ignition DODGE VIPER 2006 ZB / 2.G Service Manual

CAUTION!
It is essential when replacing the cables on the
battery that you attach the positive cable to the
positive post and the negative cable to the negative
post. Battery posts are marked positive (+) and
negative (-) and identified on the battery case. Cable
clamps should be tight on the terminal posts and
free of corrosion. Apply grease to post and clamps
after tightening. If using a “fast charger” while the
battery is in the vehicle, disconnect both vehicle
battery cables before connecting the charger to bat-
tery. Do not use a “fast charger” to provide starting
voltage.
Battery Save Feature
The Battery Save feature conserves battery power when
storing the vehicle up to 3 months without losing radio
and engine controller memory. This is an alternative to
disconnecting the battery.
NOTE:This vehicle is designed to sit in storage for up
to 30 days on a fully charged battery. If this vehicle is to
be stored for longer than 30 days the following is
recommended:
1. Disconnect the battery
2. Use the battery charger
3. Put the vehicle into Battery Save mode (3 month
charge).
Start the battery save feature by doing the following:
1. Insert the key into the ignition.
182 MAINTAINING YOUR VEHICLE

2. Cycle the ignition from OFF to ACC four times with-
out going into ON. Leave the switch in the OFF position
after the fourth cycle.
3. Depress the driver’s side Power Door Lock switch in
the UP direction. A single chime and a horn chirp indicate
that the process has begun.4. Remove the key from the ignition and exit the vehicle.
5. The feature is cancelled when the ignition is cycled to
ON/RUN.
6. The vehicle will enter Battery Save Mode 45 seconds
after all doors are closed.
NOTE:The remote keyless entry and passenger exterior
door handle will not work when the Battery Save feature
is enabled. Enter the vehicle either by using the key to
open the door manually or by using the outside door
handle.
NOTE:The Vehicle Theft Alarm is disabled when the
vehicle is in Battery Save mode. Therefore, the vehicle is
not protected when the Battery Save feature is enabled.
NOTE:The exterior and interior lighting functions will
not work when the vehicle is in Battery Save Mode.
Exit Battery Save Mode by doing the following:
Ignition Key Positions
MAINTAINING YOUR VEHICLE 183
7

1. Press the driver’s door exterior handle to wake up the
vehicle.
2. If the door does not open (vehicle is armed) press the
remote keyless entry unlock button to unlock the vehicle.
3. Press the driver’s door exterior handle again to open
the door.
4. Cycle the Ignition to ON/RUN. If the ignition is NOT
cycled to ON/RUN, then the vehicle will re-enter Battery
Save Mode 45 seconds after the driver’s door is closed.
Air Conditioner
Check the air conditioning system operation at the start
of the warm weather season.
NOTE:If air conditioning operation seems to be lower
than expected, check the front of the A/C condenser,
located in front of the radiator for dirt or insect accumu-
lation. Clean with a gentle water spray as required. Frontend fascia protectors may reduce air flow to the con-
denser and radiator, reducing A/C and engine cooling
performance.
WARNING!
•Use only refrigerants and compressor lubricants
approved by the manufacturer for your air condi-
tioning system. Some unapproved refrigerants are
flammable and can explode, injuring you. Other
unapproved refrigerants or lubricants can cause
the system to fail, requiring costly repairs. Refer
to Section 3 of the Warranty Information book for
further warranty information.
•The air conditioning system contains refrigerant
under high pressure. To avoid risk of personal
injury or damage to the system, adding refrigerant
or any repair requiring lines to be disconnected
should be done by an experienced repairman.
184 MAINTAINING YOUR VEHICLE

Cavity Fuse Circuits
5 Cartridge
Fuse 30
Amp
GreenIgnition Switch (Run &
Accessory)-(Downstream)
6 Cartridge
Fuse 40
AmpBatt
7 Cartridge
Fuse 30
Amp
GreenBatt-Relay Contact, ABS Pump
Motor
8 Cartridge
Fuse 30
Amp
GreenBatt-Motor, Wiper
9 Cartridge
Fuse 40
AmpBatt-FuseblockCavity Fuse Circuits
10 Cartridge
Fuse 30
Amp
GreenBatt-Switch, Ignition (Run/Start/
Accy)
11 Mini
Fuse 25
Amp
ClearBatt-Relay Contact, Auto Shut-
down
12 Mini
Fuse 20
Amp
YellowSecondary Power Outlet Feed
13 Mini
Fuse 15
Amp
BlueBatt-Flasher, Hazard
MAINTAINING YOUR VEHICLE 205
7

