garage door opener DODGE VIPER 2015 VX / 3.G Owners Manual

▫High/Low Beam Switch................106
▫Flash-To-Pass........................106
▫Interior Lights.......................106
!WINDSHIELD WIPERS AND WASHERS......108
▫Intermittent Wiper System...............108
▫Wiper Operation......................109
▫Mist Feature.........................109
▫Windshield Washers...................110
▫Headlights On With Wipers (Available With
Automatic Headlights Only).............111
!TILT STEERING COLUMN................111
!ADJUSTABLE PEDALS..................112
▫Adjustable Foot Rest...................114
!ELECTRONIC SPEED CONTROL...........114
▫To Activate..........................115
▫To Set A Desired Speed.................116
▫To Deactivate.........................116
▫To Resume Speed......................116
▫To Vary The Speed Setting...............116
▫To Accelerate For Passing................118
!PARKVIEW® REAR BACK UP CAMERA — IF
EQUIPPED...........................118
!GARAGE DOOR OPENER — IF EQUIPPED . . .120
▫Before You Begin Programming HomeLink® . .121
▫Programming A Rolling Code.............122
▫Programming A Non-Rolling Code.........124
88 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!
Drivers must be careful when backing up even when
using the ParkView® Rear Back Up Camera. Always
check carefully behind your vehicle, and be sure to
check for pedestrians, animals, other vehicles, ob-
structions, or blind spots before backing up. You are
responsible for the safety of your surroundings and
must continue to pay attention while backing up.
Failure to do so can result in serious injury or death.
CAUTION!
•To avoid vehicle damage, ParkView® should only
be used as a parking aid. The ParkView® camera is
unable to view every obstacle or object in your
drive path.
(Continued)
CAUTION!(Continued)
•To avoid vehicle damage, the vehicle must be
driven slowly when using ParkView® to be able to
stop in time when an obstacle is seen. It is recom-
mended that the driver look frequently over his/her
shoulder when using ParkView®.
NOTE:If snow, ice, mud, or any foreign substance builds
up on the camera lens, clean the lens, rinse with water,
and dry with a soft cloth. Do not cover the lens.
GARAGE DOOR OPENER — IF EQUIPPED
HomeLink® replaces up to three hand-held transmitters
that operate devices such as garage door openers, motor-
ized gates, lighting or home security systems. The
HomeLink® unit is powered by your vehicles 12 Volt
battery.
120 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

NOTE:
•Erasing all channels should only be performed when
programming HomeLink® for the first time. Do not
erase channels when programming additional buttons.
•If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
Programming A Rolling Code
For programming garage door openers that were manu-
factured after 1995. These garage door openers can be
identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is attached to the garage door
opener. It is NOT the button that is normally used to
open and close the door. The name and color of the
button may vary by manufacturer.1. Place the ignition in the ON/RUN position.
Training The Garage Door Opener
1—DoorOpener2 — Training Button
122 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

2. Place the hand-held transmitter 1 to 3 inches (3 to 8
cm) away from the HomeLink® button you wish to
program while keeping the HomeLink® indicator
light in view.
3. Push and hold the HomeLink® button you want to
program while you push and hold the hand-held
transmitter button.
4. Continue to hold both buttons and observe the indi-
cator light. The HomeLink® indicator will flash slowly
and then rapidly after HomeLink® has received the
frequency signal from the hand-held transmitter. Re-
lease both buttons after the indicator light changes
from slow to rapid.
5. At the garage door opener motor (in the garage),
locate the “LEARN” or “TRAINING” button. This can
usually be found where the hanging antenna wire is
attached to the garage door opener/device motor.
Firmly push and release the “LEARN” or “TRAIN-
ING” button. On some garage door openers/devices
there may be a light that blinks when the garage door
opener/device is in the LEARN/TRAIN mode.
NOTE:You have 30 seconds in which to initiate the next
step after the LEARN button has been pushed.
6. Return to the vehicle and push the programmed
HomeLink® button twice (holding the button for two
seconds each time). If the garage door opener/device
activates, programming is complete.
NOTE:If the garage door opener/device does not acti-
vate, push the button a third time (for two seconds) to
complete the training.
To program the remaining two HomeLink® buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 123

Reprogramming A Single HomeLink® Button
(Rolling Code)
To reprogram a channel that has been previously trained,
follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink® button until
the indicator light begins to flash after 20 seconds.Do
not release the button.
3.Without releasing the buttonproceed with “Program-
ming A Rolling Code” step 2 and follow all remaining
steps.
Programming A Non-Rolling Code
For programming Garage Door Openers manufactured
before 1995.
1. Cycle the ignition to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8
cm) away from the HomeLink® button you would like
to program while keeping the HomeLink® indicator
light in view.
3. Simultaneously push and hold both the HomeLink®
button you want to program and the hand-held trans-
mitter button.
4. Continue to hold both buttons and observe the indi-
cator light. HomeLink® indicator will flash slowly
and then rapidly after HomeLink® has received the
frequency signal from the hand-held transmitter. Re-
lease both buttons after the indicator light changes
from slow to rapid.
5. Push and hold the programmed HomeLink® button
and observe the indicator light.
•If the indicator light stays on constantly, program-
ming is complete and the garage door/device should
activate when the HomeLink® button is pressed.
124 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

