers, Intermittent....................... 85
Wiring, Ignition......................... 178
INDEX 263
10