Cavity Fuse Circuits
23, 24 Mini
Fuse 10
Amp RedAirbag, Ignition Run
25-29 ISO RE-
LAYBatt-Relay Contact, High Blower
Motor
30-34 MICRO
RELAYBatt-Relay-Starter Contact to So-
lenoid
35-39 MICRO
RELAYFeed-Auto Shutdown Relay Coil
40-44 MICRO
RELAYFeed-Horn (From Relay)
45-49 MICRO
RELAYBatt-Relay-Headlamps
50-54 MICRO
RELAYRelay-A/C Clutch Output from
Relay Contact (B+)
55-59 MICRO
RELAYLeft/Right Downstream Oxygen
Sensor Output Feed FRCavity Fuse Circuits
60, 61 Mini
Fuse 15
Amp
BlueIgnition Start/Run Relay Coil
62, 63 Mini
Fuse 15
Amp
BlueIgnition Start/Run Gauges
64, 65 Mini
Fuse 10
Amp RedIgnition Start/Run Airbag
66, 67 Mini
Fuse 20
Amp
YellowFeed-Ign Run/Acc Wiper Switch
MAINTAINING YOUR VEHICLE 207
7

Miles 57,000 60,000 63,000 66,000 69,000 72,000
(Kilometers) (95 000) (100 000) (105 000) (110 000) (115 000) (120 000)
Change engine oil and engine oil filter, if not replaced
at 3 months.XXXXX X
Lubricate the front and rear suspension ball joints. X
Change the front and rear axle fluid. X X
Inspect the brake linings. X X
Inspect and replace, if necessary, theair cleaner filter.X
Replace thespark plugs.X
Replace theignition cables.X
Inspect and replace, if necessary, thePCV orifice.
*X
Inspect and replace the Auto Tension Drive Belt as
needed.X
Change the brake and clutch fluid. X
Change the transmission fluid. X
Flush and replace engine coolant at 60 months, if not
done at 102,000 miles.X
SCHEDULE “B” 233
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 42,000 48,000 54,000 60,000 66,000
(Kilometers) (70 000) (80 000) (90 000) (100 000) (110 000)
[Months] [42] [48] [54] [60] [66]
Change engine oil and engine oil filter. X X X X X
Inspect the brake linings. X
Change the front and rear axle fluid. X
Inspect and replace, if necessary, theengine air
cleaner filter.X
Replace theignition cables.X
Replace thespark plugs.X
Inspect and replace the Auto Tension Drive Belt as
needed.X
Lubricate the front and rear suspension ball joints. X
Inspect and replace, if necessary, thePCV orifice.*X
Flush and replace the engine coolant at 60 months,
if not done at 102,000 miles.X
SCHEDULE “A” 237
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Fueling............................... 152
Fuses................................ 203
GasCap .............................. 152
Gasoline.............................. 148
Gasoline, Clean Air...................... 149
Gasoline, Reformulated................... 149
Gasoline/Oxygenate Blends................ 149
Gauges................................ 96
Coolant Temperature..................94,96
Fuel................................ 97
Oil Pressure........................... 96
Speedometer.......................... 90
Tachometer........................... 96
Voltmeter............................ 97
General Information...................... 19
Glass Cleaning.......................... 201
Ground Clearance....................... 148Hazard Warning Flasher.................91,156
Headlights............................ 214
Aiming............................. 219
High Beam........................... 80
High Beam/Low Beam Select Switch......... 80
Passing.............................. 80
Switch............................... 78
Time Delay........................... 79
Heater................................ 111
High Beam Indicator...................... 93
Hood Latch Maintenance.................. 188
Hood Release........................... 73
Hoses.............................195,196
Hydraulic Clutch Fluid.................... 198
Ignition
Key ................................. 12
Timing.............................. 178
Wiring System........................ 178
INDEX 255
10

Warranty Information..................... 245
Washer, Adding Fluid..................... 189
Washers, Windshield...................84,189
Wheel Alignment and Balance............... 145
Wheel Bearings......................... 200
Wind Buffeting.......................... 29
Windows.............................. 27
Power............................... 27
Windshield Defroster...................... 53
Windshield Washers....................84,189
Windshield Wipers....................... 84
Wipers, Intermittent....................... 85
Wiring, Ignition......................... 178
INDEX 263
10