2. Place the hand-held transmitter 1 to 3 inches (3 to 8
cm) away from the HomeLink® button you wish to
program while keeping the HomeLink® indicator
light in view.
3. Continue to push and hold the HomeLink® button,
while you press and release (“cycle”) your hand-held
transmitter every two seconds until HomeLink® has
successfully accepted the frequency signal. The indi-
cator light will flash slowly and then rapidly when
fully trained.
4. Watch for the HomeLink® indicator to change flash
rates. When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you are programming.
5. Push and hold the programmed HomeLink® button
and observe the indicator light.
NOTE:
•If the indicator light stays on constantly, program-
ming is complete and the garage door/device should
activate when the HomeLink® button is pushed.
•To program the two remaining HomeLink® buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
If you unplugged the garage door opener/device for
programming, plug it back in at this time.
Reprogramming A Single HomeLink® Button
(Canadian/Gate Operator)
To reprogram a channel that has been previously trained,
follow these steps:
1. Cycle the ignition to the ON/RUN position.
126 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

2. Push and hold the desired HomeLink® button until
the indicator light begins to flash after 20 seconds.Do
not release the button.
3.Without releasing the buttonproceed with
“Canadian/Gate Operator Programming” step 2 and
follow all remaining steps.
Using HomeLink®
To operate, push and release the programmed
HomeLink® button. Activation will now occur for the
programmed device (i.e., garage door opener, gate opera-
tor, security system, entry door lock, home/office light-
ing, etc.,). The hand-held transmitter of the device may
also be used at any time.
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, push and hold the two outside buttons for 20
seconds until the red indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
The HomeLink® Universal Transceiver is disabled when
the Vehicle Security Alarm is active.
Troubleshooting Tips
If you are having trouble programming HomeLink®,
here are some of the most common solutions:
•Replace the battery in the original hand-held transmit-
ter.
•Push the LEARN button on the Garage Door Opener
to complete the training for a Rolling Code.
•Did you unplug the device for programming and
remember to plug it back in?
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 127

If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
WARNING!
•Vehicle exhaust contains carbon monoxide, a dan-
gerous gas. Do not run your vehicle in the garage
while programming the transceiver. Exhaust gas
can cause serious injury or death.
(Continued)
WARNING!(Continued)
•Your motorized door or gate will open and close
while you are programming the universal trans-
ceiver. Do not program the transceiver if people,
pets or other objects are in the path of the door or
gate. Only use this transceiver with a garage door
opener that has a “stop and reverse” feature as
required by Federal safety standards. This includes
most garage door opener models manufactured
after 1982. Do not use a garage door opener without
these safety features. Call toll-free 1-800-355-3515
or, on the Internet at HomeLink.com for safety
information or assistance.
128 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Corrosion Protection.......................336
Cruise Light.............................152
Cupholders.............................134
Customer Assistance.......................371
Data Recorder, Event.......................69
Daytime Brightness, Interior Lights.............108
Daytime Running Lights....................104
Dealer Service............................314
Defroster, Rear Window.....................138
Defroster, Windshield.......................84
Delay (Intermittent) Wipers..................108
Diagnostic System, Onboard.................312
Dimmer Switch, Headlight...................106
Dipsticks
Power Steering.........................236
Disposal
Antifreeze (Engine Coolant)................330
Door Locks..............................24
Key Fob Emergency Key...................22
Door Locks, Automatic......................26
Door Opener, Garage.......................120
Doors..................................24
Driving
Through Flowing, Rising, Or Shallow Standing
Water................................233
Electrical Outlet, Auxiliary (Power Outlet)........129
Electric Remote Mirrors......................92
Electronic Brake Control System...............241
Traction Control System...................243
Electronic Speed Control (Cruise Control)........114
Electronic Stability Control (ESC)..............244
Emergency Brake.........................237
Emergency, In Case Of
Freeing Vehicle When Stuck................307
Hazard Warning Flasher..................290
Jump Starting..........................303
10
INDEX 383

Fluid Capacities..........................357
Fluid Leaks..............................85
Fluid Level Checks
Brake................................333
Capacities............................357
Clutch Fluid...........................335
Cooling System.........................327
Engine Oil............................315
Manual Transmission....................335
Power Steering.........................236
Fluids, Lubricants And Genuine Parts...........358
Four-Way Hazard Flasher...................290
Freeing A Stuck Vehicle.....................307
Fuel...................................277
Additives.............................280
Clean Air.............................278
Ethanol..............................278
Filler Door (Gas Cap)....................149
Gasoline..............................277
Gauge...............................149
Materials Added........................280
Methanol.............................278
Octane Rating..........................277
Requirements..........................277
Tank Capacity..........................357
Fuses..................................342
Garage Door Opener (HomeLink®)............120
Gasoline, Clean Air........................278
Gasoline (Fuel)...........................277
Gasoline, Reformulated.....................278
Gauges
Fuel.................................149
Speedometer..........................144
Tachometer............................148
General Information.......................196
Glass Cleaning...........................339
10
INDEX 385